電子噴油系統 的英文怎麼說

中文拼音 [diànzipēnyóutǒng]
電子噴油系統 英文
electronic fuel injection system
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 子Ⅰ名詞1 (兒子) son 2 (人的通稱) person 3 (古代特指有學問的男人) ancient title of respect f...
  • : 噴動詞1. (液體等受壓力而射出) spurt; spout; gush; jet 2. (噴灑) spray; sprinkle
  • : Ⅰ名詞1 (脂肪; 油脂) oil; fat; grease 2 (姓氏) a surname Ⅱ動詞1 (用桐油、油漆等塗抹) apply t...
  • : 系動詞(打結; 扣) tie; fasten; do up; button up
  • : Ⅰ名詞1 (事物間連續的關系) interconnected system 2 (衣服等的筒狀部分) any tube shaped part of ...
  • 電子 : [物理學] [電學] electron
  • 系統 : 1. (按一定關系組成的同類事物) system 2. (有條理的;有系統的) systematic
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2控單元路連接器設計製成輸入輸出控制檢測端,並在檢測面板上布置了obd -診斷插座和燃壓力表。使該動態測試能實現對發動機的燃、直接點火、怠速控制和燃蒸氣排放控制的動態檢測;並通過obd -診斷座、 ecu輸入輸出檢測端和故障模擬處理單元實現對發動機各傳感器、控單元、執行器進行故障碼讀取與清除;動態數據讀取和波形測試和故障模擬等。此外,本論文還分析了傳感器和執行器典型故障波形。
  2. Eci - jet electronic controlled injection jet

    控制燃射的燃供給
  3. Electronic control of fuel injection system for diesel engine

    控制
  4. Ndfeb magnet is mainly made of neodymium iron and boron, with excellent magnetic property abundant raw material and reasonable prices, ndfeb magnet can be used as an ideal magnet in mini - motor permanent magnetic resonance sound device magnetic suspension system, magnetic transmission machine and iatrical apparatus and etc. for ndfeb, its surface is usually treatd with some special methods. the surface treatment method include zine nickel tin silver gold plating phosphor and spray epoxy resin etc

    其主要應用在微特機、永磁儀表、工業、汽車工業、石化工、核磁共振裝置、音響器材、磁懸浮、磁性傳動機構和磁療設備等方面。釹鐵硼磁鐵容易生銹、氧化,所以對釹鐵硼磁鐵,其表面通常需作鍍處理,如鍍鋅、鎳、銀、金等,也可以做磷化處理或環氧樹脂來減慢其氧化速度。
  5. Defi digital electronic fuel injection

    數字式
  6. The application of electronically controlled technology to diesel engines provides flexibility and effectiveness in reduction of emission, noises and improvement of engine performances, saving energy, etc. in order to improve the all - round performance of diesel engine, a research on the integration of electronically controlled fuel injection and inhale - exhaust system of diesel engine is done by our research group

    機採用控技術后為控制排放、節約能源、降低噪聲、改善性能提供了靈活而有效的手段。為了實現柴機全控制,課題組對柴機燃和配氣的綜合控技術進行了研究。本文的主要工作為:在中壓共軌控燃上實現預射。
  7. Siemens vdo serves in the local china market covering the products of ems ( engine management system ), diesel system, tcu ( transmission control unit ), fuel rail, injector, sensor, fuel supply system, engine actuator, acu ( airbag control unit ), bcm ( carbody control module ), window lift motor, engine cooling module, abs motor, rke, instrument panel, audio system ( radio / cassette / cd ), navigation system, vdr ( commercial vehicle data recorder ), etc

    在中國市場上,西門威迪歐汽車中國的產品列包括ems (發動機管理) 、柴、發動機執行器、 tcu (自動變速箱控制單元) 、軌、燃嘴、傳感器、泵、 acu (安全氣囊控制單元) 、 bcm (車身控制模塊) 、搖窗機、發動機冷卻模塊、 abs機、駕駛臺儀表、音響、導航和vdr (商用車行車記錄儀)等。
  8. The timing - and - quantitation precision injection of lpg was realized with high - speed lpg solenoid valve and a set of electronic control system, which was designed by the author and can flexibly control the gas supply system of lpg. based on the analysis of experimental data got by comparing the performances before and after the application of the set of equipment on lr6105q12 diesel engine, the effects of load, speed and replace ratio, etc on the emissions of smoke, hc and co of dual fuel engine were expounded. through optimization, the smoke emission was utmostly reduced and the emissions of hc and co were within the government restriction

    為此,本文通過對各個方案進行詳細比較,選擇了控多點順序射的供氣方案;利用高速lpg射閥和自己獨立開發出一套控制對lpg供氣進行靈活地控制,實現了lpg的定時定量射,並把這套裝置應用到中國一拖生產的lr6105q12柴機上,在對改裝前後的發動機進行大量試驗和分析的基礎上,闡明了負荷、轉速、摻燒比等因素對雙燃料發動機的煙度、 hc 、 co等排放的影響情況,並且通過優化,最大限度地降低了發動機的煙度排放,同時使hc 、 co排放限制在國家標準規定的范圍之內。
  9. The logic control principle by locomotive computer and its control logic process are introduced. the control system for the electronic fuel injection of diesel engine on this locomotive has been introduced. the emphases is put on the way to realize the constant power control for the diesel engine by the electronic fuel injection system, and how to transfer the auxiliary power of the locomotive and how to modify the locomotive tractive effort to compensate its temperature swing as the calculation result of the tractive effort by direct torque control is dependent on the temperature

    論文第6章深入研究了機車微機控制的工作原理、控制流程,介紹了機車微機實現邏輯控制的方式及控制邏輯關;介紹了柴射控制技術在本機車上的實現方式,重點研究了射控制西南交通大學碩士研究生學位論文第11頁如何進行柴機的恆功率控制,以實現機車的輔助功率轉移,並對機車牽引力進行修正,以彌補直接力矩控制所產生的牽引力隨溫度而變化的問題。
  10. Electronic fuel injection system

  11. Egi electronic gasoline injection

  12. This product acquires engine crank corresponding phase signal and rotating speed signal, which after ecu treatment, are used together with signals collected from other load sensor ( such as shutter location sensor ) to achieve electronic control over engine ignition timing. compared with mechanical ignition timing control, this is more precise and reliable, resulting in optimized performance of engine in oil consumption, exhaust, output and torque

    Fdw465b型器總成採集發動機曲軸相位信號及轉速信號,同其它負荷傳感器(如節氣門傳感器等)採集到的信號,經控單元ecu計算處理后,實現對發動機點火正時的控制,較之機械式點火正時控制更加精確、可靠,使汽車發動機的綜合性能得到較大提高,特別是發動機的燃消耗率、排放、輸出功率、扭矩等方面都得到較大優化。
  13. We could offer the automatic dust - free painting production line for manufacture, tunnel drying oven line, paint coating production line for metalwork, paint coating production line for glass - work, paint coating production line for woodwork, powder coatingproducte line for metalwork, whole series of painting cabinet, all classes of drying oven, uv light drying, fresh air supply sy - stem, static dust removal equipment, emission 、 waste water control system and net printingproduction equipment, conveying equipment, electronic production equiment etc

    公司專業提供塑膠製品自動無塵塗裝線,隧道式烤爐流水線,金屬製品生產線,玻璃製品生產線,木製品生產線,金屬製品粉生產線,全漆櫃、粉房,各類?爐、烘爐, uv光固化機,鮮風供給,靜除塵設備,廢氣、廢水處理及絲印生產設備,物流輸送設備,生產設備等。
  14. As a development partner to the automotive industry, we manufacture powertrain products, engine control electronics and fuel injection systems that improve engine performance and lower emissions

    作為汽車製造商的開發合作夥伴,我們生產能夠提高發動機性能、減少排放的動力產品、發動機控制裝置和燃
  15. As development partner of the automotive industry, the company manufactures products for powertrain, engine control electronics and fuel injection technology, which improve engine performance and reduce emissions and fuel consumption

    作為汽車製造商的開發合作夥伴,我們生產能夠提高發動機性能、減少排放的動力總成產品、發動機控制裝置和燃
  16. This paper is made under the guidance of the cognitive learning theory and the viewpoint of constructivism. it finishes the development and research work of multimedia studying system of the automatic transmission, the petrol jetting and the electronic igniting in the multimedia software of the new automobile structure

    本文在認知學習理論和建構主義學習觀的指導下,完成了汽車新結構多媒體課件中的自動變速器多媒體學習、汽射多媒體學習和汽車點火多媒體學習的開發研製工作。
  17. Added cgw for 215 and 230 and sds system. 3. added new sort for cdi3, sam - rear and eis

    3新增了cdi3共軌燃射發動機sam - rear后信號獲取模塊eis點火3個的新類別。
分享友人