金相熱室 的英文怎麼說

中文拼音 [jīnxiāngshì]
金相熱室 英文
metallographic hot cell
  • : Ⅰ名詞1 (金屬) metals 2 (錢) money 3 (古時金屬制的打擊樂器) ancient metal percussion instrum...
  • : 相Ⅰ名詞1 (相貌; 外貌) looks; appearance 2 (坐、立等的姿態) bearing; posture 3 [物理學] (相位...
  1. Detection : carbon - sulfur analyzer, oxygen analyzer, glazing machine, rockwell ( vickers ) hardometer, profile projector, surfagauge, scan electron microscope, laser conductometer, magna - check, universal measuring instrument, metallograph and image analysis system, abrasion tester, universal test machine and other advanced analysis and detection equipment and instruments

    檢測類:碳硫分析儀、氧分析儀、試驗用拋光機、洛(維)氏硬度計、輪廊投影儀、表面粗糙度測量儀、掃描電鏡、激光導儀、磁力探傷機、萬能測量儀、顯微鏡及圖像分析系統、磨損試驗機、萬能試驗機及其它的先進的分析檢測設備和儀器等產品類。
  2. There are the production lines established of intermediate - frequency melting, silicasol shuck, precision casting and metal ceramic, and 250 universal devices suck asvacuum melting electric furnaces, high - temperature and intermediate - temperature heat treatment electric furnaces, digitai - control lathes, milling and drilling machines, coreless millers, spherical surface millers, standing milling machines and so on, lt has established the central measuring roomm physicallab, chemical lab, metallic phase lab, crack detection test lab, seat ring lab, rocker lab and ducgt trestle lab, our esported gas engine valve seat to america was rewarded the second prize in terms of sichuan high - quality product

    建有中頻熔煉真空熔煉硅膠溶模精密鑄造粉末冶生產線。有中頻電爐真空熔練電爐高中溫處理電爐數控車床鉆銑床無芯磨外園磨立磨等通用設備250臺套。有中心計量物理化學探傷檢測及座圈搖臂導管臺架實驗
  3. To the south of dusseldorf lies schloss benrath, a magnificent pink and white summer palace where interior designers went rather overboard with flamboyant frescoes, ornate plasterwork and gold - leaf paint

    杜塞爾多夫城南聳立著本拉特皇宮,它是一座粉白間的宏偉的避暑宮殿。內設計師們狂地追求艷麗壁畫、精雕細琢的石膏造型和飾有葉的繪畫作品。
  4. In metal matrix composites, thermal residual stresses will arise due to get ( coefficient of thermal expansion ) mismatch between matrix and fiber during cooling

    在擠壓鑄造的屬基復合材料中,由於基體和纖維的膨脹系數差很大,所以在制備過程中由高溫(工藝溫度)冷卻至溫時復合材料中會有殘余應力產生。
  5. Cu - zn - cr - zr conducting bar alloy and cu - cr - zr end ring alloys used for superpower asynchronous traction motor rotor were prepared by ingot metallurgy. using hardness measurement, tensile test at room and higher temperature, electrical resistance test at room and higher temperature, optical microscopy, xrd, sem, and tem, the mechanical and electric properties and the microstructure of above alloys at different treatment were studied. them were also analysed and explained in theory

    採用鑄錠冶法制備了大功率異步牽引電動機轉子用導條合和端環合,通過硬度測試、溫拉伸、高溫拉伸、電導率測定、分析、 xrd 、 sem 、 tem等方法研究了不同加工工藝和處理工藝對上述合力學性能、導電性能及其組織結構的影響和變化規律,並從理論上進行了分析和解釋。
  6. Abstract : the causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    文摘:分析了陵石油化工公司煉油廠二套常減壓裝置加爐存在的因蒸汽吹灰器漏水,蒸汽引起露點腐蝕及吹灰效果差造成對流積灰,排煙溫度高,煙氣量未回收利用以及爐子保溫襯里效果差等問題,提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及應的流程調整等改造措施.測定結果表明,本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題,提高了保溫效果,減少散損失1 . 25 % ,排煙溫度降至170左右,裝置的爐效率由83 %左右提高到90 %以上
  7. The causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    分析了陵石油化工公司煉油廠二套常減壓裝置加爐存在的因蒸汽吹灰器漏水,蒸汽引起露點腐蝕及吹灰效果差造成對流積灰,排煙溫度高,煙氣量未回收利用以及爐子保溫襯里效果差等問題,提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及應的流程調整等改造措施.測定結果表明,本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題,提高了保溫效果,減少散損失1 . 25 % ,排煙溫度降至170左右,裝置的爐效率由83 %左右提高到90 %以上
  8. Simple organic molecules tend to be colorless with electronic transitions in the uv, whereas visible absorption, or color is usually associated with electronic in extended and conjugated structures. color is influenced considerably by the extent of conjugation, as well as by the molecular environment imparted by substituents. the reports on organic hydrate thermochronlic material are relatively fewer

    本文利用液溫/低反應合成出變色溫度較高的具有良好色性的雙席夫堿及其配合物;過渡屬離子具有d軌道,其配合物容易引起d - d躍遷或荷移躍遷,因而它們具有豐富的顏色。
  9. This layout can stop the internal arc fault expansion ; can avoid harmful moisture, small animal and dusty interferences. it also has good perfomiance and high reliability. because the heat cannot transmit to the outside of the bus room, a good operation environment for the low space can be obtained

    主母線置於箱體頂部一個單獨的屬封閉的間隔內,並與10kv開關、儀表等間隔互獨立,為同類產品首創;這種結構可以防止內部電弧故障的擴大化,避免「火燒聯營」事故;防護性能好,防潮、防小動物侵害、防積塵,運行可靠;由於母線的隔作用,為下層空間創造了一個較好的運行環境。
  10. The effects of the fabrication and heat - treatment methods on the microstructures and properties of the nb - si system intermetallics have been studied and the optimized nb - si intermetallic system as well as the optimized fabrication and processing procedures have been selected. the presence of alloying elements as well as the morphology and microstructure of the compound phases with these elements has been investigated. the effects of the alloying elements on the high - temperature oxidation behavior of the nb - si system intermetallics have also been studied

    本文研究了不同的制備工藝和處理制度對nb - si系屬間化合物顯微組織和性能的影響,優選了合適的材料體系、制備工藝和處理制度,分析了微合化元素及其形成的組織、結構、形態、存在形式等及其對材料高溫抗氧化行為的影響,提出了材料高溫抗氧化行為和溫斷裂行為的微觀機制,為研製nb - si系屬間化合物基高溫結構材料奠定了一定的基礎。
分享友人