隨機誤差 的英文怎麼說

中文拼音 [suíjīwùchā]
隨機誤差 英文
accidental error
  • 隨 : Ⅰ動詞1 （跟; 跟隨） follow 2 （順從） comply with; adapt to 3 （任憑; 由著） let （sb do as he li...
  • 機 : machineengine
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 隨機 : random stochasticrandom
  • 誤差 : error
  1. Application of standard error of the random sample

    隨機誤差的標準差及其應用
  2. This paper also points out the consistency that can be generalized more than one dimension. so, we achieve the large sample property - consistency of this class of model on the fixed design. in this paper, for fixed design points xi ; under the assumption that the unknown function g is continuous function and the moment of random error exists and is finity, we discuss and show that the estimators n, gn and n2 for, g and 2 have strong consistency, p th - mean consistency for more general nonparametric weighted fuction

    本論文在x ；是固定設計的情況下，假定未知函數9 （ ? ）連續，對非參數權函數的條件更為一般和基本，並對隨機誤差e ；的矩的要求有限，討論並證明了在這些條件下， p ； g （ ? ）的估計量札lin （ ? ）及誤差方差a 』的估計量枯相合性和叭三2 ）階平均相合性
  3. Firstly, the mathematical method, wavelet transform of random error processing and kalman filtering algorithm of system error estimation, is designated ; the process of development of wavelet transform and its present research is recommended ; and, the definition and development situation of real - time data processing and post - flight data processing of trajectory measurement data is summarized briefly

    首先指出了應用的數學方法，即處理隨機誤差的小波變換方法和估計系統誤差的kalman濾波演算法;介紹了小波變換方法的發展過程和國內外的研究現狀;綜述了彈道測量數據的實時數據處理和事後數據處理的概念和發展狀況。
  4. The influence of observational error on statistical inference is discussed and the method to diminish the impact of stochastic error is given

    摘要討論了觀測誤差對某些統計推斷的影響，給出了減小隨機誤差影響的方法。
  5. Analyze item by item the position of unintact cycle, the running clearance of unintact cycle, locking - deform, datum dimension regulating, repeatly install, power voltage wave and marking running etc. at the same time, we give the calculating formula to calculating the running marking random error, and use it to calculate the system error of big diameter measure instrument - - datum dimension frame error, gyro - wheel diameter error, error caused by circumstance temperature, error caused by backing distance, angle error, delay error of data collecting circuit, lathe main shaft running error, workpiece install partial error

    對不完整圓的位置、不完整圓的轉動間隙、鎖緊變形、基準尺調整、重復安裝、電源電壓波動、標記轉動等隨機誤差進行了逐項分析，並給出轉動標記隨機誤差的計算公式。對大直徑測量儀的系統誤差?基準尺尺架誤差、滾輪直徑誤差、環境溫度引起的誤差、後退距離引起的誤差、角度誤差、數據採集電路延時誤差、車床主軸回轉誤差、工件安裝偏心誤差分別進行了計算，最後對誤差進行合成。
  6. Based on analyzing causes of formation of system error, random error and gross error, together with their influences to observation values, method that examine whether there is system error in apparatus by using temperature values of unbonded elastic wire resistance type meters is studied

    在對系統誤差、隨機誤差、過失誤差成因及對監測數據的影響分析基礎上，研究了利用差動電阻式儀器的伴測溫度測值來檢驗儀器是否存在系統誤差的方法。
  7. Effects of random errors on the sidelobe level of a module array antenna

    隨機誤差對模塊化陣列天線副瓣的影響
  8. Abstract : in this paper, the formula in the evaluation of standard uncertainty for the parameter in smooth change is derived from characteristics of random error

    文摘:根據隨機誤差的特性，推導了測量平穩變化參數時評定標準不確定度的計算公式。
  9. By analyzing the inter - satellite measurement net of walker constellation at some time in geometry and numeric, the correction of system error and random error caused by the change of orbit elements using different type of estimation of inter - satellite measurement net was provided quantitatively

    並通過對walker星座某一時刻的星間觀測網進行幾何分析和數值分析，定量給出了利用不同類型的星間觀測網對軌道根數變化引起的系統誤差和隨機誤差的修正情況。
  10. But the most common noise is angle random walk, bias instability, rate random walk, rate ramp and quantization noise. in this paper, the random error model including the most common five noise as above

    對常見的五種噪聲因素包括角度隨機遊走、零偏穩定性、速率隨機遊走、速率斜坡和量化噪聲建立了陀螺隨機誤差模型。
  11. Then, we use a simulation method to create a large number of radar measurement values, produce a quantity of random numbers using computer software and add them to the radar measurement values, we use kallman filtering method to calculate the location, velocity and trajectory coefficient of the target at the moment of the final tracking point, and use the numerical solving method of differential equation to calculate the trajectory, the location of the hostile artillery or the impact point of its own projectiles, finally, we calculate statistically the random error of the tracking system and analyze the location accuracy

    然後採用模擬模擬方法獲得大量的雷達測量值，由計算機軟體產生大量的隨機數，加入雷達測量值中，用卡爾曼濾波法計算出最後跟蹤點時刻的目標位置、速度和彈道系數，再用微分方程數值解法計算出整個彈道軌跡、計算出敵方炮位的位置或己方炮彈的落點，最後統計出跟蹤系統的隨機誤差，分析定位精度。
  12. When there is random error in input data, if position - keeping plan is applied, thrusters will change working status in high frequency that will lead to sever thrust wear and energy waste

    當輸入存在隨機誤差的情況下，採用常規的定點定位控制方法會導致推進器頻繁改變狀態，造成不必要的機械磨損，浪費很大的能量。
  13. One dimension river flow roughness parameter inverse analysis kalman filter is introduced into the model to solve stochastic error in observed data. applying kalman filter automatism revising system, dynamic roughness course is obtained. using dynamic roughness course the model result precision is improved, it is more consistent with observed data

    對於一維河道糙率參數反分析，針對觀測資料存在的隨機誤差，引進卡爾曼濾波器的自動校正系統，求解出河道糙率變化的動態過程，使用動態糙率計算，明顯改善模型的模擬精度，使模擬過程和觀測過程很好吻合。
  14. Statistics characteristics of random error are analyzed by wavelet transform method

    應用小波變換方法對隨機誤差進行統計特性分析。
  15. The distortion resulting from antenna ' s deadweight results that the fact surface departures the theoretical surface regularly. at the same time, because of moulding and weld fault, the measurement data departures the theoretical surface randomly. the process of the data processing is composed of three steps

    雷達天線處于架設狀態下，由於自重變形導致實際面形偏離理論面，造成變形系統誤差；而蒙皮表面加工及焊點接觸不良則造成天線面的隨機誤差。
  16. Focusing on a tuning fork vibratory gyroscope fabricated through silicon bulk micromachining, the matrix perturbation technology in the random finite element method was introduced to analyze the statistical characteristics of the natural frequencies and output capacitance of tuning fork vibratory gyroscope

    摘要以一種通過體微機械加工技術制備的音叉振動式微機械陀螺為對象，基於隨機攝動技術定量計算了微陀螺固有頻率變異和檢測輸出電容變異的統計特徵，以概率思想表達了微陀螺批量加工過程所帶來的材料尺寸隨機誤差對其性能的影響。
  17. Aees employs the multi - staged digital filter algorithm to reduce random error. meanwile, the system correct zero deviation through linear opreation. the instrument, from hardware aspect increases the feature of anti - interference by the way of reasonable layout, sepration of digital and analogue

    系統採用了中值濾波和滑動平均濾波相結合的多級數字濾波演算法來減小隨機誤差，並以精密基準電壓作為比較信號的輸入，由智能系統通過線性運算，實時地修正、校準測量數據，減小系統的零漂，實現自動定標並提高測量的精度。
  18. The allan variance ( av ) analysis method is used to evaluate the hrg signal. the result indicates that the main random error of hrg is angle random walk ( arw )

    論文採用allan方差法對半球諧振陀螺的信號進行隨機誤差分析，分析結果表明，半球諧振陀螺的角度隨機遊走誤差是陀螺隨機誤差的主要部分。
  19. This paper will deeply and systemically analyze the effect of random error on the location accuracy of the artillery target - search and gun - pointing adjustment radar by using simulation method, present an approach to increase the location accuracy

    本文以模擬模擬的方法深入系統地分析了隨機誤差對炮位偵察校射雷達定位精度的影響，並提出了提高定位精度的途徑。
  20. Data rectification is a modern technique to improve the quality of measurement data, and its main purpose is to eliminate the random errors and gross errors included in original data by making use of applied statistics, identification, optimization and other techniques

    數據校正的目的就是綜合應用統計、辨識和優化技術，對實測數據進行調整，消除數據中包含的隨機誤差和顯著誤差，去掉明顯錯誤的或不可靠的測量數據，從而提高測量數據的質量。
分享友人
分享到 Line

分享到臉書