陶瓷粉末 的英文怎麼說

中文拼音 [táocífěnmò]
陶瓷粉末 英文
ceramic powder
  • 陶 : 陶名詞1. （窯） kiln2. （人名用字） a word used in person's name
  • 瓷 : 名詞（用高嶺土、長石、石英等燒製成的材料） porcelain; china
  • 粉 : Ⅰ名詞1 （粉末） powder 2 （用澱粉製成的粉條或粉絲） noodles or vermicelli made from bean potato o...
  • 末 : Ⅰ名詞1 （東西的梢;盡頭） tip; terminal; end 2 （非根本、非重要的事物） nonessentials; minor detai...
  • 陶瓷 : pottery and porcelain; ceramics陶瓷地磚 floor tile; 陶瓷電子管 ceramic tube; 陶瓷電阻器 ceramic r...
  • 粉末 : powder; flour; stive; smalls
  1. Test methods for bulk density of fine ceramic powder

    細陶瓷粉末的體密度測試方法
  2. The first utilizes a blend of finely ground ceramic powders.

    第一種用的是一種磨細的陶瓷粉末混合物。
  3. Abstract : the base principle, key technology, characteristic and progress on synthesis of ceramic powders by solid - state metathesis reactions are described

    文摘:本文扼要地介紹了固態復分解反應法制備陶瓷粉末的基本原理、關鍵技術、特點及其研究進展。
  4. The disperse degree of the ceramic can greatly affect uniformity of the composite, which limit the poling voltage and affect the piezoelectricity. in this paper, the relationships among constitutes, microstructures, dielectric and piezoelectric properties were calculated by employing the banno unit cell mode ; pzt ceramic were synthesized by the hydrothermal method and the appropriate solution was selected according the adsorption of pvdf on the ceramic particle surface ; then, relationships between the disperse degree and the fabrication process were studied. base on these, the pzt / pvdf composites intermingled some pan were prepared and the microstructures were investigated

    論文首先利用bannounitcell模型，計算了pzt pvdf壓電復合材料的組成、結構、與其壓電和介電等性能之間的關系；針對壓電復合材料存在的均勻分散性差的缺點，選用水熱法制備的粒度均勻的pzt陶瓷粉末，並採用溶液混和法與聚合物pvdf進行分散復合，重點研究了不同工藝條件下陶瓷的均勻分散性及其與材料微觀結構之間的關系。
  5. Advanced technical ceramics. methods of test for ceramic powders. part 8 : determination of tapped bulk density

    高級陶瓷.陶瓷粉末試驗方法.第8部分:振實堆積密度測定
  6. Advanced technical ceramics. methods of test for ceramic powders. part 9 : determination of untamped bulk density

    高級陶瓷.陶瓷粉末的試驗方法.第9部分:非搗實堆積密度測定
  7. Test method for precision electroformed wet sieve analysis of nonplastic ceramic powders

    非塑性陶瓷粉末的精密電鑄濕篩分析的試驗方法
  8. Advanced technical ceramics. methods of test for ceramic powders. part 1 : determination of impurities in alumina

    高技術陶瓷.陶瓷粉末的試驗方法.第1部分:釩土中雜質的測定
  9. Processing of srbi4ti4o15 powder by molten salt synthesis method

    15片狀鐵電陶瓷粉末
  10. Using continuous compacting progress dy2o3 / zro2 materials can be sintered at low temperature. 98. 8 % of theory density was obtained for ultrafine dy2o3 / zro2 ceramic power sintering at 1200, which is 400 lower than the sintering temperature of the common ceramic power. it studied the influence of sintering temperature on the crystalline grain of power by sem

    採用二次成型常壓燒結法對氧化鋯/氧化鏑的納米粉體進行燒結，在1200左右燒結得到燒結密度為理論密度的98 . 8的陶瓷體，其燒結溫度比常規陶瓷粉末的燒結溫度低四百度左右，通過掃描電鏡研究了燒結溫度對燒結體晶粒大小的影響。
  11. The best parameters of electroless plating were observed. results demonstrated that by utilizing the ultrasonic into the electroless plating, the reaction can reacted in lower temperature and the self - decomposition of the solution can be prevented

    對陶瓷粉末化學鍍鈷法制備金屬陶瓷復合粉末的研究表明：通過在粉體化學鍍中引入超聲波，使得反應可以在較低溫度下進行，防止了鍍液的自分解。
  12. Advanced technical ceramics - methods of test for ceramic powders - chemical analysis of zirconia

    高技術陶瓷.陶瓷粉末的檢驗方法.氧化鋯的化學分析
  13. Advanced technical ceramics - methods of test for ceramic powders - part 12 : chemical analysis of zirconia

    高技術陶瓷.陶瓷粉末的試驗方法.第12部分:鋯氧土的化學分析
  14. Advanced technical ceramics - ceramic powders - determination of crystalline phases in zirconia ; german version env 14273 : 2002

    高技術陶瓷.陶瓷粉末.氧化鋯結晶相的測定;德文版本
  15. To obtain the ultra fine atc ceramic with fine, uniform grain and high mechanical properties and solve the problem of brittle of ceramic, the technique of electroless cobalt plating under low temperature and ultrasonic was used to get a cobalt deposition on nano / micro al2o3, tic ceramic. the nano / micro al2o3 - tic - co composite powder with different cobalt content was prepared by changing the load. the composite powder was then hot - pressed into a ultra fine composite ceramic

    為了得到品粒細小、均勻，力學性能優異的co - al _ 2o _ 3 - tic （ atc ）復合陶瓷，解決陶瓷的脆性問題，本文在化學鍍鈷制備高性能atc復合陶瓷的基礎上，採用超聲波化學鍍方法，以提高鈷在陶瓷粉末以及al _ 2o _ 3與tic陶瓷顆粒之間的分佈均勻性，以期進一步提高atc陶瓷的力學性能。
  16. Advanced technical ceramics - methods of test for ceramic powders - determination of untapped bulk density

    高級工業陶瓷.陶瓷粉末的試驗方法.未夯實的體積密度的測定
  17. Standard test method for wire - cloth sieve analysis of nonplastic ceramic powders

    非塑性陶瓷粉末的金屬絲篩分析的標準試驗方法
  18. By using the method of burning, we fabricated the ceramic powder of al2o3, and discussed the effect of mole percentage of metal ions and urea on forming phases of al2o3. we calculated the x - ray powder diffraction by scherrer formula, and we thought that the ceramic powder reaches nano order

    採用燃燒法制備了al _ 2o _ 3陶瓷粉末，討論了金屬離子和尿素的摩爾比對al _ 2o _ 3成相的影響；對其x射線粉末衍射數據用scherrer公式計算得出所得al _ 2o _ 3陶瓷粉末已達到納米量級。
  19. Measuring methods for the specific surface area of fine ceramic powders by gas adsorption using the bet method

    Bet法進行氣體吸附測定細陶瓷粉末表面積的方法
  20. Testing methods for particle density of fine ceramic powder

    細陶瓷粉末顆粒密度的測試方法
分享友人
分享到 Line

分享到臉書