電池升壓 的英文怎麼說

中文拼音 [diànchíshēng]
電池升壓 英文
battery boost
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 名詞1 (池塘) pool; pond 2 (旁邊高中間窪的地方) an enclosed space with raised sides 3 (舊指劇...
  • : Ⅰ動詞1 (由低往高移動) rise; hoist; go up; ascend 2 (等級提高) promote Ⅱ量詞1 (容量單位) lit...
  • : 壓構詞成分。
  • 電池 : [電學] cell; battery; element; electric battery
  1. Finally, because high - speed power solenoid valve is one of the most important executive parts in the electronic control diesel engine and the performances of diesel engine are strongly related to the solenoid valve, the response performance of the solenoid valve is investigated. the response performance of the solenoid is influenced by many factors, such as driving voltage, electric driving unit etc. in order to have high excitation voltage and in low maintaining voltage, a high - low voltage electric driving unit is designed, and in order to make the solenoid valve close more rapidly, an active free - wheeling circuit and a bootstrapping circuit are designed in the electric driving unit, too. in the high - low electric driving unit, high voltage and low voltage are supplied by the dc - dc device and by the accumulator respectively

    高速強力磁閥的響應性能除了與閥本身的結構和材料有關外,與驅動、驅動路的設計密切相關,本文通過分析,首先開發出一種高低驅動路,高源是山式dc - dc原理獲取的,低由蓄本身提供,實現高強激和低維持的功能,路中採用有源續流柴汕機中卜軌知介系統的設訓及其七川j敝略的叭究路進行續流,加誣了磁閥的關閉速度;採用自舉吐路,降低了場效應管對驅動的要求。
  2. When the batteries are treated by hydrophobia of 4 % ptfe concentration, the cycle life and voltage plateau improves. internal resistance increase with the increase of ptfe concentration

    4的ptfe乳液憎水處理提高了的循環壽命,但平臺衰退有所加快,憎水處理后內阻隨ptfe乳液濃度的高而增大。
  3. After which, the battery will be charged by large constant current to allow the fast charging. finally, the constant voltage charging is adopted to guarantee the battery was charged to its full capacity. under the condition that the temperature has raised to a certain threshold at the constant current charging stage, the over temperature circuit is performing and it provides a compensation current which switches the system to constant temperature charging mode with the intention of protecting the ic

    即在充初期採用較小的流對進行預處理,對出現過放進行修復和保護;然後採用較大的恆定流對,實現快速充的目的;最後採用恆定,確保充滿;在恆流充階段,當晶元溫度上到一定程度時,晶元過熱保護路開始工作,該路以提供充補償流的形式使充進入恆溫充模式,對晶元進行保護。
  4. By recharging voltage recharge current vary, and as for the recharge gradually increases, not because of battery heating period and declined slightly

    因充流不同而異,並隨充的進行而逐漸上,到未期因發熱而略有下降。
  5. We have made a full theoretical analysis of the wave property and the wave parameters of the flap - type wave generator in the towing tank of our school, and confirmed that should make the factor that the performance of the wave generator give play to normally to influence. in allusion to that the old wave generator can not simulate sea wave, upgrade and transform to this system change the control computer system and install additional d / a change card, redesign the wave control interface and transmission means of control signal, give up the disk machine that can not be used, make the wave - making control voltage signal that has translated direct input the wave controller, make wave controller to make waves through servo system

    對我校船模水原有的搖板式造波系統的性能進行了理論分析,針對水原有造波機系統模擬海浪的不足,對該系統進行級與改造,更換了主控計算機並加裝d a轉換卡,重新設計了造波控制信號的介面與傳輸方式,捨去了原系統中現已淘汰的磁盤機,使轉換后的造波控制信號直接輸入到造波控制器中,再由造波控制器通過液伺服系統驅動造波板進行造波。
  6. The result shows that, when the full - bridge power converter is joined with boost / buck dc chopper in parallel, it can serve a dc voltage of over 340v and a power of 800w, meanwhile, as output voltage of the fuel cells changes due to loadings, the sliding - mode controller can cause more rapid responses and robustness to the dc bus voltage source

    實驗結果顯示,本論文之全橋式功率轉換器與/降直流截波器並聯供時,輸出可達340v以上,輸出功率約為800w ,同時,當燃料之輸出因負載而改變時,本論文所提出之滑動模式控制器能使直流鏈具有較快速的響應及強健性。
  7. Many measures were adopted to decrease bombard in order to improve the solar cells propertivity, such as decreasing target voltage, increasing target distance, accelerating the movement of the substrate. by optimizing the experimental conditions, short - circuit current was increased by 3. 7ma / cm2, the conversion efficiency was increased by 2 %, the stability was improved

    在硅薄膜的zno : al al背反射極應用方面,通過減小靶、適當增加靶距和基片的運行速度來減小對的轟擊,改善性能,通過優化實驗條件,使的短路流提了3 . 7ma cm ~ 2 ,效率增加了2 ,穩定性得到改善。
  8. Chapter 5 describes how to design fuzzy control rulers by reverse pulse algorithm, which solves the problem of fast charging on the storage battery. this method is applied to improve the efficiency of power conversion and shorten the charging time

    第五章從蓄快速充理論出發,根據馬斯定律,以和溫作為控制變量,運用反向脈沖模糊控制演算法對蓄快速充進行模擬,用以提高能轉換效率,縮短充時間。
  9. Battery bottom plumping up, belly protruding, even leakage, what are possibly the causes

    充滿時,溫度為什麼會急為什麼會突降?
  10. Compared with the lithium ion batteries using untreated graphite as anode material, those using modified graphites as anode materials have larger capacity, higher discharge voltage and better cycling capability

    以熱處理或摻雜改性石墨為負極的鋰離子的放容量增加,放中值高,循環性能顯著提高。
  11. Battery charging booster

    用的
  12. Battery boost charge

    電池升壓
  13. In designing the stage controlling system, brake motors are used in place of traditional hydraulic power transmission, combined with frequency conversion technique, computer controlling technique, realizing the smooth control over the elevating orchestra. on - the - spot debugging and operation show that it is desirable in effect, reliable in operation, smooth in starting and stopping, accurate in leveling with the surface of the stage, thus, fulfilling the anticipated requirements

    在設計舞臺控制系統中,本文用制動機傳動取代了傳統的液傳動,並結合了變頻技術、計算機控制技術,實現了對樂降的平穩控制,經過現場調試和使用,控制效果理想,運行可靠,啟動停止平穩,平層準確,達到了預期的要求。
  14. Make sure your batteries are fresh, or that you are using an optional ac adapter to prevent power interruptions during the update process

    確認你的已經充滿,或者使用ac變器供,以防止在級的時候斷
  15. Battery booster cables

    電池升壓
  16. Under certain soc, the inner pressure will increase non - linearly with the increase of the ratio of positive capacity to negative capacity

    在相同荷態下,隨著ni / mh正負極容量比的增大,會逐漸上,但是非線性的增大。
  17. When reducing the discharge cut - off voltage of the second, the third, the forth step to 850 mv during activation, discharge capacity is improved remarkably, increasing about 24 mah. but middle point voltage decreases and internal resistance increases about 1 mq

    ( 2 )化成時降低第二、三、四步放截止到850mv ,能顯著提高容量,提高幅度達24mah左右,但中點有所降低、內阻也高了將近1m ( ) 。
分享友人