防漏試驗的 的英文怎麼說

中文拼音 [fánglóushìyànde]
防漏試驗的 英文
leak-tested
  • : Ⅰ動詞(防鷥) provide against; defend against; guard against Ⅱ名詞1 (防守; 防禦) defence 2 (堤...
  • : Ⅰ動詞1 (從孔或縫中滴下、透出或掉出) leak; drip 2 (泄漏) divulge; disclose; leak 3 (遺漏) le...
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • : 4次方是 The fourth power of 2 is direction
  • 防漏 : sealing up防漏劑 leak preventive; 防漏鉚接 tight riveting; 防漏密封 leakproof seal
  • 試驗 : trial; experiment; test
  1. Secondly the paper develops two new techniques that enable the software on a computer to control the electromagnetic radiation of crt monitor transmits at very low cost : digital filter and dithering technique, validates the two methods to reduce the information leakage by a experiment. aiming at the shortage of software process, this paper gives a new method which combines the software with hardware

    在此基礎上提出了兩種全新視頻信息泄技術(數字濾波與偽發射技術) ,並且進行了實際測和分析,證了它有效性、可行性,然後針對它們不足之處提出了一種軟體和硬體相結合新方法。
  2. Protective clothing for use against solid particulates - test method of determination of inward leakage of aerosols of fine particles into suits

    固體顆粒用護服.測定細粒氣溶膠向服裝內滲方法
  3. Protective clothing for use against solid particulates - part 2 : test method of determination of inward leakage of aerosols of fine particles into suits

    固體顆粒用護服.第2部分:測定細粒氣溶膠向服裝內滲方法
  4. The phenomena can be observed in the tests low seepage pressures can easily form passageways behind the waterproof layer if there is no drainage layer or the drainage layer is blocked in the single - shell test slab ; the waterproof layer can resist higher seepage pressure if there is no drainage layer or the drainage layer is blocked in the double - shell test slab ; the seepage water can be controlled and drained away in the drainage layer by the water proof layer only if there is unblocked drainage layer behind it in the double - shell test slab

    可見,在單層板中沒有排水層或排水層不通暢時,較低水壓就能在水膜后形成滲流通路;在雙層板中沒有排水層或排水層不通暢時,水膜能抵抗一定程度水壓;只有在雙層板中排水層暢通時,水膜才能有效地將滲水控制在排水層中排走。
  5. Test method for total inward leakage of filtering particle respirator

    過濾式微粒口罩總透方法
  6. Plastics piping systems. elastomeric sealing ring type joints and mechanical joints for thermoplastics pressure piping. test method for leaktightness under external hydrostatic pressure

    塑料管道系統.熱塑塑料壓力管道用彈性密封環型接頭和機械接頭.外部液壓條件下密封方法
  7. Plastics piping systems - elastomeric sealing ring type joints and mechanical joints for thermoplastics pressure piping - test method for leaktightness under external hydrostatic pressure

    塑料管道系統.熱塑塑料壓力管道用彈性密封環型接頭和機械接頭.外部流體靜壓條件下密封方法
  8. Standard test method for non - destructive detection of leaks in medical packaging which incorporates porous barrier material by co2 tracer gas method

    Co2示蹤氣體法對用多孔滲透材料包裝泄性進行無損檢測標準方法
  9. To avoid the pollution of groundwater resource and adjacent environment caused by drainage pipe leakage, current criterion in our country stipulates that there must be a pressurization test before drainage pipes are used

    止污水管道滲而導致污水外滲污染地下水資源和周邊環境,我國現行規范規定,無壓管道在竣工交付使用之前必須進行管道嚴密性
  10. On the basis of analyzing the features of commonly - occurred leak problem in exterior walls in coast area, seepage force of rainwater in exterior walls and comparison test results of permeability in exterior walls, the article proposes a basic principle of seepage prevention of exterior wall and introduces its use in newly - built residence and treatment for tough leak problem in exterior walls

    在分析沿海地區建築外墻常見滲特徵、外墻雨水滲透動力以及外墻抗滲性能對比結果基礎上,提出了外墻基本原理,介紹了其在新建住宅外墻工程和外墻疑難滲問題治理工程中應用。
  11. ( 4 ) one row seepage wall, which is formed by sprinkling grouting method, is used to the xiacouba reservoir project for cutting off the way of seepage on the basis of the project condition and grouting test. the results testified that a sound effectiveness of preventing seepage could be attained by the application of the high - pressure sprinkling grouting technology if design paramenter is proper and the construction quality is controlled strictly

    根據工程要求、 _仁質條件及灌漿,本工程選用單排旋噴套接方式形成滲墻,實踐證明,只要設計參數合理,施工過程嚴格控制,利用高壓噴射灌漿技術可達到滲、堵
  12. Leak detection systems - part 7 : general requirements and test methods for interstitial spaces, leak protecting linings and leak protecting jackets

    系統.第7部分:填隙部位襯層和一般要求和方法
  13. Non - destructive testing - terminology - terms used in leak tightness testing

    無損檢.術語.第8部分:術語
  14. The waterproof layer and partial structures of composite linings were simulated by single and double shell concrete test slabs, and the seepage water pressure was applied to the slabs with the manual pump

    通過單層、雙層混凝土板對水層及隧道襯砌局部結構進行了模擬,並通過手動泵進行滲水壓加載。
  15. Plastics piping systems. valves for polyethylene piping systems. test method for leaktightness under and after bending applied to the operating mechanism

    塑料管道系統.聚乙烯管道系統用閥門.在操作機構上彎曲和彎曲后方法
  16. Standard test method for water penetration of exterior metal roof panel systems by uniform static air pressure difference

    採用均勻靜態空氣壓差分析外部金屬屋面板系統性能標準方法
  17. Plastics piping systems - end - load - bearing and non - end - load - bearing assemblies and joints for thermoplastics pressure piping - test method for long - term leaktightness under internal water pressure

    塑料管道系統.熱塑性壓力管道用端部承載及非端部承載組件和接頭.內部水壓下長期方法
  18. Geosynthetic barriers - test method for determining the resistance to leaching ; german version en 14415 : 2004

    土工合成阻擋層.測定方法
  19. Leak detection systems - general requirements and test methods for interstitial spaces, leak protecting linings and leak protecting jackets

    系統.填隙空間泄護襯和泄護套一般要求和方法
分享友人