金相腐蝕液 的英文怎麼說

中文拼音 [jīnxiāngfǔshíyè]
金相腐蝕液 英文
metallographic etchant
  • 金 : Ⅰ名詞1 （金屬） metals 2 （錢） money 3 （古時金屬制的打擊樂器） ancient metal percussion instrum...
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 腐 : Ⅰ名詞（豆腐） bean curdⅡ動詞（腐爛; 變壞） decay Ⅲ形容詞（腐爛） rotten; corroded; putrid
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 液 : 名詞（液體） liquid; fluid; juice
  • 金相 : metallographic金相分析 metallurgical analysis; 金相技術 metallographic technology; 金相檢驗 metal...
  • 腐蝕 : 1 （通過化學作用使物體逐漸消損破壞） corrode; corrosion; corroding; deep etch; diabrosis; rot; ea...
  1. The formation of 3. 5 % nacl solution is almost similar to that of 3. 5 % nacl thin electrolyte layer, just the mass transfer rate of the oxygen in the layer is more quicker than in the solution ? the test shows that the crack growth rate of wet - corrosion fatigue of lc4cs aluminum alloy in the layer is quicker than in the solution, and also shows that morphology of fatigue fracture in the layer is evidently distinguished from in the solution

    3 . 5 nacl溶液和3 . 5 nacl薄液層的化學組成幾乎完全相同，只是薄液層中氧的傳質速率較快。實驗結果顯示了在薄液層中， lc4cs鋁合金的濕腐蝕疲勞裂紋擴展速率，大於在3 . 5 nacl溶液中的速率。實驗還發現其疲勞斷口的形貌，也與3 . 5 nacl溶液中的有明顯區別。
  2. Abstract : iron - based alloy aluminum liquid maceration experiment is done. transmission ele ctron microscope ( tem ) and energy dispersive spectrometer ( eds ) are employed to in vestigate the characteristics of microstructure and the distrbution of compone nts. based on fe - al alloy phase diagram and the experiment results, a model is propo sed for iron - based alloy aluminum erosion

    文摘:進行了鐵基合金鋁液浸蝕實驗，利用透射電鏡和能譜儀對腐蝕試樣進行微觀組織觀察和成分分析，結合鐵鋁相圖和實驗結果.論述了鐵基合金鋁液腐蝕過程
  3. By means of chemical etching, microscope observation, eelectron probe x - ray micro - analyzer ( epma ), the micro - distribution of c acceptor defect in lec si - gaas wafer is investigated, the results show that there is serious influence of the density and distribution of dislocations on the distribution of c impurity in wafer

    本文通過ab腐蝕、 koh腐蝕，金相顯微鏡觀察，透射電鏡能譜分析，電子探針x射線微區分析，研究了液封直拉法生長的非摻半絕緣砷化鎵（ lec ， si - gaas ）單晶中碳的微區分佈。
  4. Electroplating on magnesium alloy can get a quite bright alloy - layer which has better antiseptic ability and conductive performance, the alloy - layer raises hardness, anti - corrosion and wearability of the surface of the magnesium alloy. the electroplating coating as the preconditioning can carry on regular shelter and decorating, so electroplating is a good method to obtain highly anti - corrosion metallic coating

    鎂合金表面電鍍是在液相中沉積出具有相當防腐能力和導電性能的光亮鍍層，這層均勻的鍍層提高了鎂合金表面的硬度、耐蝕和耐磨性，作為鎂合金件的預處理防護層，就可以進行常規的防護和裝飾，因此，電鍍是獲得耐蝕金屬塗層的好方法。
  5. In this paper, the ceramic coatings were prepared in situ on ti - 6al - 4v alloy by micro - plasma oxidation ( mpo ). the phase composition, microstructure and corrosion resistance of the ceramic coatings were studied in detail and the technology of corrosion resistant coatings was optimized. the dissolution of the substrate and the changes of the elements in the electrolyte during the mpo process were studied to discuss the growing characters and the structure of the ceramic coatings

    本文通過微等離子體氧化（ mpo ）方法在ti - 6al - 4v鈦合金表面原位生長陶瓷膜，系統地研究陶瓷膜的相組成、微觀結構及膜層耐腐蝕性能，並優化耐蝕性陶瓷膜層制備工藝;分析基體在mpo過程中的溶解現象和電解液中離子濃度變化特點，探討電極表面陶瓷膜層生長規律和結構特點;研究膜層的等效電路、膜層結構與耐腐蝕性能的關系，並對優化工藝條件下制備的陶瓷膜層進行進一步的耐腐蝕性能測試和耐腐蝕機制研究。
分享友人
分享到 Line

分享到臉書