電容電阻耦合 的英文怎麼說

中文拼音 [diànróngdiànzǔǒugě]
電容電阻耦合 英文
capacitance resistance coupling
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 耦 : Ⅰ動詞[書面語] （兩人並耕） plough side by sideⅡ名詞1 （古農具名） plough2 [書面語] （兩人一組） a...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 電容 : electric capacity; capacitance; capacity
  • 電阻 : （物質阻礙電流通過的性質） resistance; electric resistance （電路中兩點間在一定壓力下決定電流強度...
  • 耦合 : [物理學] coupling; interconnection; catena; linkage; linking
  1. Design and simulate of the single stage common emitter amplifier

    單級阻容耦合晶體管放大器電路設計與模擬
  2. The basic principles still apply : ground impedance must be as low as possible, high level and low level signals must be separated so that they do not interfere with each other, and capacitance and mutual inductance coupling must be avoided

    前文提到的原理仍然適用：地線阻抗要盡量小，大功率信號和微弱信號要分開布置以避免串擾，一定要避免電容性耦合和電場耦合。
  3. The characteristics of damping shows that the uncompensated parallel ac transmission line can release the coupling between the hvdc and generator and improve the damping of the system, hence the possibility of subsynchronous oscillation decrease. in such a system scheme, the hvdc system dominates the changes of damping due to the small magnitude of the damping provided by ac line. when the ac transmission line is compensated with a fixed series capacitor, the situation will be totally different

    其中，並列運行的無串補交流輸電線路可以緩解hvdc與其臨近機組之間的機電耦合程度，改善hvdc的電氣負阻尼特性，從浙江大學博士學位論文摘要而減輕機組發生次同步振蕩的危險性，此時系統的整體電氣阻尼特性由hvdc的性質決定;但若交流線路中存在串聯補償電容，則系統幅值較大的電氣負阻尼不僅可能使整流站機組發生次同步振蕩，逆變站附近機組同樣存在發生次同步振蕩的可能性，此時系統的整體阻尼特性由串聯補償電容的性質決定。
  4. Five different structures are described : standard transformer coupling, parafeed, resistively loaded stage capacitively coupled to the output transformer, tube ( valve ) based constant current source load capacitively coupled to the output transformer, and solid state ( mos fet ) constant current source load capacitively coupled to the output transformer

    我們將討論五種不同的方式：標準變壓器耦合；旁饋耦合；電阻性負載電容性耦合至輸出變壓器；膽恆流源負載電容性耦合至輸出變壓器；以及晶體管恆流源負載電容性耦合至輸出變壓器。
  5. Design the good - working signal processing circuit of the sensor, including the signal collecting circuit of three output polars the coupling circuit using capacitance and resistance the alternating amplify processing circuit and the stabilization voltage supply circuit

    設計了性能良好的信號處理電路（包括銻化銦磁阻三端輸出型信號採集電路、阻容耦合型交流濾波放大電路和穩壓電源電路三個部分） 。
  6. Also, we select the signal collecting circuit of three output polars, the coupling circuit using capacitance and resistance, the alternating amplify processing circuit, the positive feedback retardation comparsion, the driving circuit of output current and the stabilization voltage supply circuit

    選擇了insb磁阻三端輸出型信號採集電路，阻容耦合型交流放大電路，正反饋遲滯型電壓比較器和大電流推挽驅動電路及穩壓電源電路。
  7. By means of resistance and capacitance coupled negative feedback method to control the plasma discharge development process and prevent the transition from glow discharge to spark discharge in a pin - to - plate static air plasma generator, a stable alternative current atmospheric glow discharge is produced successfully

    在靜態大氣壓空氣針板等離子體發生器中，採用阻容耦合負反饋方法控制等離子體放電發展過程，成功地抑制了輝光放電向火花放電的過渡，產生了穩定的交流輝光放電。
  8. A fem software as an important tool, work has been done as follows : the method using fem to design anomalous structure of transducers was adopted ; the vibration modes of the elastic pipe, ultrasonic transducers and system has been analyzed in piezoelectric coupled field. resonant frequencies of the transducers have been matched quite well with resonant frequencies of pipe, which can make it easy and accurate to design a transducer. the values of equivalent dynamic capacitors and dynamic inductances of ahead nine orders have been gotten derived by fem method, and fem equivalent circuit of the transducers has been built

    以ansys有限元軟體為主要分析工具完成了設計工作;在經典換能器設計理論和前人經驗的基礎上，對不規則形狀的換能器採用了有限元的方法設計;在耦合場中分析了換能器、導管及整體裝置的振動情況，使換能器的諧振頻率與導管的諧振頻率達到了較好的匹配，使設計變得更加容易和準確;利用有限元方法建立了振子的等效電路模型，求出了其前6階模態的等效動態電容電感值，為阻抗匹配和驅動電路的設計提供了依據。
  9. The main context of this dissertation focuses on three aspects. the author simulates and optimizes the helix - slow wave structure by using the high frequency electromagnetism code cst mws, gets the results which the shape of the supports of helix impacts on the dispersion characteristic and the coupling impedance. then using ansys software, the author analyzes the thermal contact resistant will impact the thermal characteristic of the helix - slow wave structure and get the temperature of the helix slow - wave structure

    本論文主要包括以下三方面的內容:作者使用cstmws軟體對螺旋線慢波結構的夾持桿形狀進行了優化;分析了夾持桿形狀對慢波結構色散和耦合阻抗的影響，同時還分析了接觸熱阻對螺旋線慢波結構散熱性能的影響，找到了兼顧螺旋線慢波結構電特性和散熱性能的夾持桿形狀。
分享友人
分享到 Line

分享到臉書