降低真空的 的英文怎麼說

中文拼音 [jiàngzhēnkōngde]
降低真空的 英文
vacuum-reduced
  • : 降動詞1. (投降) surrender; capitulate 2. (降伏) subdue; vanquish; tame
  • : Ⅰ形容詞(真實) true; genuine; real Ⅱ副詞1 (的確; 實在) really; truly; indeed 2 (清楚確實) cl...
  • : 空Ⅰ形容詞(不包含什麼; 裏面沒有東西或沒有內容; 不切實際的) empty; hollow; void Ⅱ名詞1 (天空) s...
  • : 4次方是 The fourth power of 2 is direction
  • 降低 : reduce; cut down; abate; debase; drop; lower; lessening; reducing; reduction; depression; tarnish
  • 真空 : [物理學] vacuum; empty space; vacuo
  1. Both oxyopes sertatus and harpactor fuscipes are important predators of common cutworm ( spodoptera litura ) on tobacco. the effect of several interference factors on the predations of o. sertatus and h. fuscipes on the larvae of s. litura were examined in laboratory. the results indicated that there were significant mutual interferences on their predations with the existence of other individual in the same / different species. as the number of the predator increased, the predation rates decreased significantly. the interference coefficients ( m ) within h. fuscipes and within o. sertatus were 0. 7278 and 0. 6911, respectively, while the interference coefficient ( m ) between o. sertatus and h. fuscipes was 0. 9464. these results showed that the effect of mutual interference on predation in interspecies was more obvious than that in intraspecies. the number of prey captured and the predation rate of predator dropped with increasing the number of tobacco stalks. this result suggested that spatial heterogeneity was also an important factor affecting the predation of predator on prey

    斜紋貓蛛和紅彩獵蝽均是煙草上斜紋夜蛾重要捕食性天敵.室內測定幾種干擾因素對斜紋貓蛛和紅彩獵蝽捕食作用影響,結果表明這些干擾因素對斜紋貓蛛種內、紅彩獵蝽種內和兩種捕食者種間捕食作用均有明顯干擾作用,隨捕食者數量增加,其對斜紋夜蛾捕食作用率顯著.斜紋貓蛛種內干擾系數和紅彩獵蝽種內干擾系數分別為0 . 7278和0 . 6911 ,而兩者種間干擾系數為0 . 9464 ,說明兩者種間干擾作用要明顯高於同一種捕食者種內干擾作用.兩種捕食性天敵對斜紋夜蛾捕食量和捕食作用率隨煙草莖桿數增加而,表明間異質性同樣是影響兩種捕食性天敵捕食作用一個重要因素
  2. At the appropriate pressure, the chamber is opened to a high-vacuum pumping system that continues to reduce the pressure of the process chamber.

    在適當壓強下,工藝室被接通高泵系統抽氣,以繼續工藝室壓強。
  3. Since solder balls do oxidize quickly and builds an oxide coat that reduces the soldering characteristic of the ball, the chips should be vacuum sealed shortly after the reball process

    因為很容易氧化並且形成一個氧化層覆蓋會錫球焊接特性,所以在重新植球加工后應盡快封裝。
  4. The salt water is passed through a series of chambers which have progressively higher vacuums and lower temperatures.

    鹹水流過一系列程度逐漸增高,溫度逐漸蒸餾室。
  5. Abstract : “ high pressure oil shock ” has been found to be the major source of shock noises in the rotary piston vacuum pumps. recently, we found that the oil shock may shift forward. here, the high pressure oil - shock and the formation mechanism of three other types of shock were analyzed so as to reduce the vacuum pump noises

    文摘: 「高速油液沖擊」是滑閥泵沖擊噪聲主要激勵源,通過試驗發現了這一沖擊前移現象,並進一步分析了高速油液沖擊和其他三種沖擊形式,為滑閥泵噪聲提供了可靠依據。
  6. The results showed that the microstructure of as - deposited tbdyfe ii 1ms were amorphous and the crystal of tbfe2 were found in films after annealing at 500. annealing films in vaccum could improve the saturation magnetization ms and the susceptibility, decrease the coercivity and the saturaion field, and make the direction of the magnetic moments parallel to the film plane

    結果表明,制備態薄膜為非晶態結構,經過500退火熱處理后,薄膜出現了tbfe _ 2結晶物,薄膜矯頑力和外場飽和磁場大大,飽和磁化強度增強,初始磁化率提高,易磁化軸轉向膜面。
  7. X - ray diffraction results revealed that the structure of as - deposited smco film was amorphous and crystallization happened after the films annealed at 500 in vacuum. the magnetic tests of smco thin films showed that its coercivity reduced with the increase of film ' s thickness while the ratio of mr / ms was opposite. the films " coercivity and mr / ms declined after it annealed at 500 because the machanism of magnetization were changed from domain wall nailing into magnetic nuclear forming

    研究結果表明,由於雜質fe摻入了smco薄膜磁性能;制備態smco薄膜為非晶態結構,矯頑力hc隨著薄膜厚度增加而減小,剩磁比mr ms隨膜厚增加而增加;經過500退火熱處理后,薄膜出現smcos結晶物,矯頑力hc, mr ms減小,磁化機制由疇壁釘扎類模型轉為形核類模型。
  8. By improving surface condition of parts and one shot seal - off clean room grade, using ultrasonic vapor phase cleaning process, the inner parts of vacuum interrupter get cleaner. movable particles have been diminished by automatic current ageing, power frequency hi - voltage ageing and dynamic high current ageing. as the dielectric strength of clearance in vacuum interrupter improved, the probability of re - ignition in test drops evidently

    通過提高零件表面加工質量,改善一次封排間衛生條件、制定合理超聲波氣相清洗工藝提高管內潔凈度,採用自動電流老煉、超高壓工頻老煉、大電流動態老煉等工藝進一步消除滅弧室內活動性微粒,可提高滅弧室間隙介質強度,使開關投切電容器組重燃率大大,並通過實驗驗證開關投切電容器組重燃率在製造工藝改進後由原來10 . 7 %至1 . 3 % 。
  9. The experiment took water as the medium and experiments on two jet modes were carried out under the falling film vacuum evaporating. the experimental results indicated that the two ejectors in series compensation method could adjust the variational work situation due to the decrease of primary steam or secondary steam and insure the normal production. at the same time, the ejector ' s best work situation founded in the experiment would provide reference for ejector ' s design and usage

    本實驗建立了一套蒸發裝置,以水為介質,對變工況下單級和串聯噴射熱泵蒸發進行了實驗,結果表明兩級串聯補償噴射裝置能對由引射蒸汽和工組蒸汽壓力所造成混合蒸汽壓力進行調節,達到了變工況下正常生產
  10. The bigger no. 5 6 high pressure heater ' s difference temperature is another factor. the paper detaily analysed the reasons that turbine ' s relative intra - efficiency and condenser ' s vacuum lowering and no. 5, 6 high pressure heater ' s difference temperature rising. it using the thermal system equal quantity analysis method, calculated the value that turbine unit thermal efficiency had been lowered

    論文中對汽輪機相對內效率、凝汽器於設計值以及# 5 、 6高壓加熱器上、下端差大於設計值原因進行了詳細分析,並將各因素對整個熱力系統效率影響程度進行了定量分析和計算。
  11. This paper based on the result of thermal system test of no. 2 turbine unit in liancheng power station. using compare method and thermal system equal quantity analysis method, analysed the factor lowering turbine unit thermal efficiency. in this, the lower turbine ' s relative intra - efficiency is main factor

    其中,汽輪機相對內效率較設計值是影響汽輪機組熱力系統效率主要因素;凝汽器於設計值是影響汽輪機組熱力系統效率第二位因素; # 5 、 6高壓加熱器上、下端差大於設計值是影響汽輪機組回熱系統效率又一重要因素。
  12. Assists to fix the equipment problems in the vacuum coating areas, to minimize the break down time

    協助解決鍍膜區設備故障,最大限度壞機時間。
  13. Test method for characterizing a combination of properties of planar surfaces to a technical level by a vacuum hold - down technique

    技術表徵達到一定技術水平平面綜合特性方法
  14. Results of vmd experiments indicate that flux increases when feed temperature, feed rate and vacuum degree increase. but the increase of flux becomes slowly when feed rate reaches 60l. h - 1 ; flux increases with pore size rapidly, but rejection approaches zero when pore size reaches 0. 5m

    實驗表明,隨進料溫度、進料流速、冷側增大,膜通量增大;但進料流速增大到60l . h - 1之後,通量隨進料流速增長變緩;膜通量隨孔徑較快地增大,但當膜平均孔徑達到0 . 5m時,截留率迅速,已無實際意義。
  15. In this paper, the development of vacuum freeze drying technology is reviewed and the importance and necessity of decreasing drying time and reducing energy consumption are expounded in detail

    本文首先在綜述冷凍乾燥技術發展現狀基礎上,闡述了凍干能耗和縮短凍干時間必要性和重要性。
  16. This paper has studied the structure of the one - sixth turn axial magnetic field of the cup vacuum interrupter with iron core and distribution of the axial magnetic field. the axial magnetic field reduces loss of radial energy of arc post plasma, and makes the arc voltage reduce

    本文著重研究了帶鐵芯1 / 6匝杯狀縱磁滅弧室結構以及縱向磁場分佈,縱向磁場引入了弧柱等離子體徑向能量損失,使電弧電壓
  17. The principle, the structure, the prevention of back - streaming of pump oil, the reducing noises, the designs and the calculations of the pump are described in detail in order to systimatically understand, correctly use and reasonablly maintain the sliding vane rotary pump to benefit enterprises

    作者從該泵原理、結構、防止返油、噪音以及設計計算等諸多方面進行了詳細論述,其目在於使廣大用戶對旋片泵有一個比較系統了解,從而正確使用和合理維修旋片泵將給企業帶來可觀經濟效益和社會效益。
  18. It is very important to reduce the vibration of the vacuum pump for keeping its quality and lengthening its service life

    摘要滑閥式振動對提高泵質量、延長泵壽命有著重要意義。
  19. Comparison research verifies its effectiveness on reducing the de - link losses and improving the output performance. the three topologies mentioned above are all presented with detailed theoretical analysis, parameters design, simulation and experimental verifications. a 6kw three - phase inverter system is accomplished in order to verify that the two - amplitude control technique is fit for high power application

    第五章研究三相逆變系統雙幅諧振直流環節技術,完成了6kw實驗系統,提出了滯環電流控制與間矢量調制相結合方案( hcc - svm )並首次採用cpld實現邏輯控制,大大了逆變器換流頻率,縮短了控制延時,實現了逆變器高效變換和輸出失
  20. Eg vacuum system will not generate the waste water

    使用eg系統可以大大廢水排放
分享友人