集電結 的英文怎麼說

中文拼音 [jídiànjiē]
集電結 英文
collector base junction
  • 集 : gatherassemblecollect
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  1. The collector junction biased in the reverse direction.

    集電結是反向編置。
  2. As a comparison, ba1. 03ce0. 8gd0. 2o3 - was synthesized by sol - gel method. among these samples, nonstoichiometric samples were synthesized for the first time. the research work involved : the crystal phase of the sinters were determined by xrd ; ionic conduction under different experimental atmospheres was measured by gas concentration cells ; performances of hydrogen - air fuel cells with the sinters as electrolytes and porous pt as electrodes were measured

    用粉末x射線衍射儀鑒定它們的結晶相；在（ 600 1000 ）范圍內，以燒結體作為電解質隔膜，多孔性pt黑為正、負電極， pt - rh合金網為集電極，分別組成氫濃差電池、氧濃差電池及氫?空氣燃料電池並測定了它們的性能，研究了不同氣氛下樣品的離子導電特性及影響燃料電池性能的因素。
  3. Based on the mesne layer theory, the centralized stress cantilever was designed, and the infection factors was analysed in detail. in the designing of controditional circuits, comparing with several troditional methods and the merits was integrated, a novel circuits with fewer components and higher performance was designed, and by using the micro assembly techniques, the circuits was minisized

    文中以材料力學的中性層理論為理論依據，設計了結構獨特的應力集中結構懸臂梁，並對各影響因素進行了詳細分析。在調理電路的設計中，通過對幾種傳統方案的比較，綜合了它們的優點，設計了一種元件少、性能佳的新型電路，並採用微組裝技術，實現調理電路微型化。
  4. 1 、 through the theoretical analysis and the medici simulation, according to the design directive, the structural parameters are designed comprehensively, including the dopant concentration and the depth of the emitter, the base dopant concentration and the depth ( especially the ge ratio ), the dopant concentration and the depth of the collector

    主要工作是: 1 、通過理論分析和medici模擬，綜合設計得出符合設計指標的結構參數，主要包括:發射區的摻雜濃度和厚度?基區的摻雜濃度和厚度及基區中ge的組分比?集電區的摻雜濃度和厚度。
  5. The fourth chapter : in this chapter, it introduces the hardware designing of the dsp system based on pci bus and states every module of the hardware designing : circuit of signal adjusting, filter circuit of anti - overlap, circuit of data - acquisition automatically, expanding circuit of dsp memory, circuit of voltage matching, interfaces circuit of pci etc. it also includes theoretic basis and procedure of pcb designing

    第四章介紹基於pci總線的dsp系統硬體設計。敘述了硬體設計的各個模塊：信號調理電路、抗混疊濾波電路、自動數據採集電路、 dsp存儲器擴展電路、電平匹配電路、 pci介面電路等，以及pcb設計的理論基礎和設計過程，並給出了設計和調試的結果。
  6. And the results of calculation and numerical simulation indicate, without increasing the intrinsic collector - junction area of power devices, collector - combed structure helps to raise the intrinsic heat - dissipating area and base ' s perimeter, improve heat - dissipating method of each cell of the chip, enhance the distribution uniformity of junction temperature and current of each cell of the chip, reduce the thermal resistance and raise the dissipation power pd and output power p0, fairly well relax the contradiction among frequency, out - put power and dissipation power of the devices, and further improve the devices " property against second breakdown

    而計算分析和二維數值模擬分析結果表明：梳狀集電結（基區）結構在不增加器件本徵集電結面積的條件下，增大了器件的本徵散熱面積和基區周長，改進了每個子器件單元內的散熱方式，提高了單元內結溫和電流分佈的均勻性，降低了器件的熱阻，增大了器件的耗散功率和輸出功率，較好地緩解了目前傳統結構中頻率與功率、功耗的矛盾，並有利於改善器件抗二次擊穿的性能。
  7. Like the active control, acld has a lot to be studied because there are a lot of problems such as : the constitutive equation of smart materials is very complicated ; the feedback control methods should be improved ; it is very difficult to deploy and optimize the sensors and actuators ; it is complicated to collect and feedback correctly the information of the structures without any time delay

    和主動控制結構一樣，由於壓電結構本構關系比較復雜，控制策略還有待于進一步完善，如何配置和優化傳感器以及作動器，如何準確的採集和反饋結構的信息以及控制反饋的時間滯后等問題的存在，壓電智能結構的振動控制問題還有待于進一步的研究。
  8. The processing of the three daily bulk volume clearing runs for the net settlement for stock market transactions, low - value bulk electronic payment items and paper cheques had also been smooth

    該系統每日處理三類集體結算，即股票交易凈額結算大量小額電子支付項目及支票的運作結算情況亦十分順利。
  9. This paper introduces the ways of collecting eletronic periodicals, exploiting information resources of foreign periodicals and raising utilization ratio of foreign periodicals

    因此必需從採集電子期刊，開發和利用外文文獻資源，提高文獻利用率等方面來調整改善高校圖書館外文期刊的館藏結構。
  10. Quantitatively describing the principle of protein - protein interactions and recognition in molecular level is the key point for understanding the relationship between structure and function of protein complexes and designing protein complexes, hi these interactions among proteins, electrostatic and hydrophobic interactions are the two most important ones, which let protein molecules bond systematically

    在分子水平上定量地闡明蛋白質分子之間的親合力和相互識別的機制，是正確地認識蛋白質聚集體結構和功能之間的關系併合理地設計出有用的蛋白質分子聚集體的關鍵。蛋白質分子間相互作用，其中最主要的是靜電和疏水相互作用，使蛋白質分子能有序地結合在一起。
  11. The progress of the development and the electromagnetic contactor expert system is discussed. the system is expert system applied in electrical apparatus design field, and it is an internet application built on applied eletromagnetic contactor technology - expert system technology computer technology and software engineer technology. the main design idea is to combine abundant experts " experience with the ability of analysis and discussion of computer to solve reality problem. the system can run according to contactor design parameter by user ' s input and collect corresponding knowledge from knowledge _ base, then design out contactor ' s various structure parameter, and it can analyze dynamic and static character and optimization design, and in the end all property can achieve best

    該系統是專家系統應用於電器設計領域內的一次嘗試，它是集電磁式接觸器技術、專家系統技術、計算機技術和軟體工程技術為一體的應用軟體包。其主要的設計思想是把專家的豐富經驗和計算機的分析推理能力相結合去解決實際問題。本系統可以根據用戶的設計要求輸入接觸器的設計參數，同時從知識庫中提取相應的知識，設計出接觸器的各種結構參數，並對其動靜特性進行分析計算。
  12. Experimental sample dct375 with collector - combed structure has better parameter such as icm, pq, pd and / r etc. than traditional - structure devices and overseas devices of the same kind. collector - combed structure technology opens up a new way for the further research of new high - frequency, microwave power devices

    研製出的梳狀集電結（基區）結構試驗管dct375 ，其最大電流容量、最大輸出功率、最大耗散功率以及頻率特性等電參數明顯比傳統結構器件和國外同類產品有大的提高。
  13. The main works are as the follows. in view of the contradiction among frequency, output power and dissipation power, propose deep - trench junction termination structure filling with isolated materials and collector - combed ( base - combed ) structure

    主要工作包括以下幾個方面：針對頻率與功率、功耗的矛盾，提出了絕緣深阱結終端結構和梳狀集電結（基區）結構。
  14. In this thesis two reverse - bias electrical stress methods were used to investigate the reliability of the devices. one is a typical of oc stress method with collector open and reverse - bias emitter - base junction. another one, a new technique, is fc stress method with forward - bias collector - base junction and reverse - bias emitter - base junction

    本論文採用兩種反偏電應力方法考察器件的可靠性，一種為傳統的oc應力（集電極開路，發射結反向偏置）方法，另一種為新的方法fc應力（集電結正向偏置，發射結反向偏置）方法。
  15. The assessment method integrates the series equivalent approach and minimal cut - set to evaluate the reliability of electrical distribution net which consists of mid - voltage and low - voitage net on the assumption that there are sufficient and accurate datum

    評估計算中，假設所獲得的數據和資料充足、準確，採用串聯等值法與最小割集法結合，進行包括中、低壓的供電網路的可靠性評估。
  16. Sample error probably caused from data collection circuit of rf virtual frequency spectrum analyzer instrument was emphasized, and some kinds of selectable resolution scheme were presented, then these schemes of advantages and disadvantages were compared and summarized by the way of theory analyse, matlab simulation and practice validate and so on, at last, the optimum scheme of rf virtual frequency analyzer instrument was decided and adopted

    重點對虛擬射頻頻譜分析儀中的數據採集電路可能造成的采樣誤差進行了分析，提出了幾種可供選擇的解決方案，經過理論分析、 matlab模擬和實際驗證等手段，對這幾種方案的優缺點進行了比較和總結，並最終確定了其中最適合虛擬射頻頻譜分析儀的方案。
  17. In this paper, stable perylene and phthalocyanine monolayers were obtained through modifying silicon wafers by chemical reaction between organic macrocycle molecules and functional silicon surface. the surface morphology, aggregation and optical - electric properties of these monolayers were characterized by xps, ftir, uv - vis spectrum, afm, raman, xrd and surface photovoltaic spectrum

    通過紅外光譜，紫外?可見光（ uv ? vis ）吸收， x光電子能譜，激光拉曼光譜，原子力顯微鏡（ afm ） ，表面光電壓譜等表徵手段研究了單層膜的表面形貌、聚集態結構和光電性能等等。
  18. Because of its ability not only to produce two - dimensional high resolution images of the scene illuminated, but also to measure complete complex scattering matrix for each resolution cell, and to operate under all weather conditions and all the time, day and night, a polarimetric synthetic aperture radar ( sar ) is playing a more and more important role in gathering the detailed information regarding the geometric and electric structures of surfaces and covers of the earth

    極化合成孔徑雷達（ sar ）能夠通過照射場景，對場景進行二維（方位向和距離向）高分辨力成像，同時測量出每個分辨單元的復散射矩陣。由於極化合成孔徑雷達具行全天候和全氣候工作的能力，使得極化合成孔徑雷達在採集地表及其覆蓋物的物理（電結構）細節信息方面起著越來越重要的作用。
  19. 3. the multiwalled carbon nanotube ( mwcnt ) bonded by 2, 9, 16, 23 - tetra amino manganese phthalocyanine ( tamnpc ) was obtained and both its chemical and aggregated structures were characterized by means of ftir, uv - vis, tem, and xrd

    3 .成功合成了以化學鍵合方式連接的四氨基酞著錳一碳納米管分子內復合光電導材料體系，並用ftir 、 uv - vis 、 tem和xrd等手段表徵了其化學結構和聚集態結構。
  20. The system also provided smooth operation for the four daily bulk clearings - the net settlement of stock market transactions, low - value bulk electronic payment items, paper cheques and jetco items. us dollar clearing system

    此外，該系統每日提供的4類集體結算服務，即股票交易凈額結算、大量小額電子支付項目結算、支票結算及銀通項目結算，繼續運作順利。
分享友人
分享到 Line

分享到臉書