重拋球 的英文怎麼說

中文拼音 [zhòngpāoqiú]
重拋球 英文
ball re-droppint
  • : 重Ⅰ名詞(重量; 分量) weight Ⅱ動詞(重視) lay [place put] stress on; place value upon; attach im...
  • : 動詞1. (扔; 投擲) throw; toss; fling 2. (丟下; 拋棄) leave behind; cast aside; abandon
  • : 名詞1 (以半圓的直徑為軸 使半圓旋轉一周而成的立體; 由中心到表面各點距離都相等的立體) sphere; glo...
  • 拋球 : droball
  1. We've noted that this is just like a body projected horizontally in the earth's gravitational field.

    我們注意到,這個問題同在地力場中水平射一個體十分相象。
  2. These successful companies, whose supply chains currently span the globe, have spurned their remaining competitiors to consider global sourcing as an important procurement strategy

    這些供給鏈目前橫跨全的成功的公司已將其餘的競爭對手在身後,考慮將全的資源作為一項要的采購策略。
  3. S had been flung into the sea, and was dragged into its depths by a thirty - six pound shot tied to his feet

    唐太斯被進了海里,他的腳上綁著一個三十六磅的鐵,正把他拖向海底深處。
  4. Solar wind flows out from the corona the sun s outer atmosphere into interplanetary space at speed of between 300 and 900 km per second. it causes fluctuation to the earth s magnetic field, which we call magnetic storm. such event will cause deflection of compass needles

    而太陽風則以每秒300至900千米的速度由日冕太陽外大氣層向外射,進入行星際空間,對地磁場造成擾動而產生磁暴,導致指南針指針偏移,嚴的話更會導致電力受阻和電話線路中斷。
  5. They never buried the dead ; they merely attached a heavy cannon - ball to the feet, and then threw them into the sea

    他們從不埋葬死人,只是給死人腳上綁上一顆很的鐵,然後把它到海里。
  6. This is significant because of the unique geometrical features of the arecibo telescope : whereas most radio dishes are parabolic in shape, the arecibo dish is a giant half - sphere dug into the ground

    這非常要,由於阿雷西博望遠鏡的獨特幾何結構:盡管絕大多數的射電望遠碟面都是物面型的,而阿雷西博的碟面是在地上挖出的一個巨大半
  7. The general measure method of aspheric optics is done after fine polishing. when the error between actual surface and theoretic surface is big, we must grinding the optics again, then polishing, measuring. . it ' s too complex ! if we had a measuring instrument which could measure the surface of aspheric optics after fine grinding, the procedure of processing aspheric optics would be simplified and the cost would be reduced

    常規的非面光學元件檢測是在元件光后進行的,通過與之對應的補償儀檢測其面形質量,當實際面形與理論面形有較大誤差時,就必須把已經光的元件新精磨,再進行光、檢測,其加工工序是相當繁復的。
分享友人