電壓四倍器 的英文怎麼說

中文拼音 [diànyāsìbèiqì]
電壓四倍器 英文
voltage quadrupler
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 壓 : 壓構詞成分。
  • 四 : Ⅰ數詞（三加一后所得） four Ⅱ名詞1 [音樂] （中國民族音樂音階上的一級） a note of the scale in gong...
  • 倍 : Ⅰ名詞（跟原數相同的量） times Ⅱ形容詞（加倍） double; twice as much
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 電壓 : voltage; electric tension; electric voltage
  1. A white led driver circuit is presented in this paper. the circuit drives up to four white leds with regulated constant current for uniform intensity. by utilizing proprietary adaptive 1x / 1. 5x modes and ultra - low - dropout current regulators, it maintains the highest possible efficiency over the full 1 - cell li + battery input voltage range

    整體電路以恆定電流驅動4隻白光led ，利用1倍/ 1 . 5倍分數型電荷泵和低壓差電流調節器，在整個鋰電池供電電壓范圍內保持最高的效率，並使四個白光led獲得均勻的亮度。
  2. At the same time the effection of some important recombinations are discussed and the relation of photoconduction versus time is given. in chapter 4, auston circuit, blumlein pulse forming line, multiplier of pulse forming line are introduced and give their differentiates

    在第四章中，分析各種以光導開關為核心器件的電脈沖成形電路: auston電路、 blumlein脈沖成形線、層疊線倍壓器，對其輸出轉換效率進行比較，並進行實驗研究。
  3. The topologies family include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits. taking full - bridge mode circuit as an example, the operational mode, steady principles, transient voltage feedback control strategy of the converter are investigated. the output characteristic curve, the design for the key circuit parameters and the reference sinusoidal circuit which is synchronous with the signal of n or 1 / n times line voltage frequency are given

    該電路拓撲族包括單四象限功率開關式、推挽式、半橋式、全橋式電路，以全橋式電路為例分析研究了這類換器工作模式、穩態原理與電壓瞬時值反饋控制策略，給出了變換器的外特性曲線、關鍵電路參數、與電網電壓n倍頻或n分頻信號同步的基準正弦電路的設計。
  4. The input voltage of the piezoresistive transducer, gain, sampling frequency and negative delay can respectively be graded through programming. the stored system is specially designed to have two modes of trigger ( namely, external trigger through wire breakage and inner trigger through overpressure signal ), reading software and interface circuit that are of

    該測試系統可通過編程選擇傳感器供電電壓（兩檔） 、放大倍數（四種） 、采樣頻率（四種） 、負延遲（四種） ；同時具有斷線外觸發和超壓信號內觸發兩種觸發方式；讀數的軟體和介面電路都具有串併兼容特性；系統還具有狀態自檢和定時上電等功能。
  5. But in fact, there are many windings on each leg of a balance transformer, and the winding impedance relationships that the balance condition requires are strict, so it is difficult to design and make such transformers. if adopting the connection scheme of dual windings, the windings on single leg will increase almost doubly. it is more difficult to satisfy the balance condition and probably it will confront conflict when arranging these windings, so parameters of various phases can not be balanced

    事實上由於平衡變壓器單柱繞組數目較多，若採用雙重接線方案，則單柱繞組數目增加近一倍，滿足平衡條件十分困難，甚至使得繞組在空間上的布置產生矛盾，無法達到各相參數平衡的要求，而「四相四心柱「結構的三相變四相電力變壓器較好的解決了這一難題。
分享友人
分享到 Line

分享到臉書