附體渦 的英文怎麼說
中文拼音 [bùtǐguō]
附體渦
英文
bound vortex-
This factor accounts for the gas adsorbed on the solids, its interchange between the wake and the emulsion, and its holdback in the system.
這個系數考慮到了在固體顆粒上吸附的氣體，尾渦和乳化相之間的交換以及在這個體系中的滯留量。The ejected coolant interacts with the external flow near the endwall and generates aerodynamic and thermodynamic losses in the process. this reduces turbine stage efficiency and together with the consumption of cooling air is detrimental to the overall cycle efficiency
但這種方法中噴射的冷空氣與端壁附近的外流場相互作用產生氣動力和熱動力損失，並且消耗冷卻空氣，從而損害渦輪的整體循環效率。A spiral motion of fluid within a limited area, especially a whirling mass of water or air that sucks everything near it toward its center
漩渦在一定地域內液體的螺旋狀運動，尤指把附近各種東西吸向其中心的螺旋水流或空氣Numerical simulation by cfd was carried out to understand the hot current behavior in a tunnel with longitudinal ventilation. it becomes clear that fire source modeling is very important because the hot current behavior is strongly affected by the fire source position and is sensitive to methods in the modeling of the fire source. the flame area which has developed from the fire source is an area of chemical reaction caused by combustion. even if grids in the vicinity of the fire source are made fine, it was difficult to simulate the heat generation area with consideration to this chemical reaction through using a method for setting the heat release rate simply on the fire source surface. therefore, we proposed a method adopting the knowledge on flame shape under the longitudinal ventilation and incorporating it into numerical simulation and it showed a good agreement with the experimental results. it was shown through experiments in a tunnel with longitudinal ventilation that the hot current developed toward the tunnel center downwind from the fire source near a wall. the cause was investigated by numerical simulation and it became clear from the results that the spiral air by the fire plume created a vortex in the crevice between the wall and the plume
運用cfd進行數字模擬，以了解縱向通風隧道內熱煙氣流的特性.通過模擬發現對火源進行模擬非常重要，熱煙氣流特性受火源位置的影響很大，並且對火源模擬方法很敏感.火源生成的火焰區是燃燒引起的化學反應區域.即使火源附近的木垛排列完好，也很難在考慮這些化學反應條件下模擬熱生成區域.建議考慮縱向通風隧道內火焰形狀並對它進行數字模擬.模擬結果與試驗結果非常吻合.試驗證明，在縱向通風隧道內，熱煙氣流從靠近墻體火源處順風向隧道中心蔓延.數字模擬結果發現，火災羽流造成的螺旋上升空氣會在墻體和羽流之間形成一個渦流區Abstract : numerical simulation by cfd was carried out to understand the hot current behavior in a tunnel with longitudinal ventilation. it becomes clear that fire source modeling is very important because the hot current behavior is strongly affected by the fire source position and is sensitive to methods in the modeling of the fire source. the flame area which has developed from the fire source is an area of chemical reaction caused by combustion. even if grids in the vicinity of the fire source are made fine, it was difficult to simulate the heat generation area with consideration to this chemical reaction through using a method for setting the heat release rate simply on the fire source surface. therefore, we proposed a method adopting the knowledge on flame shape under the longitudinal ventilation and incorporating it into numerical simulation and it showed a good agreement with the experimental results. it was shown through experiments in a tunnel with longitudinal ventilation that the hot current developed toward the tunnel center downwind from the fire source near a wall. the cause was investigated by numerical simulation and it became clear from the results that the spiral air by the fire plume created a vortex in the crevice between the wall and the plume
文摘:運用cfd進行數字模擬，以了解縱向通風隧道內熱煙氣流的特性.通過模擬發現對火源進行模擬非常重要，熱煙氣流特性受火源位置的影響很大，並且對火源模擬方法很敏感.火源生成的火焰區是燃燒引起的化學反應區域.即使火源附近的木垛排列完好，也很難在考慮這些化學反應條件下模擬熱生成區域.建議考慮縱向通風隧道內火焰形狀並對它進行數字模擬.模擬結果與試驗結果非常吻合.試驗證明，在縱向通風隧道內，熱煙氣流從靠近墻體火源處順風向隧道中心蔓延.數字模擬結果發現，火災羽流造成的螺旋上升空氣會在墻體和羽流之間形成一個渦流區The two wall jets collide with each other and turn upward to form an upwash fountain which increases the lift force of the upper plate
包圍在噴射流與噴泉流附近的流體會被其帶入而在周圍形成數個渦流。By solving the 2 - d viscous navier - stocks equation, the flow field of the microjet was simulated. the results clearly reveal the features of microjet and the process of vortex pairs ? formation, advection, diffusion and entrainment effection on ambient fluid
結果清晰的反映了作動器出口附近微射流場的形態，同時也再現了此區域內旋渦對的生成、遷移和擴散過程以及微射流對周圍流體的卷吸作用。The result shows that two clear vortexes exist in the cyclone, strong swirling vortex round the exit pipe and weak one near back wall of the half - tilted cone
結果表明，在分離器內部有兩個較為明顯的旋渦，位於排氣管附近的為強旋渦，位於半斜錐體後壁處有一弱旋渦。The investigated performance characteristics of lateral jet interaction include pressure fields, flow field pattern and surface pressure distribution with jet on or off in the streamwise direction. 2
本論文設計的計算程序具有模擬物體表面存在大壓力剃度和激波與湍流附面層存在強烈干擾情況下的復雜渦流場計算的能力。分享友人