陶瓷粉 的英文怎麼說

中文拼音 [táocífěn]
陶瓷粉 英文
ceramic powder
  • 陶 : 陶名詞1. （窯） kiln2. （人名用字） a word used in person's name
  • 瓷 : 名詞（用高嶺土、長石、石英等燒製成的材料） porcelain; china
  • 粉 : Ⅰ名詞1 （粉末） powder 2 （用澱粉製成的粉條或粉絲） noodles or vermicelli made from bean potato o...
  • 陶瓷 : pottery and porcelain; ceramics陶瓷地磚 floor tile; 陶瓷電子管 ceramic tube; 陶瓷電阻器 ceramic r...
  1. Test methods for bulk density of fine ceramic powder

    細陶瓷粉末的體密度測試方法
  2. The first utilizes a blend of finely ground ceramic powders.

    第一種用的是一種磨細的陶瓷粉末混合物。
  3. Abstract : the base principle, key technology, characteristic and progress on synthesis of ceramic powders by solid - state metathesis reactions are described

    文摘:本文扼要地介紹了固態復分解反應法制備陶瓷粉末的基本原理、關鍵技術、特點及其研究進展。
  4. The disperse degree of the ceramic can greatly affect uniformity of the composite, which limit the poling voltage and affect the piezoelectricity. in this paper, the relationships among constitutes, microstructures, dielectric and piezoelectric properties were calculated by employing the banno unit cell mode ; pzt ceramic were synthesized by the hydrothermal method and the appropriate solution was selected according the adsorption of pvdf on the ceramic particle surface ; then, relationships between the disperse degree and the fabrication process were studied. base on these, the pzt / pvdf composites intermingled some pan were prepared and the microstructures were investigated

    論文首先利用bannounitcell模型，計算了pzt pvdf壓電復合材料的組成、結構、與其壓電和介電等性能之間的關系；針對壓電復合材料存在的均勻分散性差的缺點，選用水熱法制備的粒度均勻的pzt陶瓷粉末，並採用溶液混和法與聚合物pvdf進行分散復合，重點研究了不同工藝條件下陶瓷的均勻分散性及其與材料微觀結構之間的關系。
  5. Advanced technical ceramics. methods of test for ceramic powders. part 8 : determination of tapped bulk density

    高級陶瓷.陶瓷粉末試驗方法.第8部分:振實堆積密度測定
  6. Advanced technical ceramics. methods of test for ceramic powders. part 9 : determination of untamped bulk density

    高級陶瓷.陶瓷粉末的試驗方法.第9部分:非搗實堆積密度測定
  7. Test method for precision electroformed wet sieve analysis of nonplastic ceramic powders

    非塑性陶瓷粉末的精密電鑄濕篩分析的試驗方法
  8. Advanced technical ceramics - methods of test for ceramic powders - determination of the densification on natural sintering

    高技術陶瓷.陶瓷粉試驗方法.自然燒結的緻密化測定
  9. Advanced technical ceramics. methods of test for ceramic powders. part 1 : determination of impurities in alumina

    高技術陶瓷.陶瓷粉末的試驗方法.第1部分:釩土中雜質的測定
  10. Processing of srbi4ti4o15 powder by molten salt synthesis method

    15片狀鐵電陶瓷粉末
  11. Using continuous compacting progress dy2o3 / zro2 materials can be sintered at low temperature. 98. 8 % of theory density was obtained for ultrafine dy2o3 / zro2 ceramic power sintering at 1200, which is 400 lower than the sintering temperature of the common ceramic power. it studied the influence of sintering temperature on the crystalline grain of power by sem

    採用二次成型常壓燒結法對氧化鋯/氧化鏑的納米粉體進行燒結，在1200左右燒結得到燒結密度為理論密度的98 . 8的陶瓷體，其燒結溫度比常規陶瓷粉末的燒結溫度低四百度左右，通過掃描電鏡研究了燒結溫度對燒結體晶粒大小的影響。
  12. After adding 0. 12 volume fraction of pt powder, the pyroelectric coefficient of pt / p ( vdf - trfe ) composite film was about 30 % higher and the detective merit was about 21 % higher than that of sensors using pure p ( vdf - trfe )

    12的鈦酸鉛納米陶瓷粉粒的摻入，使得pt / p （ vdf - trfe ）復合膜的熱釋電系數值提高了約30 ，探測優值提高了約21 。
  13. In this paper, we tried to get metal - coated composite powders with different particle sizes by electroless silver plating on different ceramic powders such as nano - al2o3, micro - cenospheres and submirco - sio2. the nano - al2o3 powder with average size about 10 to 20 nanometers was pretreated to produce catalytic activity before the electroless silver plating

    本文利用化學鍍的方法在不同粒徑的陶瓷粉體（包括納米al _ 2o _ 3 、微米空心玻璃微珠及亞微米級的sio _ 2 ）上包覆金屬銀，制備不同粒徑的金屬包覆型復合粉體。
  14. Advanced technical ceramics - methods of test for ceramic powders - determination of impurities in alumina

    高技術陶瓷.陶瓷粉的試驗方法.氧化鋁的純度測定
  15. The best parameters of electroless plating were observed. results demonstrated that by utilizing the ultrasonic into the electroless plating, the reaction can reacted in lower temperature and the self - decomposition of the solution can be prevented

    對陶瓷粉末化學鍍鈷法制備金屬陶瓷復合粉末的研究表明：通過在粉體化學鍍中引入超聲波，使得反應可以在較低溫度下進行，防止了鍍液的自分解。
  16. The objective of this paper is to obtain metal - ceramic composite materials with better complex properties by the way of preparing nano - composite powders of metal and ceramic. in our thought, firstly we should prepare nano - ceramic powders coated with metal, and then during the period of sintering, the film of metal could prevent the nano ceramics powder from dumpling and keep the powders to be nano - sized

    這樣，在隨后制備塊材的燒結過程中，由於復合粉體復合充分，相容性提高，結合力高，另外金屬表面層可抑制納米陶瓷粉體的融合長大，使粉體在燒結后保持納米尺寸，從而發揮納米顆粒的作用；同時通過引入均勻分佈的韌性金屬相，進一步改善陶瓷的脆性。
  17. Advanced technical ceramics - methods of test for ceramic powders - chemical analysis of zirconia

    高技術陶瓷.陶瓷粉末的檢驗方法.氧化鋯的化學分析
  18. Advanced technical ceramics - methods of test for ceramic powders - part 12 : chemical analysis of zirconia

    高技術陶瓷.陶瓷粉末的試驗方法.第12部分:鋯氧土的化學分析
  19. The technique of producing the tiny ceramic powders by ultrasonic atomizer

    超聲霧化制備超細氧化鋁陶瓷粉體技術
  20. Advanced technical ceramics - ceramic powders - determination of crystalline phases in zirconia ; german version env 14273 : 2002

    高技術陶瓷.陶瓷粉末.氧化鋯結晶相的測定;德文版本
分享友人
分享到 Line

分享到臉書