離型劑 的英文怎麼說

中文拼音 [líxíngjì]
離型劑 英文
mold release agent
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  1. The mechanical properties indicated that the improved exfoliation degree of mmts was essential for better properties of the nanocomposites, while the mechanical properties of interc alated nanocomposites were dependent on the structure of the organic modifiers 3

    有機蒙脫土層間有機物含量較高，有利於聚合物插層和mmt片層剝離分散。片層剝離分散程度大，有利於提高復合材料的力學性能；插層型復合材料的力學性能與表面活性劑分子結構有關。
  2. The alkanes are generally inert to ionic reagents.

    烷烴一般說來對離子型試劑是不活潑的。
  3. Nonionics include polyoxyethylene condensates, sucrose esters and alkyl amine oxides.

    非離子型表面活性劑有聚氧乙烯縮合物糖酯和烷基胺氧化物。
  4. Nonionic surface-active agents include polyoxyethylene condensates, sucrose esters and alkyl amine oxides.

    非離子型表面活性劑有聚氧乙烯縮合物，糖酯和烷基胺氧化物。
  5. Main ingredients : green tea essence, almond oil, mint, cationic active agent, high elastic case - hardened cells and etc

    主要成分：綠茶精華、杏仁油、薄荷、陽離子活性劑、高彈性定型因子等。
  6. Results the diagnostic accuracy of cut film with conventional ap and lateral views was 80. 5 %, the diagnostic accuracy of cine film with angulated views was 90. 0 % and the diagnostic accuracy of dsa using non - ionic contrast medium with angulated views was 96. 5 %

    結果用快速換片心血管造影設備和常規正側位元投照時的兒童先天性心臟病心血管造影診斷符合率為80 . 5 % ，用電影心血管造影設備和軸位元成角投照技術時的造影診斷符合率為90 . 0 % ，採用數字減影心血管造影設備，軸位成角投照技術和非離子型對比劑時的造影診斷符合率為96 . 5 % 。
  7. Its action site is located on the postsynaptic membrane and the biological activity of hwtx - i is located in the fifth p - turn containing lys25 and lys 27. to - conotoxin mviia is a neurotoxin belonging to one of n - type ca2 + channels inhibitors, purified from the venom of the conus marine snails, contains 25 amino acid residues with three disulfide binds. it adopts the pattern of ick and its linkage of the disulfide binds and space conformation are highly similar to hwtx - i

    -芋螺毒素mviia （ - conotoxinmviia ）是從芋螺屬（ conus ）海底蝸牛毒液中分離提純的一種活性多肽，屬于n -型ca ~ （ 2 + ）通道阻斷劑中一種，含25個氨基酸殘基，三對二硫鍵，其二硫鍵連接方式、分子的空間構象與hwtx -很相似，採取ick結構模體。
  8. This millirod system incorporates multiple components : a plga matrix ; excipient in free and complex forms ; drug in free, bound, and crystalline forms

    這個微囊系統包括多種成分： plga基質；單一和復合型賦形劑；游離、結合和結晶型藥物。
  9. It influences the miaow thiazole quinoline to lose slowly that the experiment is drawn the pharmaceutical loses slowly the factor of performance has temperature mainly, density, the membrane time in advance, and design many group ' s simulation systems for different influence of these three factors, is it is it should lose pharmaceutical to lose pharmaceutical slowly one positive pole type, lose performance is it is it form space location hinder after the membrane to absorb to come from mainly slowly slowly to appear to prove, thus isolated the carbon steel base body and corrode the medium

    實驗得出影響咪唑啉緩蝕劑緩蝕性能的因素主要有溫度，濃度，預膜時間，並針對這三個因素的不同影響設計了多組模擬體系，驗證出該緩蝕劑是一種陽極型的緩蝕劑，緩蝕性能主要來自於吸附成膜后形成空間位阻，從而隔離了碳鋼基體和腐蝕介質。
  10. As for fine - grained ta - nb mineral, the flotation is generally adopted, and effective collectors is fatty acids, arsenic acids, phosphonic acids, hydroximic acids and cationics

    對細粒鉭鈮礦，一般採用浮選，其中比較有效的捕收劑有脂肪酸類、胂酸類、膦酸類、羥肟酸類和陽離子型捕收劑。
  11. A lot of experiments have been done in the process of exploiture soft packaging li - ion battery about how to choice the rational arts and crafts. the content include : how to deal with the collector, add how much pvdf in the material, how long the material need to stirring and the right viscidity, how much condubtivity agent the electrode need, what theckness is best, choice different collectors, the degree of dryness of the electrode, theckness of pressed model, how much electrolyte will be added, placement how long after added the electrolyte, system of formation how to influnce the battery, in formation the battery need or not need preesure from outside, how to vacuumize and the optimize matching positive pole and negative pole. with these practice make sure the parameter of the positive pole should less than 90 m ; according to different vacuumize order the conduc - tivity agent in anode will be 5mass % and 9mass %, respectively, and in cathode the data is 2mass % ; every 100mah added to 0. 4 ml electrolyte ; before formation the battery should be placement 8 hours and the system of formation must be less than 0. 01c before the voltage reach to 3. 0v ; should press in outside when battery in formation ; to these batteries which capacity more than 350mah the vacuum time not excess 15s ; the optimize matching positive pole and negative pole between 2. 10 : 1 and 2. 15 : 1. finally make out the battery which cycling performance and security are all very well

    液態軟包裝鋰離子電池的研究主要是對關鍵工藝進行了優化設計，具體包括:集流體的處理、 pvdf的加入量、漿料攪拌時間和粘度、導電劑的加入量、電極膜的厚度、不同集流體的選擇、電極膜的乾燥程度、壓型的厚度、電解液的加入量、注入電解液后靜置時間的長短、化成制度的影響、化成時電池所具有的壓力影響、抽真空的處理、正負極活性物質的匹配。最後確定出液態軟包裝鋰離子電池最佳工藝參數:正極膜的厚度小於90 m ;根據化成時不同抽真空順序，確定正極膜中的導電劑的加入量分別為5mass %和9mass % ;負極膜中導電劑的加入量為2mass % ;電解液的加入量為每100mah添加0 . 4ml ;化成前電池的靜置時間應當大於8h ;電池在3 . 0v之前採用小於0 . 01c的化成制度;在化成過程中應當施加一定的外部壓力;對於350mah的電池抽真空的延時不應大於15s ;而正負極活性物質的質量比應當在2 . 1 : 1 2 . 15 : 1之間。
  12. Tem images revealed that the phase morphology of pls composites were influenced by the interaction among the matrix, the compatibilizer and organo - mmt. hence, a novel mesophase " " silicate sheet cluster " was also found in ldpe / eaa / mmt nanocomposite. the mechanical, barrier and thermal properties results of ldpe / mmt composites indicated that,

    對ldpe mmt納米復合材料的力學性能、透氣性能以及熱力學性能的研究結果表明，插層型或剝離型pls納米復合材料的力學性能取決于基體、相容劑在硅酸鹽片層表面的相容性。
  13. Study on the optical properties of transparent epoxy / clay nanocomposites a new type transparent epoxy based nanocomposites has been prepared by the reaction of alkylammonium exchanged montmorillonite ( amt ) with diglycidyl ether of bisphenol a ( dgeba ) and triethylamine as the curing agent. the morphology of amt in the epoxy matrix was characterized with x - ray diffraction ( xrd ), scanning electron microscopy ( sem ) and transmission electron microscopy ( tem )

    光學透明環氧樹脂粘土納米復合材料光學性能採用十八烷基伯胺鹽、十六烷基三甲基溴化胺處理na基蒙脫土製備出兩種不同的有機土，以三乙胺為固化劑，有機土與雙酚a型環氧樹脂熔融插層聚合后制備出剝離型和插層型兩種結構的環氧樹脂粘土納米復合材料。
  14. Be dealed with separating smear coat, convenient to use and no shrink

    經離型劑塗層處理方便應用，不會收縮
  15. This product is also an excellent release agent, extremely suits the plastic processing industry

    本產品同時也是優良的離型劑，非常適合運用在塑料加工業。
  16. Aozhan company concentrate on development of “ special oily agent ”, which have owned countless great accomplishment and gradually becomes taking characteristic “ anti - rust, lubrication, cleaning, cooling ” as “ silver brilliant ” series of special long - term and mid - term anti - rust agent, special mold release agent, cleaner and thimble oils and so on

    奧展公司致力於「特種油劑」的開發已碩果累累，逐步形成以「防銹、潤滑、清洗、冷卻」為特色的「銀晶」牌特效模具長期、中期防銹劑、特效離型劑、清洗劑、頂針油等系列產品。
  17. 3. to avoid the high temperature process in sige cmos technics, appropriate implantation energy and dose and rtp ( rapid thermal anneal ) are introduced into the the fabrication of sige cmos double - well and source

    3 .研究了離子注入法形成sigehcmos的雙阱及源漏工藝。確定了注入的離子類型、劑量、能量等關鍵參數。
  18. The type of formed nanocomposite was depended on the kind of curing agent used : intercalated nanocomposite was formed for curing agents of deta or mz, and exfoliated nanocomposite was obtained for curing agent of toa

    用二乙烯三胺或咪唑作固化劑時，形成插層型納米復合材料，而用桐油酸酐作固化劑時形成的是剝離型納米復合材料。
  19. It was found that exfoliation of clay occurred when the curing speed of intra - gallery was faster than that of extra - gallery even the epoxy / clay compositions were cured at any temperatures, for any time and with any types of curing agents

    研究表明，當蒙脫土層間的固化速度大於層外固化速度時，採用不同的固化劑，固化不同時間，在不同的溫度下固化都可以得到剝離型的環氧/蒙脫土納米復合材料。
  20. Curing agents and mixing conditions were two important factors that effected on exfoliation behavior of organophilic montmorillonite in diglycidylether of bisphenol a matrix. the organophilic montmorillonite was exfoliated completely and there were no d001 diffraction peaks with methyltetrahydrophthalic anhydride as curing agent and benzyldimethylanine as catalyst. properties test results show that mechmical properties, electricity properties, heat distortion temperature of the exfoliated nanocomposites were all improved by addition of the montmorillonite, and the nanocomposites had lower linear thermal expansion coefficiency and water absorption compared with neat epoxy resin

    結果表明，環氧樹脂與有機蒙脫土的相容性好；混合條件和固化劑是影響有機蒙脫土在環氧樹脂中剝離的兩個重要因素，在一定的混合條件下並選用合適的固化劑可以使蒙脫土在環氧樹脂中完全剝離；剝離型環氧樹脂蒙脫土納米復合材料的力學性能、電性能、熱性能以及吸水性能與純環氧樹脂固化物相比均有不同程度的提高和改善。
分享友人
分享到 Line

分享到臉書