鏈子調節器 的英文怎麼說

中文拼音 [liànzidiàojiéqì]
鏈子調節器 英文
chain adjuster
  • 鏈 : Ⅰ名詞1. （鏈子） chain Ⅱ動詞（用鏈栓住） chain; enchain Ⅲ量詞（計量海洋上距離的長度單位） cable length
  • 子 : 子Ⅰ名詞1 （兒子） son 2 （人的通稱） person 3 （古代特指有學問的男人） ancient title of respect f...
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 節 : 節構詞成分。
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 調節器 : regulator; adjuster; governor; controller; conditioner; actuator; phaser
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  1. This paper also use non - linear feedback decoupling theory to decouple die vector - control close - loop system into linear decoupling of rotor speed and rotor flux linkage subsystems. the speed regulator and flux linkage regulator of these two linear subsystems can be designed with classical linear theory

    本文同時還應用非線性反饋解耦理論將矢量控制的閉環系統分解為線性化的轉速子系統和轉子磁鏈子系統，兩個子系統中的速度調節器和磁鏈調節器可按線性理論設計。
  2. In the paper, a speed estimator based on artificial neural network is designed according to the principle of direct torque control, the speed estimator is optimized by genetic algorithm, and the parameters of pid speed adjuster is also optimized by genetic algorithm. a stator linkage and torque observer based on stator resistance estimator using fuzzy neural network is also designed. eventually, the intelligent control of direct torque control system is implemented

    本文根據異步電動機直接轉矩控制原理，在應用人工神經網路進行速度辨識的基礎上，利用遺傳演算法對神經網路速度辨識器進行了優化設計；運用遺傳演算法對pid速度調節器的結構和參數進行了整合；在採用模糊神經網路對電機定子電阻辨識的基礎上，進行了定子磁鏈及轉矩的觀測，為最終實現無速度傳感器直接轉矩控制系統的智能控制創造了條件。
  3. The dissertation deals in details with the basic principle of direct torque control. according to the faults of traditional direct torque control and the requirement of an induction motor ' s control strategy change the method of regulating stator flux to make its path approximate to a circle as possible as could. to get quickly torque control, use a three - value regulator

    本論文介紹了電動機直接轉矩控制的基本原理，並根據傳統直接轉矩控制存在的缺點以及對電動機調速性能的要求，改變對定子磁鏈的調節方式，使定子磁鏈軌跡近似為一圓形，對轉矩採用三值調節器進行調節，以實現轉矩的快速調節。
  4. After the analysis of the state of converter switches, the voltage space vector is received. on the basis of hexagon stator flux trace method of traditional direct torque control, by changing the regulation of stator flux, hexagon and approximate round trace of stator flux can be got when using different voltage space vector. the fast regulation is realized when three - value regulator is used to adjust torque

    通過對逆變器開關狀態的分析進而得到電壓空間矢量，並且論述了電壓空間矢量與轉矩和磁鏈之間的關系，使用兩點式調節方法對定子磁鏈進行調節，實現六邊形磁鏈軌跡和圓形軌跡方案，對轉矩採用三值調節器進行調節，以實現轉矩的快速調節。
  5. Secondly, to achieve the independent regulation of active and reactive power output from the generator side which is designed for the purpose of tracing the maximum wind - energy capturing. the paper has analyzed the mathematic model of the ac excited doubly - fed machine and the stator field orientation control strategy of the motor as vscf wind power generator. thirdly, it has put forward and designed the dual pwm converter with the capacity of energy flowing bidirectional aimed at the demand of rotor energy bidirectional flow. the author constructed reliable and integrated experimental system and did a series of experimental study including no - load, cutting - in network and power generation at, below and above the synchronous speed

    論文首先分析了風機運行特性及其最佳風能利用原理，通過模擬及實驗驗證了採用直流電機的輸出特性模擬風力機的最大輸出功率曲線的可行性，並給出了模擬系統的硬體結構；然後為了實現交流勵磁發電機有功、無功功率獨立調節機理，分析了交流勵磁雙饋發電機的數學模型和在追蹤最大風能捕獲變速恆頻風力發電時必需的定子磁鏈定向矢量控制策略；針對雙饋發電機轉子能量雙向流動的要求，提出並設計了具有能量雙向流動能力的雙pwm交流勵磁用變頻器；最後為實現從理論到實踐的全面研究，研製出了一套小功率完整的雙pwm變頻器交流勵磁的雙饋風力發電機實驗系統，進行了空載、並網、同步速及上、下的發電運行等一系列的運行實驗；所完成的模擬和實驗研究均驗證了理論、模型和控制策略的正確性、可行性。
  6. Aim at the dtc ' s blemish mentioned above and the direction of dtc technique development, the dissertation put great emphasis on the work as follows, with an eye to exalt dtc system function : ( 1 ) a new speed - flux observer of an induction motor is proposed to enhance the accuracy of flux observing, which is an adaptive closed - loop flux observer and different from the traditions. a new adaptive speed - observation - way is deduced out according to the popov ' s stability theories ; ( 2 ) to improve the performance of dtc at low speed operation, we have to exalt the accuracy of the stator flux estimation and a new way of bp neural network based on extended pidbp algorithm is given to estimate and tune the stator resistance of an induction motor to increase the accuracy of the stator flux estimation ; ( 3 ) digital signal processor is adopted to realize digital control. an device of direct torque control system is designed for experiment using tms320lf2407 chip produced by ti company ; ( 4 ) bring up a distributed direct torque control system based on sercos bus, sercos stand for serial real time communication system agreement which is most in keeping with synchronous with moderate motor control ; ( 5 ) the basic design frame of the hardware and software of the whole control system is given here and some concrete problem in the experiments is described here in detail

    針對上面提到的直接轉矩控制的缺陷和未來直接轉矩控制技術發展方向，本論文重點做了以下幾個方面的工作，目的在於提高dtc系統的綜合性能： （ 1 ）提出一種新型的速度磁鏈觀測器，新型的速度磁鏈觀測器採用自適應閉環磁鏈觀測器代替傳統的積分器從而提高磁鏈觀測的精度，並且根據popov超穩定性理論推導出轉速的新型自適應收斂律； （ 2 ）改善系統的低速運行性能，主要從提高低速時對定子磁鏈的估計精度入手，提出了一種提高定子磁鏈觀測精度的新思路? ?利用基於bp網路增廣pidbp學習演算法來實時在線地修正定子電阻參數； （ 3 ）採用數字信號處理器dsp實現系統全數字化硬體控制，結合ti公司生產的tms320lf2407晶元，設計了直接轉矩控制系統的實驗裝置； （ 4 ）提出了基於sercos總線網路化分散式的直接轉矩控制系統， sercos （ serialrealtimecommunicationsystem ）是目前最適合同步和協調控制的串列實時通信協議； （ 5 ）基本勾勒出整個控制系統的硬體和軟體設計基本框架，詳細描述一些實驗中的具體的細節問題。
  7. In this reactor, a series of nano - sized crystals, one - dimension chain structure of [ cu ( idac ) ( h20 ) 2. and [ ag ( l - phe ) ] were formed through self - assembly with different length and diameter. the length and diameter of the nanorods could be adjusted by changing the molecular weight of peg and the content of the water in the reactor

    在該反應器中，通過改變peg的分子量和調節反應器中水的含量，過渡金屬離子和氨基酸分子通過自組裝方式結合形成了一系列不同長度和直徑的一維鏈狀的[ cu （ idac ） （ h _ o ） _ 2 ] _和[ ag （ l - phe ） ] _納米晶。
  8. In this paper, the author divides the digital governor as speed control unit, drive unit, electronic execution unit. for above three parts, the author also makes principle emulating from structure and function and constructs the hotspot information chain with next class hotspot information chain of specific functions

    本文將電子調速器分為轉速調節單元、驅動控制單元、電動執行單元，對這些功能單元從結構、功能上進行原理模擬，建立單元的熱點信息鏈與具體功能建立二次熱點信息鏈。
  9. Limited by time this paper focused on three areas : ( 1 ) basic dtc principal study and research ( 2 ) the design of speed regulator of dtc ( 3 ) a new kind of stator flux observer because the dtc system is a nonlinear system and we ca n ' t grasp the parameters completely, the classic speed regulators design method is not fit for dtc system

    由於時間有限，本文所進行的研究工作主要集中在三個方面： （ 1 ） dtc基本原理的學習與實現（ 2 ） dtc中轉速調節器的設計研究。 （ 3 ）新型定子磁鏈觀測器的研究。 dtc所具有的非線性和參數不可知的特性決定了直流調速系統的轉速調節器的設計方法不能完全適合於dtc系統。
分享友人
分享到 Line

分享到臉書