鋯溶液 的英文怎麼說

中文拼音 [gàoróng]
鋯溶液 英文
zirconium solution
  • : 名詞[化學] zirconium (40號元素, 符號 zr)
  • : 動詞(溶化; 溶解) dissolve
  • : 名詞(液體) liquid; fluid; juice
  • 溶液 : solution; liquor; scald; aqua
  1. The silver colloid in the composite material never changed the ability of zp to tune the potential of redox mediators. but the ability of the zirconium phosphate to adsorb neutral red and the redox reaction ability of this phenothiazine dye were enhanced significantly in the composite film due to the nanosize silver colloid

    磷酸降低了納米銀膠粒在水中的聚集,提高了其催化活性,而銀膠粒保持了磷酸對介體的電位調制能力,並大大的提高了磷酸對堿性染料的吸附能力和染料分子的活性。
  2. It can determine the elements in water. when tta is used to extract zirconium in uranium, the combination of zirconium and tta is very strong, the concentrated acid of nitric acid and hydrochloric acid can not destroy their combination

    用tta萃取分離鈾、時, tta對的螯合作用很強,硝酸和鹽酸的濃酸並不能破壞它們之間的整合,即對的反萃取非常困難。
  3. The parameters of impregnation are as follows : ph is about 3, the range of temperature is from 20 to 45, and the time is about 2 to 6 hours. after the necessary treatments, zirconia cloths had the optimal strength when the diameters of zirconia fibers were controlled in 4um to 7um, and the sizes of zirconia grains were in 50nm to 100nm. the affec - ting factors were discussed and the liner regression analysis of the cloths was made, from w hich they show that the diameters and grain sizes have the significant influences on zirconia cloths. the obtained zirconia cloths have been accepted for use in nickel - hydrogen batteries by practical use

    研究結果表明:粘膠類纖維布最適合制備氧化纖維布的前軀體;濃度以飽和為宜;浸漬工藝參數為ph值3左右,溫度20 45 ,時間2 6小時;多餘鹽的去除、浸后纖維布的整平處理及平燒施應力燒成有利於氧化纖維布的柔軟及平整; 200 600燒成溫度段應緩慢燒成,控制氧化纖維直徑在4 7 m ,氧化晶粒尺寸50 100nm時氧化纖維布的強度最好。
  4. The preparing process is as follow : mixing the nickel salt, zirconium salt and stabilizer in the solvent ( distilled water ) to prepare mixing solution according to a certain ratio ; commingling the mixing solution and coordination solution of carboxylic ammonia in accordance with a certain rate to form sol, drying the sol and turning it into gel, pre - sintering the gel to get the zro2 - nio powders and the zro2 - ni nanocrystalline composite powders were gained by reducing the zro2 - nio powders

    方法如下:將鎳鹽、鹽、穩定劑和水劑按所需成分配成混和,再將混和、外加劑按比例混和形成膠,膠經乾燥成為凝膠,凝膠經預燒得到ysz - nio氧化物納米粉末,將該氧化物粉術還原得到ysz - ni納米復合粉術。絡合。
  5. In this study, the preparing processes of zro2 - ni nanocrystalline composite powder aremixing the nickel salt, zirconium salt and stabilizer, solvent ( distilled water ) together to prepare the mixing solution according to certain ratio ; commingling the mixing solution, coordination solution of carboxylic ammonia, intrusion aid in accordance with certain rate to form sol, drying the sol and turning it into gel, pre - sintering the gel to get the zro2 - nio powder and gaining zro2 - ni nanocrystalline composite powder by reducing the zro2 - nio powder. xrd, x - ray wide - angle diffractometer, bet, sem, tem, hrtem analyses are used to study the zro2 - ni nanocrystalline composite powder and zro2 - ni cermet. the sintering temperature is determined

    本研究的zro _ 2 - ni納米復合粉末的制備方法如下:將鎳鹽、鹽、穩定劑和劑(水)按所需成分配成混合,再將混合、外加劑和氨羧絡合劑按比例混合形成膠,膠經乾燥成為凝膠,凝膠經預燒得到zro _ 2 - nio納米粉,將該氧化物粉還原得到zro _ 2 - ni納米復合粉。
  6. Abstract : some new technological measures, such as new reactors, gel method to remove silicon, direct dissolve acid to recrystallizate and direct calcine from zirconyl chloride, were used to reform zirconium dioxide production process. as a result, the materials consumption and energy consumption were reduced and the wastewater discharge was decreased. meanwhile the rubbish were recovered and utilized to prepare into a by - product as silica aerosol. the pollution prevention and control in production process were achieved

    文摘:採用新型反應器及膠凝除硅、直接酸重結晶、直接煅燒等技術對二氧化的生產工藝進行了改革,降低了原材料消耗及能耗,減少了廢排放量,並將回收的廢物加工成副產品白炭黑,在生產過程中防治污染。
  7. Some new technological measures, such as new reactors, gel method to remove silicon, direct dissolve acid to recrystallizate and direct calcine from zirconyl chloride, were used to reform zirconium dioxide production process. as a result, the materials consumption and energy consumption were reduced and the wastewater discharge was decreased. meanwhile the rubbish were recovered and utilized to prepare into a by - product as silica aerosol. the pollution prevention and control in production process were achieved

    採用新型反應器及膠凝除硅、直接酸重結晶、直接煅燒等技術對二氧化的生產工藝進行了改革,降低了原材料消耗及能耗,減少了廢排放量,並將回收的廢物加工成副產品白炭黑,在生產過程中防治污染。
  8. Synthesis and characterization of samaria stabilized zirconia powders by buffer - solution method

    緩沖法制備氧化釤穩定氧化納米粉體及其表徵
分享友人