電動機制動 的英文怎麼說

中文拼音 [diàndòngzhìdòng]
電動機制動 英文
motor braking
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : machineengine
  • : Ⅰ動詞1 (製造) make; manufacture 2 (擬訂; 規定) draw up; establish 3 (用強力約束; 限定; 管束...
  • 電動機 : electric motor; motor (俗稱「馬達; 電滾子」)電動機並聯法 parallel connection of the motors; 電...
  • 電動 : motor driven; power driven; power operated電動擺 motor pendulum; 電動扳手 electric wrench; 電動泵...
  1. Control of soft starting of large asynchronous motor

    大型異步的軟起
  2. Depend on the comprehensive analysis and study of the structure, principle, and exterior characteristic of the motor, through the methods of system modeling and digital simulation analysis, two kind of control device that work for the low voltage ( lvdc ) and the high voltage ( hvdc ) in avigation are researched respectively. point to the control technique of close - loop speed stabilization at a limited adjustment speed range, we bring out the close - loop speed control method that using the rotor position sensor indirectly measure the speed of the motor

    在全面分析了稀土永磁無刷直流的結構特點、工作原理、運行方式以及外部特性的基礎上,通過系統建模和數字模擬分析,分別針對航空低壓直流( lvdc )和高壓直流( hvdc )兩種構用永磁無刷,在小范圍轉速連續調節下的閉環穩速控技術進行了詳細理論研究,提出了利用轉子位置傳感器信號間接測量轉速進行轉速閉環穩速控的策略。
  3. According to the system technology require, adopting singlechip realize open loop digital control of hdclsm ; using v / f conversion and complex key - control method realize digital setting of system parameter, such as velocity ; using micro - stepping control insure the motor running more smoothly ; adopting debasing speed control method to eliminate the mechanical impact of distance termination effectively ; at the same time, analyzing main power circuits drive circuit and protect circuit of system, completing hardware design and facture and software programming and debugging ; at last, making a whole test in hybrid rotary step motor. the experiment result indicates that this control system reaches the qualities required and run smoothly also

    根據系統技術要求,採用單片實現了混合式直流直線步進的開環數字控;利用v f變換和復合鍵控方法實現了系統轉速等參數的數字設定;利用細分控技術保證了運行的平穩性,並進行了波形分析和理論研究;採用單片軟體降速控策略解決直線步進行程末端的械沖擊問題;同時對主功率路、驅路和系統保護路進行了分析,完成了硬體設計、製作和軟體編程、調試,最後在混合式旋轉步進上進行了全面測試。
  4. Speed controller for step motor based on fpga and dds

    技術的步進速度控
  5. The machine mainly includes electromotor framework, dibbling mechanism, sowing mechanism, powered mechanism, pneumatic electric and plc control panel

    主要由架、打洞裝置、播種裝置、傳構、氣氣及plc控等部分組成。
  6. A. c. high - voltage switchgear and controlgear. high - voltage motor starters. part 1 : direct - on - line full voltage a. c. starters

    交流高壓開關設備和控裝置.高壓器.第1部分:直接在線交流起
  7. Low - voltage switchgear and controlgear - part 4 - 1 : contactors and motor - starters ; electromechanical contactors and motor starters

    低壓開關設備和控設備.第4 - 1部分:接觸器和器.式接觸器和
  8. Moreover, the aeronautic linear dc motor control system not only can instead the drive motor of emergency discharging - oil valve, but also can be used in some low power electromotion machine making linear locomotion. the motor owns extensive application foreground preferably

    該直線直流步進系統的研製,可替代現有飛應急放油閥有刷驅,也可用於小功率直線運構中,具有較好的應用前景。
  9. A mathematic model of the motor is builded and emulated through matlab. the low - speed and constant - torque, high - speed and constant - power state is analyzed and researched, also the software approach of simulation to the driver has been done, a digital signal processor tms320lf2407 is developed successfully to control the perm square - wave bldcm driving airscrew of solar powered unmanned engine. it is useful to the further study

    在matlab下建立了的數學模型,通過計算模擬,驗證了數學模型的正確性,同時在理論上對低速恆轉矩高速恆功率運行進行了分析與研究,提出了一種用模糊控的方法實現恆功率控,並對驅器進行了系統模擬,成功的研製了以數字信號處理控器tms320lf2407為控核心的驅器,控無刷直流太陽能無人飛的螺旋槳,為後面繼續研究工作提供了參考。
  10. The paper involved srm s maths model, velocity - control theory and feedback - signal - check technique. according to srd s main technical demand, srm s raw data and srm s control theory, the main system was divided into several modules. based on the modules, by selecting proper components and calculating right parameters, in parallel with the sample machine s experiments, the cotroller s design was completed and the system completely meet the demands

    根據開關磁阻系統的主要技術要求和開關磁阻的原始數據以及控理論,將2 . 2kwsr器系統的設計劃分為幾大功能模塊,進而通過系統元器件的選型和參數計算,結合樣試驗,完成了對2 . 2kwsr器系統的設計,並達到功能要求。
  11. Automatic electrical controls for household and similar use - part 2 : particular requirements for motor starting relays

    家用和類似用途的自裝置.第2部分:器的特殊要求
  12. Particularly set forth scm control circuit, principle and realization process of dc electromotor in creeping machine, the design of logic circuit and principle of interface card, the design of precise location installation, the choice of sensor, its principle and realization process, including the concrete process of realization by software

    詳細闡述了爬行器中直流裝置的單片路設計、工作原理及實現過程;介面卡邏輯路的設計和工作原理;精確定位裝置的設計、傳感器的選用、工作原理,包括各項工作的具體軟體實現過程。
  13. Once the force between wheel and track surpasses the biggest adhesive power that the track ’ s permission, it will bring the idle turn and slide of wheels and the vehicles can ’ t be droved or braked. therefore the traditional metro system is a kind of driving type that is restricted with the track adherence

    由直線感應的線性地鐵是目前發展比較快的城市軌道交通工具之一,其牽引力不再受到輪軌黏著的限,而是靠直線初級與次級之間的磁推力驅運行。
  14. Research on direct torque control of induction machine with fuzzy controller

    直接轉矩模糊控感應系統的研究
  15. Low - voltage switchgear and controlgear - part 4 - 3 : contactors and motor - starters - ac semiconductor controllers and contactors for non - motor loads

    低壓開關設備和控裝置.第4 - 3部分:接觸器和器. ac半導體控器和非負載用起
  16. The permanent magnet brushless dc motor servo system is an abroad servo form, now it is used on highly precision, small power cortrolling field

    永磁無刷直流系統是目前在高精度中、小功率伺服控領域中應用極為廣泛的驅形式。
  17. Low - voltage switchgear and controlgear - electromechanical contactors and motor - starters

    低壓開關設備和控設備式接觸器和
  18. Low - voltage switchgear and controlgear - part 4 - 1 : contactors and motor - starters ; electromechanical contactors and motor - starters

    低壓開關設備和控設備.第4 - 1部分:接觸器和器.式接觸器和
  19. Low - voltage switchgear and controlgear - part 4 - 1 : contactors and motor - starters ; electromechanical contactors and motor starters ; amendment 1

    低壓開關設備和控設備.第4 - 1部分:接觸器和器.式接觸器和器.修改件1
  20. The article in lead - zinc mineral tailing transmission pumps electric motors automatic control system of huang - shaping, for example, a detailed account of the system frequency conversion governor, ultrasound liquid position controller design models, debugging points and parameters set methods, and energy saving effect of a careful analysis

    摘要文章以黃沙坪鉛鋅礦尾礦輸送泵系統為實例,詳細介紹了系統中變頻調速器、超聲波液位控器的設計選型、調試要點和參數設定方法,並對節能效果進行了認真分析。
分享友人