電子束密度 的英文怎麼說

中文拼音 [diànzishùmìdù]
電子束密度 英文
electron beam density
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 子 : 子Ⅰ名詞1 （兒子） son 2 （人的通稱） person 3 （古代特指有學問的男人） ancient title of respect f...
  • 束 : Ⅰ動詞1 （捆; 系） bind; tie 2 （控制; 約束）control; restrain Ⅱ量詞（用於捆在一起的東西） bundle;...
  • 密 : Ⅰ名詞1 （秘密） secret 2 [紡織] （密度） density 3 （姓氏） a surname Ⅱ形容詞1 （距離近; 空隙小）...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 電子 : [物理學] [電學] electron
  1. The experimental results show : the flattop phenomenon on the diode voltage pulse was very apparent for using the carbon fiber cathode, that is to say, the pulse duration of the diode voltage was widened ; moreover, under the condition of the same power of microwave, the pulse duration of the out - put microwave was prolonged by about 30 % ; the peak power of the microwave was enhanced by 3db

    通過在裝置上做的兩種陰極的對比實驗，結果顯示:碳纖維陰極的使用，改善了電子束質量，使輻射微波的脈寬增加了30 %以上，輻射主瓣方向上的功率密度提高了3db以上，頻譜分佈較純凈，實現了微波的高效輸出。
  2. Abstract : the effect of correction of self - consistent potential on electronic structure in simple cubic nanocrystal particles is calculated by means of the green ' s function method in the tight - binding approximation, taking only the nearest neighbor matrix elements into account. the numerical results show that the electronic energy spectrum is shifted, the chemical potential is not equal to the atomic energy level, the electronic density at each lattice point is changed, and the variation of electronic density at surface lattice point is the largest

    文摘:在緊束縛近似下，只計及最近鄰的矩陣元，採用格林函數計算了自洽勢修正對簡立方納米晶體顆粒的電子結構的影響，發現電子能譜發生了移動，化學勢不等於格點原子能級，各格點的電子密度也發生了變化，其中以表面格點的電子密度變化最大。
  3. A pulse from an intense laser or particle beam, however, creates a disturbance in the plasma

    然而，一個從高密度的雷射或粒子束所產生的脈沖，可以對電漿產生擾動。
  4. Subnanosecond millimeter relativistic backward wave oscillator, based on superradiance mechanism, was a novelty microwave device developed in last few years. the dependence of peak power on the square of the density of electron beam is almost linear

    基於超輻射機理的亞納秒毫米波微波器件是近幾年發展起來的一種新型微波器件，其輻射功率與參與束波互作用的電子束密度的平方成正比關系。
  5. Chapter 2 : characteristics of propagation of ultra - intense laser beam in a partially stripped preformed plasma channel is discussed, in which the relativistic self - focusing effects, together with the perturbed plasma density, is discussed

    第二章：本章闡述了超強激光光束在拋物型部分電離的預等離子體（聚焦和散焦）隧道中的傳輸特性。研究了相對論自聚焦效應和等離子體波引起的密度擾動對傳輸的影響。
  6. Compared with conventional weld methods, electron beam welding possesses such advantages as high power density, strong penetrability, precise, high speed, good control ability, good protection effect and high quality

    與常規的焊接方式相比，電子束焊接具有功率密度高、穿透能力強、精確、快速、可控性好、保護效果好、焊縫質量高等優點。
  7. Which is scanned with an electron beam. so the resulting signal

    密度模式經電子光束的掃描，繼而產生的信號
  8. To make pic ( particl - in - cell ) simulations. to set up models of guns and magnetic field and simulate them in the vacuum and plasma, respectively. we found that plasma held back part of space charge effects and improved trajectory of electrons. but beam would oscillate and became instable as accretion of plasma density. by simulating again and again, we draw a conclusion magic could n ' t work when plasma density was more by far than beam electron density. at last a four - stage depressed collector was simulated

    建立電子槍和聚焦系統模擬模型，分別在真空和填充等離子體條件下進行模擬。發現填充等離子體能補償部分空間電荷效應，改善電子束包絡軌跡，提高電子的流通率，但是隨著等離子體密度的增大，束電子會出現振蕩不穩定性，遺憾的是通過反復多次模擬發現本文所用粒子模擬的代表性軟體magic無法用於模擬等離子體密度遠高於束電子密度的情況。
  9. In the hipib strengthening experiments, samples of high - speed steel ( w6mo5cr4v2 ) were irradiated by abstract hipib ( cn + = 30 %, h + = 70 %, ion energy 250 kev, ion current density 60 - 180a / cm2, pulse duration 80 - 100 ns ). microstructure investigation and properties characterization of the treated hss samples were carried out to investigate the effect of current density and pulse number of incident hipib on the surface modification treatment. the physical mechanism of the hipib - solid interaction was established based on the experiments

    在hipib轟擊材料表面方面，本文選擇成分由c ~ （ n + ） （ 30 ）和h ~ + （ 70 ）組成、加速電壓為250kv 、脈沖寬度為80 100ns的hipib對高速鋼（ w6mo5cr4v2 ）進行表面輻照處理，研究離子束流密度和脈沖次數對高速鋼微觀結構和宏觀性能的影響，探討了hipib與材料表面相互作用的物理機制。
  10. Standard practice for approximate determination of current density of large - diameter ion beams for sputter depth profiling of solid surfaces

    固體表面濺射深度仿形加工用大直徑離子束的電流密度近似測定的標準規程
  11. Meanwhile by using numerical method, the beam ' s one - order current density, and the power exchange between the beam and the field are solved. curves are given to illustrate the relations among the above solved parameters and the gap ' s transit angle in different electron velocity and number density

    然後通過數值求解得到了不同初始速度和電子數密度時徑向間隙中一階電流密度、高頻電場、電子束與本徵場的功率交換等隨間隙直流渡越角的變化規律。
  12. The main results are as follows : 1. the propagation of an ultrashort intense pulse laser beam in low - density plasmas is investigated analytically. relativitistic pondermotive force and space - charge effects are included, and an equation describing the evolution of the laser spot size is derived

    考慮有質動力與電荷分離場的平衡，推出了超短超強脈沖激光在低密度等離子體中的折射率、電子密度和電荷分離場的表達式以及激光束斑的演化方程。
  13. A collinear acoustooptic - deflector of pronton - exchanged linbo3 channel wave - guide is studied. the theoretical analysis, structure design and device fabrication of linbo3 pronton - exchanged acoustooptic wave - guided deflector have been finished in this thesis. the width of wave - guide, the width, spacing, effective aperture and width of electrode of interdigital transduces have been theoretically analyzed and designed

    本論文研究了一種質子交換linbo3溝道波導共線式聲光偏轉器，其特點是利用了溝道波導的橫向約束，限制了聲波的發散和衍射效應，使得窄孔徑電極結構得以實現，從而增加了功率密度，使總的聲場驅動功率降低。
  14. There is a part of beam loss during the course as the neutralization of high - energy particles dragged from the ion source, the deflexion of charged particle on the beam stream and the scraped beam of exceeding beam waist and low density. it is necessary to analyze the beam loss and bring forward a rational project for absorbing beam stream

    將離子源引出的高能粒子進行中性化，再偏轉掉束流中的帶電粒子，將超過束腰半徑、密度較小的束流削除，在此過程中有一部分束流損失，它直接影響加熱功率的因素，因此，對束流損失進行了分析，對損失束流的吸收提出了吸收方案。
  15. There were troubles in the continuity of the function and of its - derivative divided by band - mass on the boundary. in the theoretical calculation, the wave function is relative to the physical properties of the impurity greatly, the envelop function f ( x, y ) is expanded in terms of the one - dimensional linear harmonic oscillator function in this paper. it satisfies the continuity of the function and of its - derivative divided by the band - mass, so it improves the precision of the function and binding energy

    與以往工作不同的是，以前選用的x ， y方向電子的包絡函數f （ x ， y ）是一維有限深量子阱中波函數的乘積，在邊界上波函數的連續性和粒子流的守恆條件存在問題；而在理論計算中，波函數的選取與雜質的物理性質有密切關系，本文選取的電子的包絡函數是用一維線性諧振子的波函數展開而成的，在邊界上能夠同時滿足波函數的連續性及粒子流（ 1 / m ~ * ） f ' （ x ， y ）的守恆條件，從而使得波函數和束縛能的精確度得到了改進。
  16. The maximum output of ion beam current is obtained at a charging voltage of 8 kv for the magnetic field power system, which is in accordance with the theory of magnetic insulation. the ion beam parameters are an accelerating voltage of 300 kv, an ion current density of 300 a / cm2 with beam pu lse width of 80 ns and with composition of 70 % proton and 30 % carbon ions

    在磁場電源電壓為8kv ，獲得了與磁絕緣理論相符的最大離子束流密度輸出，離子束參數為：加速電壓300kv ，離子束流密度300a cm ~ 2 ，離子束脈沖寬度80ns ，成分約為70 h離子和30 c離子。
  17. At the delay time when the area on the anode surface bombarded by electrons expands to a maximum field, the upper limit of ion beam current output is reached. the ion beam parameters are an accelerating voltage of 220 kv, an ion current density of 350 a / cm2 with beam pulse width of 70 ns and with composition of 30 % proton and 70 % carbon ions

    在電子流對陽極轟擊面積達到最大所對應的延遲時間，獲得了最大離子束流密度輸出，離子束參數為： 220kv ， 350a cm ~ 2 ， 70ns ，成分約為30 h離子和70 c離子，離子束流密度的波動同樣可控制在20 。
分享友人
分享到 Line

分享到臉書