垂距 的英文怎麼說

中文拼音 [chuí]
垂距 英文
offset
  • : Ⅰ動詞1 (東西的一頭向下) hang down; droop; let fall 2 [書面語] (敬辭 多用於長輩、上級對自己的行...
  • : Ⅰ名詞1 (距離) distance 2 (雄雞、雉等的腿的後面突出像腳趾的部分) spur (of a cock etc )Ⅱ動詞...
  1. To reduce the marking distortion, using the vertical 2 - dimension galvanometer distributing and f field lens focalize, the distance of the second galvanometer to the machining plane is the focus f. to avoid too hign temperature to distroy the resonance cavity because of too long marking time, cooling system and self - protector is used in the design

    為減少打標畸變,採用直二維振鏡分佈, f物鏡聚焦,將激光束經第二個振鏡反射後到加工平面的離為焦f ,為了避免打標時間過長,溫度過高破壞諧振腔,在設計中加上冷卻系統和自我保護裝置。
  2. The effect of the height between nozzles and ground plate, the distance between the nozzles, the inlet velocity of the nozzles, and the velocity of the cross flow on the flowfield structure were studied one by one

    分別就噴嘴地面高度、噴嘴間、噴嘴出口速度、橫向流等,對噴射直撞擊平板流場的影響,逐一討論。
  3. Breakthroughs in modern gyroplane technology - an introduction to the advances in gyroplane technology and the emerging market opportunities for a new generation of gyroplanes ranging from small vtol & ustol gyroplanes to large vtol gyrodyne airliners or freighters with 20 ton payload capacity

    現代旋翼機科技的突破-介紹旋科技的進步,以及新一代旋翼機的市場機會,從小型超短離升降和直升降的旋翼機到可直升降,載重20噸以上的大型直升旋翼客機和貨運機
  4. We will denote by h the perpendicular distance from p to the inclined face.

    我們用h來表示從p點到斜面的離。
  5. Green or brown flexible petiole, variable internode length. large trailer

    綠色或咖啡色的柔軟葉柄,節間離易變。大的懸型。
  6. The helicopter is allowed to fall the same distance that it climbed at the beginning of the maneuver before pulling the helicopter back to straight and level flight

    待直升機直俯沖的離與直爬升的離相同時,拉起機頭恢復成水平直線飛行。
  7. He would come up, close, co - altitude, within about three to five feet, was making gestures, pulled back a little bit, came back up again and made some more gestures, and then the third time his closure rate was too far. instead of under - running, he attempted to kind of turn and pitch up, and that was when his vertical stabilizer - - where it meets the fuselage of the aircraft - - impacted my number one propeller, basically pretty much tearing his aircraft apart

    他追上來、靠近、與我們同一高度,我們約3英尺到5英尺以內,他做了幾個手勢,後退了一點,再次追過來並做出更多的手勢,然後他第3次靠近,這次他離得太近了。他不是在下方飛行,而是試圖做出某種轉身和提拉,此刻他的直穩定翼同機身相接的地方撞到了我的1號螺旋槳,他的飛機基本上就斷裂了。
  8. Liihe palynological data indicate a vertical paleovegetational landscape : evergreen broad - leaved forest dominated by castanopsis, lithocarpus, cycobalanopsis and anacardiaceae etc occurred on the slopes near the deposit site ; mixed coniferous / broad - leaved forest and coniferous forest occurred on the area of high elevation, and main elements were tsuga, podocarpus, pinus, picea and abies etc. seven paleoclimatic parameters of liihe area estimated include mat ( 13. 3 - 20. 9c ), wmt ( 22. 5 - 27. 5c ), cmt ( 2. 5 - 12. 6c ), dt ( 12. 1 - 24. 8c ), map ( 803. 6 - 1254. 7mm ), mmap ( 179. 4 - 281. 9mm ) and mmip ( 10. 2 - l8. 5mm ). yangyi palynoflora comprises of 52 palynomorphs belonging to 32 families. the percentage of angiosperms is 61. 5 %, gymnosperms 9. 6 %, pteridophytes 25. 0 %, algae 3. 9 %

    呂合孢粉植物群的組成反映該地區在沉積時期植被具有直分帶特徵,沉積地附近分佈有常綠闊葉林,包括殼斗科的青岡屬、栲屬、石櫟屬和漆樹科等植物,以及多種亞熱帶和溫帶闊葉成分;林中混生少量針葉樹(如松屬和杉科等) ;林內蕨類植物較少;沉積地較遠的海拔較高的地區分佈由鐵杉屬、冷杉屬、雪松屬和雲杉屬組成的針闊混交林或針葉林。
  9. The application in the use of the design in certain v / stol aircraft proved the realization of this method

    重點分析了其在某型直短飛行器設計中的應用,證明了該方法在系統評價中的有效性。
  10. A simulation of the guidance scheme applied to the example tilt rotor vehicle exhibits satisfactory behavior in the presence of wind and initial errors

    模擬結果表明,在初始擾動和有風作用下,離偏差均達到很小。
  11. 4 a block diagram of phased array radar used which is used to measuring the distance, velocity and azimuth of the object in the horizontal plan and the highness in the vertical plane

    4給出了水平方向採用二維譜估計技術測離、速度和方位,直方向採用波束掃描測高的小型車載相控陣雷達系統框圖。
  12. Therefore we should choose length, width, height and interval of frames according to water height and demand of velocity. the results can be used for reference to the design of bank protection works

    隨著l h 、 b h 、 a h的增加,框架群后對應點線平均流速的減速率也逐漸增加,保護區長度、寬度也不斷增加,因此,應根據不同的水深和減速率要求拋投相應長度、寬度、高度、間的框架群。
  13. This process is as follows : firstly, the data of different section contour and of section line have been obtained by reverse - engineering ; secondly, non - uniform b - spline approximation algorithm is used to fit the discrete data ; then the data have been optimized and reduced by adopting adaptive sampling of key points of the fitted curve based on vertical distance, sequently the adaptive sampling data is transformed into the format of the. ibl file of the famous 3 - d design software pro / e. therefore we reconstruct the surface and a model is generated ; lastly, the effectiveness of the adopted algorithm and modeling approach are demonstrated by the experiments

    建模型的過程中,首先運用逆向工程測量方法,獲得曲面物體上不同截面輪廓線的測量數據點列,接著對測量數據點進行平滑處理,用最小二乘法求解基於數據點列的控制多邊形,以非均勻三次b樣條曲線擬合截面輪廓曲線;然後利用基於垂距的數據采樣演算法,對擬合曲線上的數據點進行重新采樣,達到優化數據點的分佈及減少描述曲線數據量的目的。
  14. When the calculated offset from recorded chirp is higher from the sum of offset and delta offset then such record is repeated

    當計算后的記錄的短促聲波的垂距垂距和三角垂距的總和要高的時候,這樣的紀錄將被重置。
  15. Delta offset is an acceptance of maximum positive deviation from the offset value

    三角垂距是最大正面偏差取從垂距的值。
  16. Offset is a time presented in bytes ( different settings required different amount of memory to store sound data ) between the played signal and the same signal recorded by microphone

    垂距是代表時間,以位元組的形式(不同的設置要求不同的記憶體的數量存放聲音數據)在播放的的信號和相同的信號之間由話筒記錄。
  17. Set offset this option allows you to change manually the offset settings

    這個選項允許您手工改變垂距設置。
  18. New future the signal strength. if the offset and the signal are good enough the level should be above the 2 bar

    新未來信號強度。如果垂距和信號在足夠好的水平,應該是在第2欄之上。
  19. This test searches for the correct offset. the additional information are displayed during the test. this test is important when the device is recording but can ' t find the played signal

    這個測試尋找正確垂距。其它信息在測試期間被顯示。當設備在記錄但無法發現被播放的信號時,這個測試十分重要。
  20. By using the calculating method of distance from points to the center line according to document 1, a new optimum calculating method has been proposed in this article, which can simply and successfully solve the problem for selection of existing curve elements

    利用文獻1給出的中點到中線垂距計算公式及程序,提出一種新的優化計算方法,能簡便而圓滿地解決既有曲線要素的選擇問題。
分享友人