電凝固 的英文怎麼說

中文拼音 [diànnínggù]
電凝固 英文
diathermocoagulation
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 凝 : 動詞1. （凝結） congeal; curdle; coagulate 2. （注意力集中） fix
  • 固 : Ⅰ形容詞（結實; 牢固; 堅硬） firm; hard; solid Ⅱ副詞1 （堅決地; 堅定地） firmly; resolutely 2 [書...
  • 凝固 : solidify; solidification; coagulation; congealing;clotting; hardening; solidifying; freezing
  1. Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )

    體積電阻率的測定：當r _ v 10 ~ 8時，製成100 100 4mm板材，用zc36型高阻儀測量；當r _ v 10 ~ 8時，用dt - 9205b型數字式萬用表測試試樣的體積電阻，為了減小接觸電阻對測試的影響，採用銀導電膠將銅片粘接在試樣的兩個端面上，靜置24小時，待銀導電膠凝固，試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。
  2. In experiment, the dsc technique was used to analyze the effect of electric fields on the precipitate kinetic of al - li alloy solutionized with electric fields. the energy spectrum, tem and sem techniques are employed to investigate the elements solution, precipitates, fracture character, conductivity and vickers hardness. also, the solidification of al - cu eutectic alloy was conducted with the influence of electric fields

    在實驗上，利用dsc熱分析技術，分析了電場作用對al - li合金相析出動力學的影響；採用能譜成份檢測，透射電鏡和掃描電鏡等多種微觀檢測手段，對鋁合金的析出相，斷裂特徵、合金電導率和維氏硬度等性能在電場作用下的變化進行了系統的研究，並觀察了al - cu共晶合金在電場作用下的凝固組織。
  3. It was found experimentally that rapid solidification could speed up the peritectoid phase transformation from the metallic a - fe2sis and s - fesi to semiconducting p - fesj2

    提高- fesi _ 2相的轉變速度是- fesi _ 2基熱電材料制備技術的關鍵之一。實驗發現，快速凝固有助於加速-相轉變。
  4. On account of the solidification character of rare earth alloys, the zone melting is improved by putting the alloys prepared by arc - melting into the quartz tube, then melting

    鑒于稀土化合物凝固結晶的特點，對區熔法進行了改進，將電弧爐熔煉好的樣品裝入石英管中，封石英管后在區熔設備上進行區熔。
  5. The results show that the solidification microstructure of high speed steel fe - 2 % c - 4 % v - 4 % mo - 5 % cr - x % w ( wt ) contains of martensite, retained austenite structure, and mc, m6c, m2c carbides, and mc / m2c complex carbides by xrd, sem and metallographs. most of the mc carbides locate in the cell and other carbides distribute along the boundary of the cell

    結果表明：經金相組織觀察、 x射線衍射和掃描電鏡分析， fe - 2 c - 4 v - 4 mo - 5 cr - x w合金系高速鋼凝固組織包含馬氏體基體、殘余奧氏體及各種類型的碳化物如mc型碳化物、 m _ 2c型碳化物、 m _ 6c型碳化物和mc m _ 2c類型復雜碳化物，大部分mc型碳化物分佈於晶粒內部，其它類型碳化物則沿晶界呈網狀分佈。
  6. Longitudinal and transverse metallographic specimens for microscopic observation were prepared using conventional techniques. the morphology evolution was observed with neophot - 1 metaloscope and amray100b sem

    利用熱電偶測溫方法，對定向凝固過程中固液界面溫度梯度及影響因素進行測試和分析。
  7. The prepn. of dimethyldiallylammonium chloride monomer and the related polymers was summarized, and the use of the derivatives in text, dyeing and printing as antistatic, color fixing and flocculating agents were presented

    摘要簡述了二甲基二烯丙基氯化銨單體及其相關聚合物的制備方法，介紹了聚二甲基二烯丙基氯化銨及其衍生物產品在紡織印染行業中作為抗靜電劑、固色劑和絮凝劑的應用。
  8. Fesi2 - based semiconductors have been studied due to its good performance, low cost and potential application in power generation using waste heat. state - of - the - art techniques such as levitation melting, rapid solidification and hot uniaxial pressing ( hup ) were used for sample preparation in the present work. the phase transformation, micro structure and transport properties of the materials have been analysed with xrd, sem / edx, raman spectroscopy as well as thermoelectric characterization

    在綜合評述國內外熱電材料研究新進展的基礎上，本文以懸浮熔煉、快速凝固和單軸熱壓等制備工藝為技術特徵，以mn或al摻雜fesi _ 2基合金為研究對象，採用xrd 、 sem / eds 、 raman光譜以及材料熱電性能測試等分析表徵手段，系統研究相變過程、微觀結構特徵及其對材料熱電性能的影響。
  9. The test results show that the liquid metal dealed by electromagnetic pump is purified, its solidification process changes, thus, its fluidity improves

    試驗結果表明，電磁泵處理使液態金屬充分凈化，使凝固結晶過程發生變化，有利於液態金屬充型能力的提高。
  10. Copper - nanosized tibi composites were prepared by in - situ process. the microstructure, mechanical and electrical properties, and dry sliding wear behavior and electric sliding wear of cu - nanosized tib _ 2 in - situ composites was investigated ; mostly task as follows : the thermodynamic data for the reactions between b and ti in the molten liquid of copper were analyzed, the copper matrix composites reinforced by in - situ tibi nanoparticles were prepared by reactions of 8263, carbon and titanium in copper - titanium melt, and copper - titanium, copper - boron in alloy melt, respectively, which controlled the reaction temperature, reaction time and solidification process. the rnicrostructure and mechanical and electrical properties of the in - situ composites were investigated by using optics microscope, tem and xrd

    本文採用原位反應法制備了cu -納米tib _ 2原位復合材料，在此基礎上分析了原位復合材料的微結構，進行了干滑動摩擦磨損和電接觸滑動磨損實驗，完成的主要工作如下：從熱力學的角度出發，分析了陶瓷tib _ 2顆粒在銅基體中原位生成的熱力學條件，並用電解銅、工業純鈦、 b _ 2o _ 3 、 c （還原劑）以及cu - ti 、 cu - b等合金為原料，通過控制適當的反應溫度、反應時間和快速凝固等工藝手段，制備了cu -納米tib2原位復合材料。
  11. The effect of solidification rate on the solidified structure, cooperation growth zone and microstructures such as tac rods volume fraction, tac rods average spacing, tac average transverse area and y phase in this eutectic composite were systematically investigated with lmc. the relationship between solidification processing controlling and solidification microstructure was established

    藉助金相技術、電鏡技術、圖象處理技術等多種分析測試手段，考察試樣的界面形態、組織特徵以及共晶形貌等多方面的凝固特性，建立了凝固過程式控制制與凝固組織的對應關系。
  12. Therefore, in this paper, two directional solidification methods, czochralski method and electron - beam floating zone melting method, were used to obtain such material. the directional solidifition microstructures of si - tasi2 system was performed using neophot - 1, amray - 100b sem and jem - 2000cx tem analysis technique

    本文採用切克拉斯基法（ cz法）和電子束區熔法（ ebfzm ）兩種定向凝固方法制備該共晶自生復合材料；藉助金相技術、電鏡技術、圖象處理技術等多種分析測試手段，考察了si - tasi _ 2共晶定向凝固組織和及其相應的工藝規范。
  13. Solidification is controlled by electronic circuits making possible segregation - free ingots - a task impossible to achieve with castings

    通過電流控制凝固過程使得無分離鋼錠的製作成為可能，而這在鑄件工藝中則是不可能的任務。
  14. With the background of use in contact cable, this thesis introduces cu - cr alloys as studied subject, and from the two ways of solidified process and solidification mechanics, the structure configuration and the behave of separated - out strengthened elements are systematically study under the process of directional solidification

    本文就是以電車線的應用為背景，採用cu - cr合金作為研究對象，從凝固工藝和凝固機制兩個方面，系統地研究了其在定向凝固工藝下的組織形態及其強化元素的析出行為。
  15. Effect of electromagnetic stirring on solidification structure of casting

    電磁攪拌對鑄錠凝固組織的影響
  16. This product, prepared from the 2 - stage high - pressure hydrofined white oil, is characterized this lproduct, prepared from the 2 - stage high - pressure hydrolfined operation, its quality is up to by its high breaking down voltage, low setting pont and steady operation, its quality is up to or even superior to the state standarde and is widely used in various transpormers to ensure therir normal operation

    本產品採用二段高壓加氫精製的白油為基礎油料，經復配調制而成。產品具有抗擊穿電壓性能優良、凝固點低、穩定性好等特點，質量指標達到或超過國家標準要求，可廣泛應用於各地區變壓器的安全正常運轉。
  17. The microcrystalline was same to the direction of electric field. the microcrystalline orientation of the film that was obtained by melting pvdf congealing in the effect of electric field changed along electric field obviously. comparing with the film congealing without electric field their crystalline plate become thick

    發現pvdf纖維在電場作用下微觀結構變化較大，極化后微晶取向發生較大變化，極化以後微晶變化為沿電場方向取向的厚片狀，熔融態的pvdf在電場作用下凝固時變化更明顯，與不加電場直接凝固的pvdf膜相比，在電場作用下幾乎所有的分子鏈都沿電場方向取向所以出現有序的片晶結構，而且結構緻密。
  18. Solidified microstructure and phase structure of relaxor ferroelectrics pmn - pt

    弛豫型鐵電材料的凝固組織與相結構
  19. A computer simulation tracing study for the rapid cooling process of electronic material ga system consisting of 1000 atoms has been performed by using molecular dynamics mothod. adopting the honeycutt - andersen ( ha ) bond - type index method and the cluster - type index method, the bond - types and the basic cluster configurations formed by metal ga atoms have been analyzed

    採用分子動力學方法對由1000個原子組成的電子材料ga原子系統的快速凝固過程進行了計算機模擬跟蹤研究，運用ha鍵型指數法和原子團類型指數法分析了原子尺度上ga的成鍵類型和形成的基本原子團結構。
  20. Ansi a108. 1 - 1992 specifications for conductive dry - set portland cement mortar included in ansi a108. 1 - 1992

    導電的干凝固普通水泥砂漿的規范
分享友人
分享到 Line

分享到臉書