電氣絕緣強度 的英文怎麼說

中文拼音 [diànjuéyuánqiáng]
電氣絕緣強度 英文
electrical strength
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : Ⅰ動詞(斷絕) cut off; sever Ⅱ形容詞1 (完全沒有了; 窮盡; 凈盡) exhausted; used up; finished 2 ...
  • : Ⅰ名詞1 (緣故) reason 2 (緣分) predestined relationship 3 (邊) edge; fringe; brink Ⅱ動詞(攀...
  • : 強形容詞(強硬不屈;固執) stubborn; unyielding
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • 電氣 : [電學] electrical; electric電氣安裝 electric mounting; 電氣保護 electric protection; 電氣保護裝置...
  • 絕緣 : 1 [電學] (隔斷電流) insulation; isolation; insulate; isolate 2 (跟外界不發生接觸) be cut off ...
  1. It is designed according to electrical stove or microwave oven request. heating pipe adopts high temperature resistance mgo powder as the insulation medium and the stainless steel case is passed oxidation deal through the advanced web band protection oven 1050c in order to become the a special oxidation layer and improve the high temperature oxidation and bittern corrosive performance of the heating pipe. the heating tube has high power density and strong heat radion. this product with good safe performance can work normally after 3000hrs life test

    加熱管選用耐高溫氧化鎂作介質,不銹鋼外殼經過先進的網帶體保護爐1050的氧化處理,形成一種特殊的氧化層,提高熱管的抗高溫氧化及鹽鹵的腐蝕性能。熱管的功率密較高,熱輻射能力。產品經長達3000h的壽命試驗后,仍能正常工作,安全性能好。
  2. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、阻、接地連續性、泄漏流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性(壽命)試驗、機負載試驗、源線彎折、源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  3. Standard test method for dielectric breakdown voltage and dielectric strength of insulating gases at commercial power frequencies

    在工業用頻率時體介擊穿壓和介的標準測試方法
  4. Test method for dielectric breakdown voltage and dielectric strength of electrical insulating materials under direct - voltage stress

    直流壓應力下材料的介擊穿壓和介的試驗方法
  5. All the transmission lines of west - east electricity transmitting project are inevitable to crossing the high altitude and icing areas. for the reducing of the air pressure and the absolute humidity, the electricity strength of insulators will drop obviously. therefore, it must be considered the effect on the insulators " flashover voltage caused by the change of altitude and ice when the insulation cooperation of transmission lines are being designed

    「西東送」工程的所有輸線路都不可避免的要經過高海拔和覆冰地區,由於大壓力和對濕的降低會使子的顯著下降,因此在進行輸線路的配合設計時必須考慮到海拔高和覆冰的變化對子的閃絡壓影響。
  6. Test procedure for thermal endurance of insulating varnishes - electric strength method

    漆耐熱性試驗規程.
  7. The main work and conclusion for this paper is as following : according to the flashover test results of several kinds of iced insulators under positive voltage and negative voltage, this paper obtained : for the single porcelain insulator, the single glass insulator and the composite insulator bridged completely by icicle, the metal cathode ' s strong ability of emission electron is the primary reason that results in the lower negative flashover voltage ; the position difference of the high resistance district in method anode side results in that porcelain insulator cluster and glass insulator cluster have an evident effect of polarity ; when less ice and no icicle at the brim of the sheds, due to numerous non - polar arcs on the composite surface, the effects of polarity of composite insulator was lost using the test method of the average flashover voltage in the freezing period, dc flashover performances were investigated of several insulators with some typical structures and different material

    本文的主要工作和結論如下:在人工候室內,根據不同覆冰子正、負極性下的閃絡試驗結果,得出負極性弧金屬陰極的子發射能力造成了單片瓷、玻璃子及被冰凌橋接的合成子有較低負極性冰閃壓;正極性弧金屬陽極側產生高阻區所處位置的差異使得瓷和玻璃子串具有明顯的極性效應;覆冰較少時,合成子表面出現數量較多的非極性弧使合成子無極性效應。利用覆冰期內平均閃絡壓的試驗方法,對不同材質和結構的子在覆冰、低壓和污穢共存環境中的直流閃絡特性進行了研究。試驗結果表明,直流平均閃絡壓隨著海拔的升高、覆冰量的增加以及污穢的增加而降低,且其特徵指數與子結構、覆冰量、覆冰狀態、污穢等有關。
  8. Department perfect test, which can be made into various mechanical properties such as : tension tests, strength tests slide, terminal testing ; electrical performance test items include : insulation resistance testing, contact resistance testing, testing withstand voltage, high and low test, solderability test, durability testing, vibration - resistant testing, life test

    完善之測試部,能作各項機械性能測試如:拉力測試、插撥力測試、端子測試;性能測試項目計有:阻測試、接觸阻測試、耐壓測試、高低測試、可焊性測試、耐久性測試、耐振測試、壽命測試等
  9. Alleged and auxiliary safe appliance its insulation intensity is small, can ' t bear the working voltage of electric equipment, just use the security personnel action that enhances basic and safe appliance, wait like mat of insulation stage, insulation, electric insulation glove, insulated shoes

    所謂輔助安全用具其小,不足以承受設備的工作壓,只是用來加基本安全用具的保安作用,如臺、墊、手套、鞋等。
  10. Better insulation, good mechanical strength, for use in samll gears and machinery parts

    中級性,機械高,製造小輪機械零件等。
  11. Under the conditions of high safe coefficient of insulated electrical strength of the stator winding of the generator, the selection of earthing resistance value should meet the needs of matching one - point earthing protection of the stator and limiting the fault current

    在發機定子繞組有較高的安全系數的情況下,接地阻值的選取應主要服從與定子一點接地保護的配合及限制接地故障流的需要。
  12. Jdy - 280b double electromagnetic lock product characteristic : strong holding force, no left magnet easily installed, low noise, durable no mechanical failure with signal feed back function applications : can be used with intercoms and access control systems, especially for fireproof door working voltage : 12vdc 24vdc working current : 12vdc 0. 27a, 24vdc 0. 46a power consumption : 3. 3w, 3. 5w, absolutely insulative power supply mode : successively working temperature : - 40 50 dimension : 473 x 45 x 30mm weight : 3920g yiwu qimingxing computer company copy right

    Jdy - 280b雙開門磁力鎖產品特性:吸力無剩磁安裝方便噪音低壽命長具故障保護功能,無機械故障可具資訊回饋功能鎖狀態有指示燈指示:鎖門時綠燈指示燈亮開門時,紅色指示燈亮帶鎖狀態指示燈及聯網信號輸出適用范圍:可與樓宇對講門禁系統配套使用特別適用於逃生門防火門性能:性能:使用壓: 12vdc 24vdc流: 12vdc 0 . 53a 24vdc 0 . 27a阻測試: dc500v 1分鐘無擊穿通形式連續使用溫: 40 50外形尺寸: 473 x 45 x 30mm重量: 3920g
  13. Insulating and sheathing materials of electric and optical cables - common test methods - methods specific to polyethylene and polypropylene compounds - tensile strength and elongation at break after conditioning at elevated temperature - wrapping test after conditioning at elevated temperature - wrapping test after thermal ageing in air - measurement of mass increase - long - term stability test - test method for copper - catalyzed oxidative degradation

    纜和光纜的和護套材料.通用試驗方法.聚乙烯和聚丙烯化合物專用方法.高溫處理后抗拉和斷裂伸長.高溫處理后的卷繞試驗.在空中熱老化后的卷繞試驗.質量增加的測量.長期穩定性試驗.催化銅氧化降解的試驗方法
  14. Rotating electrical machines - part 18 : functional evaluation of insulation systems - section 33 : test procedures for form - wound windings - multifactor functional evaluation - endurance under thermal and electrical stresses of insulation systems used in machines up to and including 50 mva and 15 kv

    旋轉機.第18部分:系統功能評定.模繞組的試驗步驟.功率小於等於50mva , 15kv系統的應力和熱應力的
  15. Can divide roughly it is two kinds big, namely basic and safe appliance and auxiliary and safe appliance, alleged and basic safe appliance is insulation intensity big, can bear for long the working voltage of electric equipment, can use an operation directly electrified equipment, wait like pincers of insulation lever, insulation

    大體可分為兩大類,即基本安全用具和輔助安全用具,所謂基本安全用具是大,能長時間承受設備的工作壓,能直接用來操作帶設備,如桿、夾鉗等。
  16. Better insulation, good mechanical strength, for use in small gears and machinery parts

    中級性,機械高,製造小輪機械零件等。
  17. Mechanical endurance functional tests for electrical insulation systems

    裝置用的機械疲勞函數試驗
  18. Insulation systems of electrical equipment ; mechanical endurance functional tests for electrical insulation systems ; identical with iec 60941 : 1988 report

    設備系統.系統機械疲勞功能試驗
  19. Abstract : abstract : it is intended to promote the understanding of about safety principles through the relation of safety with electric insulating materials ' characteristics such as dielectric strength, moisture absorption, heat resistance, fire resistance and mechanical strength, in order to ensure that the electronic products can be manufactured and used safety

    摘要:摘要:通過論述材料的介、吸濕、耐熱、阻燃和機械方面的性能與安全的關系,加深對安全原則的理解,以保證子產品在生產、使用過程中的安全性。
  20. It can remove water content, gas, impurity in oil and enhance withstand voltage, ect performances

    能迅速脫除油中的水分體和雜質,恢復提高油的耐壓等使用性能。
分享友人