重心位置 的英文怎麼說

中文拼音 [zhòngxīnwèizhì]
重心位置 英文
center-of-gravity location
  • 重 : 重Ⅰ名詞（重量; 分量） weight Ⅱ動詞（重視） lay [place put] stress on; place value upon; attach im...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 重心 : 1 （事情的中心或主要部分） heart; core; focus; key point 2 [物理學] centre of gravity; barycentre...
  1. Studied on floating avoiding method and the memory conflict regulating method to realize the real - time image capture. 2. using four subpixel - locating methods to obtain the center of micro parts, which are template - matching method, core - shape method, centrobaric gray method, and edge - fitting method

    利用模板匹配法、型心法、灰度重心法和邊緣擬合法等四種亞像素定位方法實現了對零件中心位置的檢測；利用圖像旋轉方法，進行了零件旋轉角度定位研究。
  2. That in turn gave way to victorian prudery, together with a determined focus on the need for manliness in marriage

    隨后而來的維多利亞時期，雖然表面內斂拘謹，但是在婚姻中，陽剛氣質仍佔有牢固的重心位置。
  3. According to the moving characteristics of tracklayer, when the vehicle is on ramp and the ground ' s vertical pressure is linear, the calculating formulas of relationship between the deviation of the instantaneous steering center, the position of vehicle ' s gravity, steering radius, moving velocity, moving acceleration, and vehicle ' s orientation, were obtained by the theory and method of vector analysis in mathematics and mechanics

    摘要根據履帶式車輛的運動特點，運用數力學中矢量分析理論和方法，推導了接地比壓為線性分佈時履帶式車輛在斜坡上轉向時，瞬時轉向中心偏移量與車輛重心位置、轉向半徑、行進速度、加速度、車輛方位相互關系的計算公式。
  4. The study gets the following conclusions : 1 ) inverted nine - spot pattern water flooding is used in the early stage of the development, while linear water flooding is used in the later stage ; 2 ) well array is parallel to the fracture trend ; 3 ) the well arrangement of barycentric position method is a suitable pattern adjustment method in the later period of the development in low permeable oil fields

    研究認為，一是油田開發初期注采方式採用反九點法面積注水，開發後期調整為線狀注水方式；二是井排方向與裂縫走向平行；三是「重心位置」布井方式對低滲透油田開發後期是較為適合的井網調整方式。
  5. Effect of center - of - gravity position on aircraft drag and flight performance

    重心位置對飛機阻力及其飛行性能的影響
  6. By changing position research of airship ' s center of gravity to control longitudinal motion

    改變飛艇重心位置控制縱向運動
  7. Measurement of the center of gravity in plumb direction for a self - propellant gun

    自行火炮鉛垂方向重心位置測量
  8. For any c. g. position, an increase in trim speed from any initial value to a larger one requires a downward deflection of the elevator.

    對于任意一個重心位置，平衡速度由它的初始值變化到較大的值時要求升降舵向下偏轉。
  9. Earth - moving machinery - method for locating the centre of gravity

    測定重心位置的方法
  10. Earth - moving machinery. methods for locating the centre of gravity

    土方機械.重心位置測定方法
  11. Road vehicles with two axles - determination of centre of gravity

    兩軸道路車輛重心位置的測定
  12. Earth - moving machinery method for locating the centre of gravity

    土方機械測定重心位置的方法
  13. Motorcycles - measurement method for location of centre of gravity

    摩托車.重心位置的測量方法
  14. Mopeds - measurement methods for location of centre of gravity

    機動腳踏兩用車.重心位置的測量方法
  15. Two - wheeled vehicles - measurement method for location of centre of gravity

    兩輪機動車.重心位置的測量方法
  16. The influence analysis is achieved for maneuverability and stability of the coach - bus while the angel stiffness of it ' s lateral stable pole or the position of gravity center is changing

    並討論了橫向穩定桿角剛度變化、重心位置變化對大客車操縱穩定性的影響。
  17. Based on lots of drawings, authors analyze lightweight and center of gravity of small wooden fishing vessel of hard dine at yellow sea and bohai sea, and put forward formulas for calculating lightweight and center of gravity, which can be used as reference for design of small wooden fishing vessel of hard dine

    摘要在收集大量圖紙資料的基礎上，對黃、渤海區小型折線型木質漁船的空船質量及重心位置進行了統計分析，並提出了空船質量及重心位置的估算公式，供設計折線型木質漁船時參考。
  18. According to the principle of moment balance, the weight value and position of the center of gravity of the balances, the displacement value of the center of gravity of the freight loaded, and the amount of reducing the off - gauge grades are analysed and deduced

    通過在貨物外形輪廓關于中心線不對稱的3種方式下，依據力矩平衡原理進行分析、推導，確定出配重物的重量和重心位置、貨物裝載中心的位移值及降低貨物超限等級的程度。
  19. The vibration source identification was realized in this paper by analyzing and comparing the train ’ s and the bogie ’ s lateral acceleration. the proposed method can divide into four steps : first adopting the acceleration ’ s peak - peak value entropy comparison method, second peak - peak value cross correlation comparison method, third peak - peak value weight center position comparison method, and the last adopting peak - peak value max - value position comparison method, if still unidentified refuse it

    分為四個步驟:首先用加速度的峰峰值熵比較法進行判別，如果不行則用加速度峰峰值互相關比較法進行判別，如果不行則用加速度峰峰值重心位置比較法進行判別，仍然不行最後用加速度峰峰值最大值位置比較法進行判別，如果仍然不行則拒絕判別。
  20. Merge - merges selected vertices into a single one, at the barycenter position or at the cursor position

    合併-合併選擇的頂點為一個單點，這個合併的點在重心位置或光標位置。
分享友人
分享到 Line

分享到臉書