防護塊體 的英文怎麼說

中文拼音 [fánghùkuāitǐ]
防護塊體 英文
guard block
  • 防 : Ⅰ動詞（防鷥） provide against; defend against; guard against Ⅱ名詞1 （防守; 防禦） defence 2 （堤...
  • 護 : 動詞1. （保護; 保衛） protect; guard; shield 2. （袒護;包庇） be partial to; shield from censure
  • 塊 : 名詞（古時佩帶的玉器） penannular jade ring （worn as an ornament in ancient china）
  • 體 : 體構詞成分。
  • 防護 : protect; shelter; shield; guard; shielding; protection; proofing
  1. Following the research route of mend with study and development with creation, give the definition of risk and the methods of risk identifying, divide the risk attitude into risk loving, risk neutralism and risk avoiding, point out the importance of enhancing the risk consciousness for lightning hazard, and summarize the mechanisms of lightning hazard the theories and methods of risk assessment for lightning hazard. provide a set of risk assessment parameters for lightning hazard, which includes lightning times n, hazard probability p, hazard loss d, hazard risk r and protection efficiency e, and give the definition, decisive factor, value method and value scope of each parameter. establish a risk assessment model for lightning hazard which includes lightning hazard base module, lightning hazard probability module, lightning hazard loss module, lightning hazard accepted risk module, lightning protection cost module, correcting coefficient module, lightning hazard risk module, and lightning protection class and efficiency module

    遵循借鑒改造和發展創新的研究思路，給出了風險的定義和風險識別的方法，將風險態度分為風險喜好型、風險中庸型和風險逃避型，指出了提高雷電災害風險意識的重要性，總結了雷電災害的作用機制和雷電災害風險評估的理論與方法；提供了包括雷擊次數n 、雷災概率p 、雷災損失d 、雷災風險r和雷電防護級別與防護效率e等5類基本參數的雷電災害風險評估參數體系，並給出了各個參數的定義、參數的決定因素和取值方法以及取值范圍；設計了包括雷電災害基礎模塊、雷電災害概率評估模塊、雷電災害損失評估模塊、雷電災害允許風險評估模塊、雷電防護成本評估模塊、校正系數模塊、雷電災害風險評估模塊、雷電防護級別與效率分析模塊等8個模塊的雷電災害風險評估模型，評估模型以iec61662的評估模型為基本參考，以雷災損失d為中心，把雷災風險劃分為經濟雷災風險r _ e和人身雷災風險r _ l ，並對r _ e和r _ l分開單獨處理。
  2. For bus system installation, the focus is put on cable selection principle, installation process and antinoise measure ; for security protection equipment installation, the intrinsic safety concept, installation method equipment selection and installation under two electric power supply modes ( entity concept and fisco model ) and the bus system protection against surge voltage are illustrated ; for network component installation, the selecting, installing and integrating methods of general purpose terminators, repeaters, link equipment, bus power supply and impedance module are described

    在總線電纜的安裝方面，著重討論了電纜的選型原則、安裝方法和抗噪防擾措施；在安全保護設備安裝方面，介紹了總線系統中本質安全的概念、安裝方法、兩種供電方式（實體概念和fisco模型）下設備的選擇與安裝以及總線系統浪涌電壓的保護和設備安裝方法；在網路元件的安裝方面，主要列舉了通用終端器、中繼器、鏈路設備、總線電源及其阻抗模塊等的選擇、安裝和集成方法，為總線系統的安裝提供了可以借鑒的實用經驗。
  3. Firstly, the system is divided into many modules according to different point of view ; secondly, to the hardware equipment - vidicon, lenses, revolver, shield and decode device, their principle of work has been explained ; thirdly, according to image identification experience and other indexes of the system, the focus of the lenses and relative aperture are calculated, and the type of the camera is confirmed, at the same time, the energy of infrared lamp is also computed in the thesis ; at the same time, synthesis control box is devised

    首先，按照角度的不同，將系統劃分成許多模塊。其次，對硬體設備? ?攝像機，鏡頭，雲臺，防護罩，解碼器等的工作原理進行了闡述，再次，以人的成像辨認的經驗判據為依據，結合系統的其它指標，設計計算出鏡頭的焦距f 、相對孔徑d ，同時確定攝像機的型號，並計算出紅外燈光源。最後，對綜合控制箱進行設計，指出了設計的意義，實現的功能，並附上了綜合控制箱的外形圖。
  4. In this thesis, first, reasons and factors for the stability of loose rock dams were summarized according to the field surveys and certain expert ' s experiences. then, researches on block stability problems were reviewed, and according to the relationship between grain size and incipient velocity, it is found that the block weight is in direct proportion to 6 - 9 power of incipient velocity, and 50 % increase of the velocity will result in about 40 times change of the block weight. after that, experiments were conducted in a flume, focusing on the relationship between incipient velocity and some main factors including block weight, water depth over the dam, cross - section size, block material and river bed material

    本文首先根據散拋石壩損毀情況的現場調查資料，結合有關專家多年的整治經驗，總結出壩體的損毀原因及影響因素；對現有塊體穩定性的研究成果進行回顧和總結，並針對散拋石壩的直接損毀現象，結合山區河流的水流、地形特點，利用塊體粒徑與起動流速的關系，提出塊體穩定重量與起動流速高次方成正比的概念，流速50的增長可能導致塊體穩定重量接近40倍的變化；通過二維變坡水槽試驗，研究了壩體穩定的主要影響因素，包括塊體重量、壩頂水深、斷面尺寸、塊體材料（塊石和卵石兩種） 、護底等，結果表明對于山區河流，試圖僅僅通過增加壩體單個塊體重量或斷面尺寸來提高壩體穩定性效果甚微；最後，根據西部地區的自然、經濟、交通等條件，提出可以採用柔性混凝土鉸鏈體等一類整體性較好的護面層作為散拋石壩的防沖毀措施，以期取得良好的工程效果。
  5. Whereafter, based on the analysis on the flood influence for traffic lines, the research is centered on the following parts : firstly, the destroying modes, reasons and mechanism of flooded lines are discussed, and the frameworks and countermeasures of preventing and controlling hazards system are put forward ; secondly, the ways of region forecasting for the landslide are analyzed and the automation of landslide forecast for certain site through visual programming is realized. furthermore, the function of dynamic segmentation in arc view is made use of to realize the forecast result ' s visualization ; thirdly, the reasons and patterns of roadbed subsidence are discussed and the methods of forecasting subsidence based on the gm ( 1, 1 ) model are put forward. then the applications of the arcview software and its extended module on the study of roadbed subsidence are debates upon ; fourthly, an analysis on the sources of flood for traffic lines, which situate in the reservoir coverage area, is given

    接著，論文探討了山區交通線路災害的特點、分類、時間和空間分佈規律以及災害的防治原則和對策等；然後，以洪水災害對交通線路的毀壞為主線，重點研究和分析了以下幾個問題：第一，探討了洪水對交通線路的破壞方式，水毀原因以及水毀機理，並提出了交通線路水毀防禦系統框架和對策；第二，分析了雨季邊坡塌方災害的區段預測方法；通過可視化編程，編制了雨季邊坡塌方災害的工點預報程序，並結合arcview實現了預測結果的可視化；第三，對路基沉陷原因和模式進行了分析，並提出利用gm （ 1 ， 1 ）模型對路基沉陷區進行分析和預測，最後論述了arcview軟體及其擴展模塊在沉陷區研究分析中的應用；第四，對汛期庫區線路災害的原因進行了分析，並探討了利用數量化理論對路基防護工程抗洪能力進行預測的意義；第五，提出從風險的角度對交通線路的防災減災進行管理，對風險估計的相關問題進行了論述，並探討了交通線路水害危險區段的劃分問題。
  6. Install the electronic ignition control module on the shell of distributor, fasten bolt, and then put on protective cover on sensor and electronic ignition control module

    將電子點火控制模塊安裝在分電器殼體上，緊固螺釘，然後給傳感器及電子點火控制模塊罩上防護罩
  7. This research mainly discusses the whole design scheme and the detail design of two application modules which are information maintenance module and information publish module on the base of the network information management system of the fire - fighting bureau

    論文具體闡述了「公安消防部隊網路信息管理系統」總體設計以及系統中的「信息維護模塊」和「信息發布模塊」兩部分的詳細設計和具體功能實現。
  8. And a practical example accomplished at huanghuagang harbor of hebei province was given at the end of this paper

    最後介紹了黃驊港防護堤、欄柵板護面塊體混凝土施工實例。
  9. As a kind of typical durable thermal protection system ( tps ), the metallic thermal protection system not only overcomes many disadvantages of the traditional ceramic tps, but also has many inherent advantages such as low cost of full life span, character of structure module, integration of mtps and the main structure of vehicle, all weather and easy to check, maintain and exchange. therefore, it is very important to investigate reusable mtps technology

    金屬熱防護系統作為一種典型的耐久性熱防護系統，不但克服了傳統陶瓷熱防護系統的諸多缺點，而且還具有許多獨特優點，如:全壽命成本低，結構模塊化，熱防護系統與機體結構一體化，全天候，易檢查、維護和更換等，所以先進可重復使用金屬熱防護系統的研究是十分必要的。
  10. Information maintenance module is based on the client / server structure. according to the analysis of the requirement of the fire - fighting bureau, make the daily grind be standardization and by using network application program deal with all kinds of operations logical and access controls and complex logical rules

    信息維護模塊採用client server體系的兩層應用結構，根據軟體工程的開發標準，分析公安消防部隊幹部信息管理實際需求，建成規范化的、標準化的信息管理系統。
  11. Slave cpu receives the spwm data and output the spwm wave by query the spwm table. the dead time is generated by hardware to prevent the h bridge arm from short directly. the power out module is protected for over current, over voltage and over heat

    逆變器採用雙cpu結構，使用spi進行連接，主cpu完成輸入、輸出和spwm波形數據的計算，從cpu接收到spwm數據后使用查表方法輸出spwm波形，使用硬體電路生成死區時間防止橋臂直通，對輸出功率模塊進行了過流、短路、過壓、過熱保護。
分享友人
分享到 Line

分享到臉書