鋼軌內部應力 的英文怎麼說

中文拼音 [gāngguǐnèiyīng]
鋼軌內部應力 英文
internal rail stress
  • : 鋼名詞(鐵和碳的合金) steel
  • : Ⅰ名詞1. (路軌;軌道) rail; track 2. (比喻辦法、規矩、秩序等) rut; path; course Ⅱ動詞[書面語] (遵循; 依循) follow
  • : 名詞1. (內部; 里頭; 里邊) inner; inside; within 2. (妻子或妻子的親屬) one's wife or her relatives 3. (姓氏) a surname
  • : Ⅰ名詞1 (部分; 部位) part; section; division; region 2 (部門; 機關或組織單位的名稱) unit; mini...
  • : 應動詞1 (回答) answer; respond to; echo 2 (滿足要求) comply with; grant 3 (順應; 適應) suit...
  • : Ⅰ名1 (力量; 能力) power; strength; ability; capacity 2 [物理學] (改變物體運動狀態的作用) forc...
  • 鋼軌 : rail; metals; steel rail; railroad rail鋼軌間隙 dilatation joint; 鋼軌聯接板 joint bar; splice ba...
  1. And it investigates the appearance condition ( including joint, crack, eroding, corrosion, braking pole device rupture, crane - girder ' s gnawing railway and so on ) of the whole crane - girder system on the spot, at the same time, it also actually examines the stress of the beam, chemical ingredient, distortion and railway excursion, etc. through sampling, and based on the actually examined results, it checks and calculates the carrying capacity of crane - girder system. then, based on the investigating on the spot and the calculated result, it discusses the mechanism of fatigue failure of the upper part of welded steel crane - girder, analyses the reason of steel crane - girder in the high - frequency emerging the fatigue crack, institutes the strengthened method of damaged steel crane - girder of accurate packing up workshop of the primary mill plant. finally, it presents some advice and suggestions for the repairing and strengthening method of fatigue crack of upper part of steel crane - girder in the high - frequency

    針對包初軋廠精整車間吊車樑上區域出現裂縫這一問題,本文首先綜述了國外關于焊接吊車樑上區域疲勞裂縫的研究現狀;其次對整個吊車梁系統的外觀情況(包括連接、裂縫、腐蝕、銹蝕、制動桿件斷裂、吊車啃等)進行了現場調查,抽樣實測了梁的、化學成分、變形及道偏移等,根據實測結果,對吊車梁系統的承載能進行了驗算;然後,根據現場調查及計算結果,探討了焊接吊車樑上區域疲勞破壞的機理,分析了重級工作制吊車梁出現疲勞裂縫的原因,制定了初軋廠精整車間破損吊車梁的加固方案;最後就重級工作制吊車樑上區域出現疲勞裂縫的修復與加固方案提出了一些意見和建議。
  2. As the analysis shows that stress of the outside joint bar of rail is higher than that of the inner joint bar when a wheel rolls over the rail joint. furthermore the change of bolt tension has great effect to the stress distribution and stress level of all parts of rail joint

    分析表明:接頭受時,外側夾板的水平比側夾板的水平高;在受條件相同的情況下,螺栓扭矩的變化對接頭各件的分佈及水平有較大影響。
分享友人