金屬電極 的英文怎麼說

中文拼音 [jīnzhǔdiànjí]
金屬電極 英文
metal electrode
  • 金 : Ⅰ名詞1 （金屬） metals 2 （錢） money 3 （古時金屬制的打擊樂器） ancient metal percussion instrum...
  • 屬 : 屬名詞1 （類別） category 2 [生物學] （生物分類系統上所用的等級之一） genus 3 （家屬; 親屬） fami...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 金屬 : metal
  • 電極 : electrode; pole
  1. Welding consumables - determination of moisture resistance of manual metal arc welding electrodes by measurement of diffusible hydrogen iso 14372 : 2000 ; german version en iso 14372 : 2002

    焊料.通過測量可擴散氫測定手工金屬電弧焊電極的抗濕
  2. In the work, it was systemically studied that the effects of two suggested modifying ways on electrochemical characteristics of lithium metal electrode and its behaviors in lithium cell. finally, the action mechanisms of these two modifying ways were analyzed. through the study on pretreatment effects of different cyclic ether on lithium electrode, it was found that 1, 4 - dioxane ( doa ) and 1, 3 - dioxolane ( dol ), both could form a favorable passivating sei film on lithium electrode surface through

    研究不同環醚對鋰電極的預處理作用發現， 1 ， 4 -二氧六環（ doa ）和1 ， 3 -二氧五環（ dol ）對金屬鋰電極的表面預處理均可以在金屬鋰表面形成一層良好的sei鈍化膜，對鋰金屬電極起到了保護性作用，使鋰電極具有較小的界面阻抗，有效地提高了金屬鋰電極的充放電循環效率，改善了鋰金屬電極在循環過程中的表面形貌;而doa和dol對金屬鋰電極的表面預處理，不會明顯的影響鋰電極的動力學性能。
  3. Corresponding relationship between electrode potential and fermi level

    金屬電極電位與費米能級的對應關系
  4. Baoji anode new material co., ltd is mainly engaged in the metal anode, the active negative pole, the metal anode electric tank, the special metal coating processing and the production, and metal anticorrosion technology consultation and technical service

    該公司主要從事金屬陽極、活性陰極、金屬陽極電解槽、特種金屬塗層的加工和生產，以及金屬防腐技術的咨詢與技術服務。
  5. Because the cross - section of the oversized rib waveguide we fabricated by wet - etching was trapeziform, we analyzed the transmission of oversized rib waveguide by combining effective refractive - index method. the influence of some factors on the optical transmission loss, such as material structure, the height of rib waveguide, and the thickness and refractive index of waveguide layer and up - layer of polymer material, was analyzed

    因為濕法腐蝕工藝製作的反脊波導橫截面是梯形狀的，因此論文中採用了一種簡單有效的方法，即有效折射率法，對梯形反脊波導的光傳輸損耗特性進行了分析，同時考慮金屬電極產生熱場對脊波導傳播特性的影響。
  6. Abstract : the character of electrode material is an important factor affecting and limiting the structure and property of batteries. thereby, the main types and their features, fundamental properties, and preparation methods of the porous substrate materials for battery electrodes was simply introduced, so as to supply the clues for improving the technologies of producing these materials, and to strengthen the necessity of studying their properties and the property relationships

    文摘:簡要介紹了電池用多孔金屬電極基體材料的主要類型及其特點、基本性能要求和制備方法，旨在提供改善該材料制備工藝的線索和強化其性能及性能關系研究的必要。
  7. Metallic electrode arc lamp

    金屬電極弧光燈
  8. Insulation layer and the materials of the nano - electrode play important roles in the electrical property of the nano electronic device

    絕緣層厚度以及金屬電極選材等因素對器件性能有關鍵的影響。
  9. It is found that the height of the metal electrode, the distance between the source and drain electrodes, the thickness of the sio

    研究了場效應納電子晶體管構造過程中金屬電極的結構設計，源-漏電極高度sio
  10. Welding consumables - wire electrodes, wires, rods and deposits for gas shielded metal arc welding of high strength steels - classification

    焊接消耗品.高強度鋼氣體保護金屬弧焊鍍層和焊條，金屬絲，金屬電極.分類
  11. Aiming to the above goals, two original modifying ways of lithium electrode were suggested to make lithium electrode have a more stable sei film

    針對以上目標，提出兩種全新的鋰電極改性方法，以使鋰金屬電極表面具有更加穩定的sei膜。
  12. Once the sapphire was covered with nanotubes, they could place the metal electrodes of the transistors wherever they wanted and remove the unwanted nanotubes with highly ionized oxygen gas

    藍寶石上覆蓋奈米管后，就可在任意的位置安裝電晶體的金屬電極，再以高度離子化的氧氣除去不需要的奈米管。
  13. Important information is that the distance between metal electrode and emitting layer must be suitable. too large, difficult injection ; too small, excitons quenching. within 0 - 70ma / cm2 injection, no effect was observed

    實驗給出影響受激發射的重要信息：金屬電極距增益區距離要適當，太大，器件厚，電注入困難；太小發光激子在電極猝滅。
  14. The intention of the paper is to study the deposition and properties of znte ( znte : cu ) polycrystalline thin films and to apply znte ( znte : cu ) as a complex back contact layer between cdte and metal electrode to obtain ohm contact and high efficiency cdte solar cells

    本論文目的在於研究znte （ znte ： cu ）多晶薄膜的制備和性質，並把znte znte ： cu多晶薄膜作為復合背接觸層應用於cdte和背金屬電極之間以獲得歐姆接觸和高效cdte太陽電池。
  15. Zno varistors have been widely used in electronic and electrical power devices and systems because of excellent nonlinear v - i characteristics and high absorbance of electric current surges. with the smt ( surface mounted technology ) development, traditional zno varistors can not meet the multilayer thin films lamination structure nappe varistor ceramics and metal electrode low temperature co - fire need. however, the best character of zno - v2o5 varistor can sinter in common furnace during lower temperature ( 900 ), not only settling the problem relate to upon, but also saving energy sources

    Zno壓敏電阻因其優異的v ? i非線性和較高的浪涌吸收能力而廣泛應用在電子、電力設備系統上。然而，隨著表面貼裝技術（ smt ）的發展，傳統的zno壓敏陶瓷不能滿足多層膜獨石結構疊層壓敏電阻元件陶瓷與金屬電極低溫共燒的需要。而zno ? v2o5系壓敏陶瓷的最大優點是能用普通燒結爐在較低溫度（ 900 ）下燒結，不僅解決了以上問題，還大大節約了能源。
  16. In this modulator, coplanar strips ( cps ) are used as electrodes for they support balance mode propagation of microwave, and this is a desired merit for common optical modulator. due to the miniaturized dimensions, the metallization thickness is in the order of skin depth and the conductor losses are not negligible

    雖然由於金屬的趨膚效應，電場將集中在金屬表面，但在40g以上的頻率條件下，金屬的厚度和趨膚深度在一個量級，而且此時調制器帶寬受到限制的最大根源來源於金屬電極的微波損耗。
  17. The present studies have proved that the most important factor which influences the performances of lithium metal anode in battery is the solid electrolyte interphase interface - film ( sei film ) on lithium anode. and how to make lithium metal anode have a sei film with favorable composition and stable configuration, or make the sei film have better stability, is the key to improve the electrochemistry performances of lithium metal anode in lithium secondary battery

    已有的研究證明:影響金屬鋰負極在電池中性能的主要因素是其表面的固體電解質中間相界面膜（ sei膜）的性能;如何使鋰金屬電極表面具有組成良好、結構穩定的sei膜，或者使鋰電極表面sei膜能夠更好的「穩定化」 ，是提高鋰二次電池中鋰金屬負極電化學性能的關鍵。
  18. In a word, the two type of voa both have valuable applicability and potential market. the author have done numerous processing to work out new processing such as polymer coating and cure and triple - layer - metal film vaporing. other new processing, polymer ultra - violet ( uv ) cure and inductively - coupled plasma ( icp ) etching were studied

    作者經過反復的工藝實驗，確定了聚合物波導塗膜和固化、三層金屬電極蒸發和腐蝕等新工藝的參數，並得到了聚合物紫外固化、等離子體刻蝕等新工藝的初步數據。
  19. Up to date, it is still very hard to grow gan bulk crystals, so the heteroepitaxial growth of high quality gan thin films is the premise for the development of gan - based devices. at the same time, the rapid progress on devices requires better ohmic contact between metals and gan, so much more research work must be carried out at once

    由於gan體單晶難以制備，生長高質量的薄膜單晶材料是研究開發gan基器件的基本前提條件，同時器件的發展對電極的制備提出了更高的要求，因而研究金屬電極與gan的接觸成為必然。
  20. 21a / w, and a1so get some other significative resul t. mair1 works and resu1t inc1ude : ( l ) by ana1yzing the the working pril1ci p1es of gan - - based msm ph ( ) to - detectors, we designed the two ki11ds of di fferent structure parameter of device. the electrode fingers are 2 p m wide, and l00 ll nl long, the gap.

    本文的主要工作和結果有： （ 1 ）通過對gan的msm結構探測器的工作原理的分析，我們設計了兩種尺寸的器件結構參數，確定了器件的金屬電極條寬為2 m ，長為100 m ，電極間距分別為6 m 、 10 m兩種，器件有效面積分別為104 m 155 m 、 150 m 155 m 。
分享友人
分享到 Line

分享到臉書