零偏壓 的英文怎麼說

中文拼音 [língpiānyā]
零偏壓 英文
zero beat
  • 零 : Ⅰ數詞1 （零數） zero2 （數的空位） zero sign （0）; nought 3 （表示沒有數量;無） nil; nought 4 （...
  • 偏 : Ⅰ形容詞1 （不正; 歪斜） inclined to one side; slanting; leaning 2 （只側重一面） partial; prejudi...
  • 壓 : 壓構詞成分。
  1. The parts and units of jigs and fixtures. broad head clamp plate for eccentric wheel

    機床夾具零件及部件.偏心輪用寬頭壓板
  2. To resolve the situation that the sensitivity of present ground fault protection schemes is low for the large - sized hydro - generators, a kind of protection scheme based on the fault component of third - harmonic voltage and two kinds of protection scheme based on the fault component of zero - sequence voltage at the terminals and neutral are developed, and they can obtain higher sensitivity and reliability and provide 100 % protection for the stator windings. the influence of noise on the stator ground fault protection based on the local modulus maximum of wavelet transform is analyzed

    針對目前大型水輪發電機定子繞組單相接地保護靈敏度偏低的問題，通過分析單相接地故障后機端和中性點零序電壓的變化特點，提出了一種基於機端和中性點三次諧波電壓故障分量和兩種基於機端和中性點零序電壓故障分量的高靈敏度、高可靠性保護方案，並實現定子繞組的100 %保護。
  3. Influence of dc - rail zero - voltage notch on the output of the inverter is investigated, and an important conclusion is obtained that the direction of output current of the inverter is not effected by the voltage deviation produced by dc - rail zero - voltage notch, on the basis of which, a new simple correction approach is put forward. experiment results show that the proposed correction method is effective

    探索了直流母線零電壓凹槽對逆變器輸出特性的影響，得出了母線零電壓凹槽形成的輸出電壓偏差與逆變器輸出電流方向無關這一重要結論，在此基礎上，提出了一種簡便的校正新方法，通過試驗驗證了該校正方法的有效性。
  4. This thesis not only analysed the serious results of deviation of electricd pressure, which was harm for equipments and personal safety, caused by disconnection of null line, but also proposed effective protecting measure for mulfunction, such as repetition earth protecting measures and so on

    摘要分析了零線斷線造成電壓偏移而對設備和人身安全帶來的嚴重後果，提出了重復接地等有效的故障保護措施。
  5. The research results are controlled source which has linear or nonlinear variabe frequency scan function and the seismic instruments which match with it, and the method of small group intervals, small offset, much more channels, short array length, high - frequency receivers are applied during the link of data acquisition, and that the techniques of the refraction static correction, the noise suppressing, the high - resolution velocity analysis, the wavelet length compression, the wavelet zero - phase, and the prestack migration should be applied emphasizedly during the link of data processing and interpretation

    研究表明，對于城市活斷層的抗干擾高解析度淺層地震勘探，在數據採集環節應採用具有線性或非線性變頻掃描功能的可控震源和與其相匹配的地震儀器，以及小道間距、小偏移距、多接收道、短排列和高頻檢波器接收的工作方法；在數據處理與解釋環節，要重視折射靜校正技術、噪聲壓制技術、高精度速度分析技術、子波壓縮技術、子波零相位化技術和疊前偏移技術等的應用。
  6. In order to improve the quality of the voltage signals, this paper has adopted the scheme of three phases and six organs in signal - generator part, which can eliminate the errors caused by the assembly warp and the zero shift of organs. this paper also has analyzed the distribution and varying rules of the magnetic field in the signal - generator part, then based on the conclusion of the analysis improved the structure of signal - generator, which could completely eliminate the noise signal caused by the roughness of the face on the magnetic steel ring. the improvement not only met the requirement of this study, but established the theory foundation for the super - high precision magnetic encoder in future research

    因此，為提高原始電壓信號的質量，本文採用三相六元件的信號發生方案，通過差分處理濾除了由於裝配偏差和零點漂移帶來的信號誤差;本文對編碼器信號發生結構進行了磁場分析，依據磁場分析的結論對編碼器常用的信號發生結構進行了改進，改進后的結構利用積分原理在理論上能夠完全消除信號中由磁鋼環表面粗糙度引起的信號噪聲，進一步提高了信號質量，此結構不僅滿足了本課題的需要，而且為今後研製超高精度的磁電式編碼器奠定了理論基礎。
  7. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  8. For pf series chemical pump, its body, cover, impeller, and components in contact with the medium handled are all made of die stamped or injection mould pvdf or reinforced polypropylene

    Pf系列化工泵，其泵體，泵蓋，葉輪及其輸送介質接觸的零件均採用聚偏氟乙烯或增強聚丙烯模壓加工或注塑加工而成。
  9. The part of impeller and his transport medium contact all use assembling partial fluorine ethylene or strengthen the process or mould plastics that the polypropylene mould pressinges and process and becomes the pump cover his pump aspect pf ( fs ) mould chemical industry pump

    型化工泵，其泵體，泵蓋，葉輪及其輸送介質接觸的零件均採用聚偏氟乙烯或增強聚丙烯模壓加工或注塑加工而成。
  10. At present the manufacture of surface acoustic wave use the technology of the final submicron. a series of the devices of low insertion loss, high q saw rayleigh surface acoustic wave resonators or stws that insertion loss has less than 5db, load quality factor ( ql ) is more than 1000 on the quartz piezoelectric with zero of first temperature factor in the research. these difference frequencies are 60mhz, 280mhz, 739mhz and 1ghz of normal frequency and at also surface acoustic wave. using 1. 25db noise factor amplifier, careful design curcuit, good setting printed curcuit board, and using the 1ghz surface transverse wave resonator as frequency element, researching the low phase noise surface acoustic wave with sideband phase noise near ? 120dbc / hz deviating 1khz on carrier, spurious suppress with 80db

    本研究採用一階溫度系數為零的壓電石英基片上製作出損耗小於5db 、有載品值因素（ ql值）超過1000的一系列低損耗、高q值聲表面波rayleigh波或stw諧振器，頻率分別為60mhz 、 280mhz 、 739mhz和1ghz等不同頻率的高性能聲表面波諧振器。並採用噪聲系數為1 . 25db的低噪聲系數放大器，精心設計電路，優化設計布置印製電路板，用標稱頻率為1ghz的聲表面波諧振器為頻率控制元件，製作出在偏離載頻1khz處的單邊帶相位噪聲近- 120dbc / hz 、雜波抑制達80db以上的低相位噪聲聲表面波振蕩器。
  11. A topology of asymmetrical half bridge soft switching is researched in this thesis, which has inherent zero voltage switching ( zvs ) capability and thus potentially higher efficiency by its resonating of the leakage of power transformer with the parasitic capacitances of the power mosft switches, whereas it does n ' t raise the expense of the converter these studies in the thesis have been done as follows : ( 1 ) the topology of asymmetrical half bridge is introduced, and its principle and the relation of duty cycle and input voltage and output voltage discussed, the method of eliminating the deflection magnetism is also brought forward

    雖然，軟開關技術能夠實現功率變換器的小型化、模塊化等，但是，電路變得更加復雜，使得中小功率的變換器的成本增加，往往不利於商業競爭。本文研究了一種零電壓的不對稱半橋拓撲結構，它可以在不增加電路成本的基礎上，利用電路自身的特點，實現軟開關。本文所做的主要工作如下： （ 1 ）對不對稱半橋主電路工作原理進行分析，給出了占空比與輸出電壓、輸入電壓的關系以及消除變壓器偏磁的方法。
  12. For problems of vertical transport in the superlattice at fixed d. c. bias voltage, ode45 is optional. for problems of vertical transport in the superlattice with the increasing bias voltage and the relatively higher doped densities, ode15s is optional

    針對較高難度問題，即研究偏壓從零線性上升而且摻雜參數v較大時的超晶格縱向輸運問題（ du / dt （ 0 ） ，一般首選ode15s 。
分享友人
分享到 Line

分享到臉書