金屬處理學會 的英文怎麼說
中文拼音 [jīnzhǔchǔlǐxuékuài]
金屬處理學會
英文
metal treating institute- 金 : Ⅰ名詞1 (金屬) metals 2 (錢) money 3 (古時金屬制的打擊樂器) ancient metal percussion instrum...
- 屬 : 屬名詞1 (類別) category 2 [生物學] (生物分類系統上所用的等級之一) genus 3 (家屬; 親屬) fami...
- 處 : 處名詞1 (地方) place 2 (方面; 某一點) part; point 3 (機關或機關里一個部門) department; offi...
- 理 : Ⅰ名詞1 (物質組織的條紋) texture; grain (in wood skin etc ) 2 (道理;事理) reason; logic; tru...
- 學 : Ⅰ動詞1 (學習) study; learn 2 (模仿) imitate; mimic Ⅱ名詞1 (學問) learning; knowledge 2 (學...
- 會 : 會構詞成分
- 金屬 : metal
-
In the work, it was systemically studied that the effects of two suggested modifying ways on electrochemical characteristics of lithium metal electrode and its behaviors in lithium cell. finally, the action mechanisms of these two modifying ways were analyzed. through the study on pretreatment effects of different cyclic ether on lithium electrode, it was found that 1, 4 - dioxane ( doa ) and 1, 3 - dioxolane ( dol ), both could form a favorable passivating sei film on lithium electrode surface through
研究不同環醚對鋰電極的預處理作用發現, 1 , 4 -二氧六環( doa )和1 , 3 -二氧五環( dol )對金屬鋰電極的表面預處理均可以在金屬鋰表面形成一層良好的sei鈍化膜,對鋰金屬電極起到了保護性作用,使鋰電極具有較小的界面阻抗,有效地提高了金屬鋰電極的充放電循環效率,改善了鋰金屬電極在循環過程中的表面形貌;而doa和dol對金屬鋰電極的表面預處理,不會明顯的影響鋰電極的動力學性能。Author thinks that the direction of the maximum plastic distortion along a constant radius around the crack tip may be considered as the direction of shear - mode fracture ( named pmax - criterion ) and the load when located shear band prongs the ligament in the front of crack tip is regarded as the limited load of shear - mode fracture. ( 3 ) the fad ( fracture assessment diagram ) of titled crack is proposed based on achievements of mesomechanics about i - ii complex ductile fracture of metal, and the titled crack is classified two kinds : void - mode fracture is assessed by fracture assessment curve, and shear - mode fracture by limited load. ( 4 ) using a fe program based on plantle - ressue theory to calculate some mesomechanical parameters, a flange joint structure of a high pressure vessel ( design pressure 31. 4mpa and the thickness of the hemispherical head is half of that of shell. ) is analyzed to determine whether the structure under operation pressure is safe or not, forecast the mode of potential invalidation and argue for the rationality of design of the structure
試件的整體斷裂為剪切型,但在試件芯部裂尖鈍化區中部出現了韌窩型啟裂並有一定的擴展,說明局部較高的應力三軸度也會使韌窩型機制得以發展,但是不改變試件整體的剪切型斷裂模式;對韌性斷裂的剪切模式的細觀機理做了一定的探討,並且提出了含裂紋構件剪切型斷裂的宏觀判據:認為裂紋前方的集中剪切帶中與裂紋尖端等半徑處最大有效塑性應變出現的方向可以作為裂紋剪切斷裂的方向(可簡稱為_ ( pmax )準則) ,集中剪切滑移帶貫穿裂紋前方承載韌帶時的載荷可以作為極限載荷;本文運用金屬韌性斷裂細觀力學在一復合型韌性斷裂方面的研究成果,採用失效評定圖的形式,提出了傾斜裂紋的安全性評定方法的基本框架。Llw is compressed into steel drums, sealed and stored temporarily at the nuclear power station and eventually be transported to the repository for disposal. intermediate - level waste ( ilw ) consists of radioactive resin and chemical sludge, spent filter cartridges etc. collected from waste treatment process and maintenance work
低放射性廢物會被壓縮及裝入金屬罐內,加以密封。中放射性廢物包括在廢氣及廢液處理過程或維修工作中,所收集的帶輻射的樹脂和化學沉澱物、過濾器等。
分享友人