重熱器 的英文怎麼說

中文拼音 [zhòngrèqì]
重熱器 英文
reheator
  • 重 : 重Ⅰ名詞（重量; 分量） weight Ⅱ動詞（重視） lay [place put] stress on; place value upon; attach im...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  1. In model zw. the indirect heating still is omitted. the condensor adapts calandria heat exchanger. of course the screw plate heat exchange and coil pipe cooler can also be provided as request. when adapt coil pipe cooler, the buffer tank

    冷凝器採用列管式換熱器，也可根據用戶要求供應螺旋板式換熱器，冷卻器採用盤管式冷卻器，採用盤管式冷卻器並配套供應穩壓罐和比重測定器。
  2. Miniature evaporator is a compact exchanger with small volume, light weight, and big heat transfer area per unit of volume. it is an important application in the field of cryogenics and refrigeration

    微型蒸發器是一種體積小、重量輕、單位體積換熱面積大的緊湊式換熱器，在製冷低溫技術領域中有著重要應用。
  3. The filament drive included a trailing weight and a preheater.

    長絲體的傳動部分包括一個拖拉重錘和一個預熱器。
  4. The calculation and design procedures of air conditioning load, ground loop heat exchangers, radiant floor system, distribution system between heat pump and build are mainly introduced

    重點介紹了建築空調負荷計算、地下埋管換熱器系統、輻射地板系統以及熱泵和建築物內分配系統設計等方面的內容。
  5. In the part of detector, it mainly introduces the design of liquor tubes, heater, pressurize, and thermocouple ; in the part of controller, this design uses tms320lf2407 as the cpu. the design part mainly introduces controller circuit design which mainly contains data collection circuit, prepositive magnifying circuit, a / d convert circuit, failure self - diagnosis circuit, the tms320lf2407 interface circuit, temperature control circuit, display circuit, 4 ~ 20ma standard signal output circuit ; in the software part, it mainly introduces software chart of main program and partly linearization subprogram design

    檢測器部分重點介紹了導流管的設計、加熱器的設計、密封技術的設計以及測溫電路的設計;控制器部分以tms320lf2407為核心，重點介紹了控制器電路設計，主要包括數據選擇電路、前置放大電路、 a / d轉換電路、故障自診斷電路、 tms320lf2407介面電路、控溫電路、顯示電路、 4 20ma標準信號輸出電路共八個部分;軟體設計重點介紹了主程序軟體設計及分段線性化子程序設計。
  6. The energy will be given out wherever the two electricities can reunite through a lamp, or a motor, or a heater etc.

    而兩種電在任何可以重聚的地方，如通過電燈、馬達或加熱器等等，就會釋放能量。
  7. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。
  8. We can see than this kind of cpu thermal syphon cooling machine is the one with simple texture, easy working, low costs, reliable work and good performance

    由此可知此種cpu重力熱管散熱器是一種結構簡單、加工製造方便、成本低廉、工作可靠且傳熱性能優良的換熱設備。
  9. On the basis of the manufactured new aluminium heat pipe sets and research work done in the refrigeration lab of chongqing university, a new thermal syphon cooling machine made of aluminium has been designed. this text is to study this kind of thermal syphon to use working fluid methanol, ethanol and acetone

    在重慶大學製冷實驗室已有研究工作及新型的鋁質cpu重力熱管散熱器基礎上，本文著重研究此種重力熱管使用天然工質甲醇、乙醇和丙酮時的工作特性。
  10. But when the wind - speed becomes above 1m / s hereafter, wind - speed increase for the cpu thermal siphon of transmit heat the ability ' s gain result the deceleration. so it is considered perfect when the wind - speed is 1m / s. through this experimentation we found that when the cpu thermal syphon cooling machine used acetone as working fluid, wind - speed 1m / s, cpu chip caloricty 60w, its volumetric heat release rate came to 1. 3 104w / ( m3k )

    通過本次實驗測出所使用的cpu重力熱管散熱器在使用丙酮為工質，風速1m / s ， cpu晶元發熱量為60w時，其體積散熱率達到1 . 3 104w / （ m3k ） ，能保證晶元溫度與環境溫度之差小於40 ，能很好的適應pentium -計算機長期運行的要求。
  11. Due to the features of board heat - exchange euipment ' s simple structure, easy unpicked and washed and high heat - transfer coeffcient, it is used extensively in heating system

    由於板式換熱器結構簡單、便於拆洗、最重要在於它傳熱系數高等特點，使得它在供熱系統中得到了越來越廣泛的應用。
  12. Analysis of experimental data indicates that there exist several following problems during the whole operation : first, the emission is serious and the density of hc and co smoke is very high at on and off period. second, there is oil dripping from the dripping vitta as a result of the fault of ignition system and combustion structure. the last, there might be accidents of disabled ignition resulted from the improper operation at the beginning

    通過對樣機的試驗分析和研究表明，汽車空氣燃油加熱器在整個工作過程中，其排放存在以下三個問題：一、開機和關機兩個階段的排放問題嚴重，廢氣中hc和co的濃度值及煙度測量值都很高；二、因點火系統和燃燒結構的缺陷而導致開機后一段時間內有油滴從滴油管滴落；三、在點火過程中，會出現因操作不當而點火失效的現象。
  13. Make the u type and w type heating tube to be series - wound and shunt - wound to meet the rated voltage reauest. the fixed housing is made adopting the stainless steel or high quality hot zincification board to resist high temperature and corrosive. matching the heat fuse and temperature controller to protect doubly the heating pipe of the air conditioner and keep safe. adopting the silicone rubber high temperature wire and imported connecting terminal to make the electric connection more fixed and reliable

    以達到額定功率的要求固定支架選用不銹鋼或優質鍍鋅板製作而成，耐溫防腐配用熱熔斷器和溫度控制器，對空調加熱管起著雙重熱保護作用，安全性能更好採用硅橡膠耐高溫線和進口接線插端，使產品電氣聯接緊固可靠。
  14. Under the precondition that the radiator has enough cooling efficiency and intension, it is the necessary trend that the volume is less, the weight is lighter, the tube wall and belt materials are thinner, and the cooling efficiency is higher

    在保證散熱器具有足夠散熱能力和強度的前提下，體積更小、重量更輕、管壁及帶材更簿、散熱效率更高成了散熱器發展的必然趨勢。
  15. Avoiding the difficulties of detecting the difficult parameters in furnace control and of building up the models, integrated with fuzzy control and conventional pid control, abb ’ s control it system is used to predict the bloom surface and center temperature directly based on the temperature of furnace wall easily to be detected so that the temperature settings in various furnace sections can be self - corrected, the furnace temperature of each section self - adjusted and on - line parameters of combustion control self - optimized. in addition, the heating parameters and the operating status of the field plant can be monitored with alarm

    採用abb公司的controlit控制系統，避開爐子控制中遇到的困難參數檢測及建模困難等因素，直接根據容易檢測的爐壁溫度來推知鋼坯表面溫度及鋼坯中心溫度，將模糊控制技術與常規pid控制相結合，實現各段溫爐設定值自修正、各段爐溫自協調、各參數在線自整定的自尋優最佳燃燒控制;對熱工參數、現場設備的運行情況進行監視、報警，實現爐膛壓力、管道壓力、換熱器的保護控制，並將重要參數送往廠級mis網路。
  16. This paper made the process algorithm of condenser and closed - type heater which are two important equipment in power station. this paper also raised a design method of graphic modeling system

    本文建立了兩個重要的電廠熱力設備? ?凝汽器和面式加熱器的過程演算法；還提出了一個圖形建模系統的設計方案。
  17. 2. design scheme of gravity heat pipe air pre - heater is proposed which fits the actual situation of injecting steam boilers. detailed heat calculation and design on heat recovery of flue gas is carrying out

    提出了採用適合於注汽爐實際工況的重力熱管式空氣預熱器的設計方案，對煙氣的余熱回收進行了詳細的熱力計算和設計。
  18. The result of the analysis has significant implications for the analysis of real heat exchange processes of heat exchangers in the refrigerator

    所得結果對研究混合工質製冷機中各換熱器的實際換熱過程有重要指導意義。
  19. Understand maintenance procedure of compressor, pump, blower, turbine, tower and heat exchanger etc, and prepare lifting plan accordingly and direct big scale equipment

    了解壓縮機、泵、風機、汽輪機、塔、換熱器檢維修工作程序，根據檢修要求制訂起重吊裝方案並能夠指揮吊裝大型設備。
  20. The economic success of jiangmen huoli group co., ltd. is coined / shaped by products and service services such as boiler, heater, heater in addition to heater, homepage and water heater. one can even receive offers on boiler, stove, smoke and boiler as well as on gas water heater with jiangmen huoli group co., ltd. in outstanding quality

    不僅在以主頁、鍋爐、汽鍋、蒸餾鍋、釜、水槽、容器和加熱體以及重沸器、加熱氣和加熱器領域內著稱，而且以其它產品馳名，如地坑、爐床、煙、煙氣和水加熱器、氣水供熱裝置以及發熱器。
分享友人
分享到 Line

分享到臉書