電容性的 的英文怎麼說

中文拼音 [diànróngxìngde]
電容性的 英文
capacitive
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 的 : 4次方是 The fourth power of 2 is direction
  • 電容 : electric capacity; capacitance; capacity
  1. Though there are a certain level of counteractive impacts to the market power from the price - differentiation agreement and dynamics of demand, the influence of market power cannot be eliminated ; 3 ) in the electricity market, the market power size is greatly influenced by the supply - demand relationship, extent of concentration, and market collusion

    雖然差價合約和負荷需求彈性對市場力有一定的抑制作用，但並不能消除市場力的存在。 （ 3 ）電力市場的供需關系、市場的集中度以及市場共謀的有效性極大地影響著市場力的大小；發電企業的成本和發電容量的限制在某種程度上也影響著市場力的實施效果。
  2. The idiographic measure which can improve emc of smps have been summarized

    對改善開關模式電源電磁兼容性的具體措施進行了綜述。
  3. The carbon nanotubes ( cnts ) are attractive materials for electrodes of supercapacitors due to their superb characteristics : chemical stability, low mass density, low resistivity, and large specific surface area

    納米碳管導電性好、比表面積大、微孔集中在一定范圍內，從理論上講是製作超級電容器的理想材料。
  4. Tabular layouts of article characteristics for capacitors

    電容器的產品特性圖表
  5. Electrode materials have effects on properties of electrochemical capacitor, many carbonaceous materials such as active carbon, pyrolytic carbon, active carbon fiber and carbon nanotube were mainly used in electric double - layer capacitor. because of synthetic conditions and cost, we studied their electrochemical properties of electronic double - layer capacitor that pyrolytic carbon was used as their electrode materials

    電極材料是影響電化學電容器性能的主要因素之一，應用於雙電層電容器的電極活性物質主要是各種碳材料，如各種活性炭、熱裂解碳、碳纖維、碳納米管等，考慮到合成工藝和成本因素，我們採用熱裂解碳為雙電層電容器的電極材料，並研究了它們的電化學性能。
  6. The influence of burning system on the properties and structure of the ceramic capacitors has been studied under the certain temperature system, the optimum sintering temperature of the ceramics was primarily decided by the content of bi2o3 ? 3tio2. the sintering temperature dropped with the adding of bi2o3 ? 3tio2. at the range of suitable sintering temperature, slow heating and low temperature sintering can obtain fine grain and dense structure. it results in the improving of the breakdown voltage for the middle - high voltage ceramic capacitors

    研究了燒成工藝制度對電容器陶瓷性能和結構的影響，結果表明：在一定的升溫保溫時間下，瓷料的最佳燒結溫度主要取決于組成中bi _ 2o _ 3 ? 3tio _ 2的含量， bi _ 2o _ 3 ? 3tio _ 2含量的增加將降低燒結溫度；在合理的燒結溫度范圍內，慢速升溫和低溫燒結將有利於得到細晶緻密結構，從而改善中高壓陶瓷電容器的耐壓強度。
  7. The third chapter shows preparation and super - capacitive properties of coai double - layer hydroxide. it is made up of four parts

    第三章是coal雙氫氧化物的制備及其超電容性能，分為四部分： 1
  8. Most china standards on emc are compulsory standards, those products covered by emc standards must be inspected in emc

    電磁兼容標準符合強制性標準的特點，所以電磁兼容標準大都屬于強制性的。凡是有電磁兼容要求的產品都必須進行電磁兼容性的檢驗。
  9. The result reveals that the stress control tube comprising a composite structure of the nonlinear resistive and capacitive material shows the best performance in improving electric field distributions in cable terminations

    分析結果表明，採用由電容性和非線性電阻性材料復合絕緣結構的應力控制管時，電纜終端的電場分佈最為均勻。
  10. The result reveals that the stress control tube comprising a composite structure of the nonlinear resistive and capacitive material shows the best performance in uniforming the electric field distributions in cable terminations under impulse voltage

    分析結果表明，在沖擊電壓下電纜終端採用由電容性和非線性電阻性材料復合絕緣結構的應力控制管時，電場分佈最為均勻。
  11. Procedure of measurements for the electromagnetic compatibility ; measurement of conducted interference units vde specification

    電磁兼容性的測量程序.傳導干擾裝置的測定.規范
  12. The main works are listed as follows : ( 1 ) the small capacitance measuring circuit for ect based on the charge amplification principle was deeply analyzed and improved. the stray - immunity and the charge injection effect of this circuit were deeply analyzed. the influence of the charge injection effect was eliminated by practical time sequences and circuit structure differential

    本文的主要工作和創新點如下： （ 1 ）對基於電荷放大原理的微弱電容測量電路進行了深入的分析和改進，深入分析了該電路的抗雜散電容性能及電荷注入效應問題，通過時序的合理設計消除了電荷注入效應等因素對測量結果的影響，改進了該電路的數學模型。
  13. By experiments the conclusions were got that the actived carbon electrode could provide better capacitive character in 7mol / l potassium hydroxide solution after activation in ammonia

    通過大量的實驗發現氨水活化處理后的活性炭在濃度為7mol l的氫氧化鉀溶液中具有良好的電容性能。
  14. Application guide for capacitance current switching for ac high - voltage circuit breakers

    交流高壓斷路器用電容性電流開關的應用指南
  15. Further more, the distribution of electric field in cable termination is analyzed as cavities reside on the interface of a capacitive and a nonlinear resistive material

    進一步分析電纜終端中電容性和非線性電阻性材料知其分界面處含有氣隙時的電場分佈。
  16. The research is focused on the influence of the size of the coupling port, coupling line and the capacitive metal rods in cutoff waveguide on the gap impedance

    研究結果表明：模雙間隙腔連接截止波導段的耦合口的尺寸主要影響輸出腔的外觀品質因數，而耦合接頭的粗細和電容性銷釘的大小和插人深度對截止波導濾波器的調諧具有重要影響。
  17. The basic principles still apply : ground impedance must be as low as possible, high level and low level signals must be separated so that they do not interfere with each other, and capacitance and mutual inductance coupling must be avoided

    前文提到的原理仍然適用：地線阻抗要盡量小，大功率信號和微弱信號要分開布置以避免串擾，一定要避免電容性耦合和電場耦合。
  18. The antenna design is based on using capacitive loads and slits on two crossed narrow patches with via fed - through feed system, which can reduce the size of the antenna, improve the isolation between two ports and keep considerable bandwidth respectively

    通過電容性加載減小整個天線的尺寸，通過在天線上開槽來增加天線埠之間的隔離度，採用viafed - through的饋電方式。
  19. To explain this, we ' re going to avoid the idea of impedance ( which has resistive, capacitive and inductive components, some of which vary in effect by frequency, thus varying the actual loading ) and use pure resistance to describe the concept

    為了便於解釋，我們準備暫時避免使用阻抗這一概念，因為它有電阻性、電容性和電感性成分，而其中一部分會隨著頻率的變化而變化，從而改變了實際的負載。
  20. This text research the digitalization monitoring method for the medium loss of electric capacitive equipment : the harmony wave analytic approaches, and then adopt the method to test in scene. the result indicate that this method using in the medium loss testing have higher stability and accuracy

    本文研究了電容性設備絕緣介質損耗的數字化監測方法：諧波分析法，並採用諧波分析法在現場進行了測試，結果表明該方法在介損測試中具有較高的穩定性和準確性。
分享友人
分享到 Line

分享到臉書