電動振動器 的英文怎麼說

中文拼音 [diàndòngzhèndòng]
電動振動器 英文
electric vibrator
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 動詞1. (搖動; 揮動) shake; flap; wield 2. (奮起) brace up; rise with force and spirit
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 電動 : motor driven; power driven; power operated電動擺 motor pendulum; 電動扳手 electric wrench; 電動泵...
  • 振動 : vibrate; vibration; vibrance; vibrancy; vibra; vibes; shaking; rumble; jitter; chatter; sway; jar...
  1. Based on chaos circuit, this paper discusses two application modes, random rectangle wave oscillator and chaotic inflator and introduces intensively methods and their results of computer

    基於混沌路,論述了兩種應用方式:隨機矩形波發生和混沌,並詳細介紹了計算機模擬方法和結果。
  2. Electric submersible vibroimpactor - technical conditions

    潛水技術條件
  3. Electric motor in internal concrete vibrators

    機內裝插入式混凝土
  4. During the circuit design, the author analyzed the basic principle of the direct current motor, pwm control, h - bridge power driver, and two control techniques of h - bridge power drive circuit, designed its general structure, so the feasibility of the design is confirmed. then, reference, oscillator, power dmos gate drive circuit ( charge pump, bootstrap ), and dead time generation circuit are designed and analyzed in the sub - circuits. a current - controlled oscillator is presented in this thesis

    路設計中,作者介紹了直流機的工作原理和數學模型、脈寬調制( pwm )控制原理、 h橋路基本原理和h橋功率驅路的兩種控制模式,設計了驅路的總體結構,給出了路的功能模塊,確定了設計的可行性,然後在子路模塊中,重點分析設計了基準源路、路、高端功率管柵驅路(荷泵及自舉路) 、低端功率管柵驅路和死區時間產生路。
  5. Annual production of 15000 pieces and sets of insert concrete vibrators ( bars ) built in a motor

    年產15000臺套機內裝插入式混凝土(棒) 。
  6. Test and study of a small electromagnetic vibration feeder

    小型給料的試驗研究
  7. The production of high frequency quartz crystals, which are used in audio - visual, telecoms and pc devices, commenced last september. monthly production capacity has now topped 3 million pieces which is half of the full design capacity

    高頻石英諧廣泛應用於影音、訊及腦產品上。集團新設立的高頻率石英生產線于去年九月投產,現時每月產量已逾三百萬只,達生產線設計產能五成。
  8. Flameproof mining motor vibertory machine

    礦用防爆
  9. And then, based on the above theories, the circuit design and simulation means have been concretely applied in the internal modules of voltage reference, bias circuit, oscillator, error amplifier and drive circuit of the chip and so on. the relevant design indexes are successfully achieved. at last, the whole circuit simulation and layout design are completed

    在此理論基礎上對該源晶元內部的各個模塊,如壓基準源、偏置路、、誤差放大路和驅路等模塊進行了具體的路設計和分析模擬,且達到了相應地設計指標,最後,完成了整體路模擬和版圖設計。
  10. The dissertation presents the combined theoretical, numerical and experimental studies on the experimental modeling of the actuator, the design of test rig and control system, the modeling of two - dimensional airfoil aeroelastic system, the control design of active flutter suppression, and the effect of group delay in the digital filter on the stability of aeroelastic closed - loop system

    本文通過理論分析、數值模擬與風洞實驗相結合的方法,研究了超聲機作建模、翼段顫實驗裝置和控制系統設計、二維翼段氣彈性系統建模、顫抑制控制律設計以及數字濾波群時延對顫抑制閉環系統穩定性影響等問題。
  11. According to the feature of vibration isolation system, referring to the principle of the magnetic suspension, a electromagnetism actuator is designed for the active vibration isolation system application and also a power amplification circuit is designed to adapted to it

    針對隔系統的特點,參考磁懸浮的原理,設計了適合主系統應用的磁作,並設計了與之配套的功率放大路,還對其他系統必需的硬體進行了選型。
  12. In this paper, the mechanics model and computer control method for electromagnetism vibration feeder are studied. the emphases are put on the seeking of optical motion states and the realization of these states by computer control. using labview ( laboratory virtual instrument engineering workbench ), a waveform generator is established to control the electromagnetic force

    本文對給料機的力學模型與計算機控製做了比較深入的分析和研究,特別是給料機的力學分析與最佳運狀態、磁鐵的一些特性和用labview實現計算機控制,在與傳統的控制方法對照的情況下,建立了對比較周全的力學模型,提出了利用labview程序產生一個波形發生,經過放大后對磁鐵進行控制。
  13. Single stage voltage regulator

    單級式繼
  14. Testing method of vibroflot performance

    潛水性能試驗方法
  15. Work principles of a test bench for four wheel steering are briefly discussed, including loading system, pneumatic vibratory system, steering system and electric control system. its feasibility is analyzed

    摘要簡要分析了4輪轉向試驗平臺的工作原理,其中包括加載系統、氣系統、氣力系統、轉向系統和控制系統的工作原理,並對其可行性進行了分析。
  16. Double stage voltage regulator

    雙節式調節
  17. The new resolution method is advanced according to the control requirements of electro - hydraulic shaking table. however, there is still much work for us to constitute a complete set of servo controller in our future research

    根據臺中液伺服控制的需要,提出了一些解決的方法,但要建立一套完整的伺服控制設計方法,還需進行大量的工作。
  18. At present, its main products include y, y2 series motor, yd series multi - speed motor, yb2 explosion - proof motor, fractional horsepower motor, vibrator and pump

    目前主要有y 、 y2系列機、 yd系列多速機、 yb2防爆機、分馬力機、及水泵等產品。
  19. As far as the tow - stage vibration isolation mounting with dynamoelectric actuator is concerned, the effect of the selection of the error sensor ( displacement, velocity, acceleration ) on the force transfer rate of the pid active vibration control system is analysed and on the basis of this the control simulation with hebb rule on two - stage vibration isolation mounting with the single neural adaptive pid controller is made and the simulation results indicate the method is effective. 2

    針對具有執行的雙層隔實驗臺架,討論了誤差傳感類型(位移、速度、加速度)的選擇對雙層隔pid控制系統力傳遞率的影響,在此基礎上將單神經元自適應控制引入控制系統,採用hebb學習演算法進行了雙層隔系統控制模擬研究,取得了滿意的控制效果。
  20. Based on the requirements of high precision pointing / targeting of advanced spacecraft, dynamic modeling of spacecraft with flexible appendages bonded with piezoelectric sensors / actuators, attitude control and active vibration suppression theory are studied deeply in this dissertation, which is funded by the research fund for the doctoral program of higher education of china item ? “ large flexible multi - bodies structure spacecraft active vibration control technology ” ( 20050213010 ). the main contents of this dissertation are as the follows : an approximate analytical dynamic model of a flexible spacecraft with surface bonded piezoelectric sensors and actuators is derived using hamilton ’ s principle with discretization by the assumed mode method. the model is then converted to state - space form for the purpose of control design

    本學位論文結合高等學校博士學科點專項科研基金「撓性多體結構衛星主控制技術研究」 ( 20050213010 )課題,從理論上對粘貼有壓智能元件的撓性航天的建模、姿態控制和主控制理論等展開了深入的研究,其研究內容主要包括以下幾個方面:利用hamilton原理推導了撓性航天力學模型、壓元件的作方程及檢測方程,並採用模態分析方法,進一步將撓性航天的耦合方程規范化,使之適應于姿態控制系統的分析和設計。
分享友人