錐拔 的英文怎麼說

中文拼音 [zhuībá]
錐拔 英文
taper
  • 錐 : Ⅰ名詞1. （錐子） awl2. （似錐物） awl-shaped things 3. （錐體） cone Ⅱ動詞（鉆） drill; bore
  • 拔 : Ⅰ動詞1 （拉出; 抽出） pluck; pull out; pull up; draw; move 2 （吸出） draw; suck out 3 （選取 提...
  1. Through the pull - out experiment, the load displacement curve was obtained. contrasting the test results under the different condition to post - installed bar, it was clear about the mechanism of the inorganically post - installed bars. the test results of inorganically post - installed bars was compared especially with the traditional organically post ? installed bars

    通過拉拔試驗，得到了荷載位移曲線，對比了不同條件下植筋的試驗結果，明確了無機植筋的受力過程，特別同有機植筋進行對比，並提出了帶錐頭無機植筋的施工工藝。
  2. Abstract : this paper analyzes theoretically the effect of the reversed cone angle and length of the plug on restraint and elimination to the distortion of the internal spiral ribs, and put forth the design methods of the plug in drawing rifled tube

    文摘:從理論上分析了芯棒倒錐角和芯棒長度對內螺旋凸筋形狀畸變的抑制和消除作用，提出了採用倒錐形等螺距芯棒拉拔內螺紋管時芯棒幾何參數的設計方法。
  3. The calculation results show that the stress distributing of the plug drawing tube is different because of different dies, the drawing force and pulling force are lager in arc die and the diameter and wall thickness are closer to the designing value in cone die

    計算結果表明，不同的模具，芯拔管的應力分佈不同，弧形模成型的拔制力與芯棒后拉力較大，錐形模成型后鋼管的直徑與壁厚更接近設計值。
  4. Taper or tapere bolt

    推拔螺栓，錐形螺栓
分享友人
分享到 Line

分享到臉書