離子總濃度 的英文怎麼說

中文拼音 [lízizǒngnóngdù]
離子總濃度 英文
total ionic concentration
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 子 : 子Ⅰ名詞1 （兒子） son 2 （人的通稱） person 3 （古代特指有學問的男人） ancient title of respect f...
  • 總 : Ⅰ動詞（總括; 匯集） assemble; gather; put together; sum up Ⅱ形容詞1 （全部的; 全面的） general; o...
  • 濃 : 形容詞1. （液體或氣體中所含的某種成分多; 稠密） dense; thick; concentrated 2. （程度深） （of degree or extent） great; strong
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 離子 : [物理學] ion
  • 濃度 : potency; thickness; concentration; consistence; strength; consistency; density
  1. Best concentration of ions is 1. 5mol / l and dispersant pvp monomer 0. 8mol / l. spin - coating speed, which affected the quality of limn2o4 film greatly, was also studied. it demonstrated that smooth limn2o4 film without cracks could formed under 2000 rotates / min with the solution cion = 1. 5mol / l, cpvp = 0. 8mol / l, what ’ s more, fewest spin - coating times were needed at that speed

    實驗結果表明:採用離子總濃度溶液為1 . 5mol / l ，聚乙烯吡咯烷酮單元濃度為0 . 8mol / l的溶液旋轉塗覆時，轉速在2000轉/分鐘時最佳，所得到的濕limn204薄膜平整光滑均勻，加熱后無龜裂現象。
  2. The main factors that influence the anaerobic granulation process were summarized, including inoculation seeds arid its concentration, nutrients, inorganic ions, temperature, as well as hydraulic conditions

    摘要總結了影響厭氧污泥顆粒化進程的幾種主要因素，包括接種污泥的種類和濃度，營養物的種類和濃度、無機離子、培養溫度以及水力條件等。
  3. Stationary source emissions. determination of the mass concentration of total gaseous organic carbon at low concentrations in flue gases. continuous flame ionisation detector method

    穩定源輻射.煙道低濃度氣體氣化有機碳濃縮總量的測定.連續火焰離子檢測器法
  4. In the third chapter of this thesis, the nickel electrodeposition process in leaching solution containing ammonia and chloride was summarized, and the electrochemical behaviour of nickel electrodeposition in ammonia complex bath was investigated by measuring polarization curves. the effects of total nickel, ammonia, ammonium chloride concentrations in the electrolyte as well as its anion species and temperature were studied systematically

    在第三章中首先對氨絡合物體系電積金屬鎳的工藝進行了總結，並通過極化曲線測量，對氨絡合物體系中鎳陰極電沉積電化學行為進行了研究，系統探討了溶液中總鎳離子濃度、氨水濃度、氯化銨濃度、陰離子及溫度等工藝條件對鎳陰極還原的影響，而後著重對電積鎳的反應機理進行了研究。
  5. The total rna was purified from the germ in the liquid by the guanidine isothiocyantehod method, then the total rna digested by dnase that had not rnase was used for rt - pcr. i change the magnesium ion dencity in the pcr system in order to optimize the pcr condition. at the end i selected the magnesium ion density as 1. 25 mm. the production of rt - pcr was inserted directionally into pgem ? z ( ampr ). the pgem ? z ( ampr ) was used to transform e coli jm109. i got a positive clone through culling and identificatin. the dna sequence inserted into pgem ? z ( ampr ) was sequenced and blasted with the cdna sequence of the # - mannanase mature peptide that got from genbank

    分取誘導培養液中的菌體，用異硫氰酸胍法提取總rna ，總rna再經無rna酶的dna酶處理後用于rt ? pcr 。在pcr擴增目的基因時，通過優選擴增體系，使鎂離子濃度為1 . 25mm時rt ? pcr可順利地獲得目的基因，並能定向克隆到載體pgem ? 3z （ amp ~ r ）中。用克隆載體轉化宿主大腸桿菌jm109 ，通過篩選獲取陽性克隆子，對陽性克隆子進行酶切與pcr鑒定，並對載體中插入的目的基因進行測序。
  6. Stationary source emissions - determination of the mass concentration of total gaseous organic carbon at high concentrations in flue gases from solvent using processes - continuous flame ionisation detector method

    固定源輻射.使用連續火焰離子化檢測器法測定在高濃縮時由溶劑產生的廢氣中總氣態有機碳的質量濃度
  7. The conclusion is that under the neutron and 7 - ray synthetical irradiation environment of a reactor, ionization effects of neutron on the vlsi made with cmos technology are weak, and that the displacement effects of neutron induces the decreases of mobility ratio and density of charge carrier, which causes the decrease of the total static current, so it compensates the increase of the static current caused by the synthetical ionization effects of neutron and - ray

    對試驗結果綜合分析得出：在反應堆的綜合輻照環境下，中子電離效應較弱，並且由於中子位移效應引起載流子遷移率降低和載流子濃度降低，使得總的靜態電流下降，從而抵消中子和射線綜合電離導致的靜態電流增長。
  8. Results showed that the factors include : solvent and concentration of limn204 precursor solution, spin - coating speed, heating speed, sintering temperature and time etc. in the end, techniques of sintering under vacuum conditions were studied

    主要有以下幾方面:溶液中離子總濃度以及分散劑濃度對成膜質量的影響;旋轉塗覆時轉速、熱處理的升溫速度、燒結溫度、燒結時間對薄膜晶型結構及性能的影響。
  9. Effects of sodium ion on the concentrations of aqueous total sulfur and calcium ion in wet calcium fgd process

    對液相總硫和鈣離子濃度的影響
  10. Stationary source emissions - determination of the mass concentration of total gaseous organic carbon in flue gases from solvent using processes - continuous flame ionisation detector method

    固定源排放.使用溶劑過程產生的廢氣中總的氣態有機碳物質濃度的測定.持續火焰離子化探測儀法
分享友人
分享到 Line

分享到臉書