電流平衡 的英文怎麼說

中文拼音 [diànliúpínghéng]
電流平衡 英文
current balance
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 平 : Ⅰ形容詞1 （沒有高低凹凸 不頃斜） flat; level; even; smooth 2 （高度相同; 不相上下） on the same l...
  • 衡 : Ⅰ名詞1 （秤桿） the graduated arm of a steelyard2 （稱重量的器具） weighing apparatus3 （姓氏） a...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. Balancing switch current of dynamotor using ta

    平衡發電機開關電流
  2. A device for equalizing pressure or strain

    均衡器用來使電壓或電流保持平穩的設備
  3. The sensor used unbalanced principle of alternating electric field around feed cable to detect the state of electric field of cable core over the ground, thereby got out the result that the feed state of cable in mine had no relation to the current in the cable

    該傳感器利用饋電電纜周圍交替電場的不平衡原理檢測電纜芯線對地的電場狀態，從而間接檢測出礦井電纜的饋電狀態與電纜是否有電流無關。
  4. Monitor apparatus can measure valid value of three phase voltage and current, power factor, three phase disequilibrium, instant flecker of short time and harmonic without twenty, degree and harmonic distortion total. the paper are laid on the following. ( 1 ) master plan and function of circuit, ( 2 ) hardware design including circuit and principle of a / d conversion, phase lock, liquid crystal display and keystroke and so on, ( 3 ) design of system software including digital filtering, fft, a / d conversion and monitor interface of pc, ( 4 ) system test

    監測儀能夠完成包括三相電壓、三相電流的有效值、功率因數、三相不平衡、電壓短期閃變、以及20次內的諧波、諧波相位、諧波失真總量等的測量。論文重點介紹了以下幾部分： （ 1 ）電路的總體設計和功能； （ 2 ）硬體設計，包括a d轉換、鎖相環、液晶顯示和按鍵輸入等原理和電路。 （ 3 ）系統軟體設計，包括a d轉換、 fft 、數字濾波等程序的原理和演算法以及上位機監控界面的設計； （ 4 ）系統測試。
  5. When the galvanometer reads zero the circuit is in the null-balance position.

    當檢流計的讀數為零時，電路處于零平衡位置。
  6. Being added an anti - phase compensating winding, this device, which is placed between high voltage line and first insulator, makes the synthesized magnetic field in magnetic core reach a dynamic balance, and thus solves the problems from remanence and assures the measurement accuracy

    其漏電流傳感器增加一個反相的補償線圈，使得電流傳感器磁芯內的合成磁場達到動態平衡，解決了由於剩磁而帶來的問題，保證了測量精度。
  7. This paper starts the research of the liquid floated pendulous accelerometer testing system according to the engineering. at first, this paper gives the brief introduction of the history and present status of accelerometer and its testing technology, the working principium and math model of the liquid floated pendu - lous accelerometer, and then, decides the binary width pulse force retrim loop as the design proposal of testing system, researches the transfer function of every part in the system emphasizly, analyses the stability of the whole accelerometer testing system from the angle of control theoretics by the open loop transfer function of system, and designed the correcting net, analyses the basal problems such as resolution, sampling restraint, precision and so on, designs the hardware testing circuits such as preamplification, band - pass filter, alternating amplifier, phase sensitive demodulatorn, pulse - width modulation, frequency scale circuit, moment current generator. finally, using the graphics program language labv - iew which is designed for testing field especially by ni accomplishes the solfware design of testing system, realized the testing functions

    首先對加速度計及其測試技術的發展歷史和現狀，液浮擺式加速度計的工作原理和數學模型等作了簡要的介紹，然後確定了以二元調寬脈沖再平衡測試迴路為設計方案，並從控制理論的角度進行了分析，著重研究了系統中各部分的傳遞函數，利用系統開環傳遞函數分析了系統的穩定性，同時設計了系統的校正網路;分析了二元調寬脈沖再平衡測試迴路的解析度、采樣約束以及測試精度等基本問題，並按照系統分析的結果設計了包括前置放大、帶通濾波、交流放大、相敏解調、脈寬調制、頻標電路以及力矩電流發生器等測試系統各部分硬體電路，驗證了電路的正確性，最後按照測試系統的要求，採用了美國ni公司專為測試領域所開發的虛擬儀器工具? ? labview作為測試軟體開發工具，利用該圖形化編程語言完成了測試系統軟體部分的設計，實現了測試功能。
  8. By constructing the geometrical model of a certain underground single arm type pantograph and applying the translation of pantograph - head balancing bar and the perpendicular displacement of pantograph in the direction of the movement of locomotive while raising pantograph as the objective which must satisfy the demands of locomotive ' s stable current collection, this paper applied the multi - objective optimization based on the genetic algorithms to design the pantograph mechanism

    摘要在建立某地鐵單臂受電弓簡化幾何模型的基礎上，根據列車平穩受流對受電弓提出的各項要求，以受電弓升弓時機車前進方向上的縱向偏移量和弓頭平衡桿的平動為目標，以受電弓正常升弓所需升弓轉矩等為約束，運用基於遺傳演算法的多目標優化技術，對該型受電弓機構進行了優化，得到了使受電弓運動性能達到最優的幾何參數。
  9. Again, small dc shifts in the black level caused by residual sync can disturb the color balance or gains of the video channels

    同樣，由於殘留的同步信號而導致的黑電平上很小的直流偏移依然能夠影響顏色的平衡和各個視頻通道的增益。
  10. Unbalanced current generated in differential protection of main transformer and its countermeasure

    主變差動保護不平衡電流產生及應對措施
  11. The carrier wave is modulated directly by the baseband signal at several frequency point in l band and s band. firstly, this paper clarifies the theory of i / q modulation, elaborates evm and acpl, and analyzes the effect of amplitude and phase unbalance and dc offset on evm. secondly we review the basic principle of phase locked loop and it ’ s composing parts, including the basic conception and design method of pll frequency synthesizer, especially introduce the charge pump pll frequency synthesizer in detail

    首先，在闡述i / q正交調制基本原理的基礎上，通過對誤差矢量和鄰近通道功率泄漏的詳細分析，定性、定量地討論了各種非理想電路因素（如相位不平衡、幅度不平衡、直流偏差等）對調制器性能的影響;其次，介紹了鎖相環的工作原理和基本組成部分，包括鎖相環的設計和環路濾波器的設計，特別詳述了電荷泵鎖相頻率源;第三，介紹了採用直接調制技術模擬衛星信號的射頻前端的設計;最後，對整個直接射頻調制系統進行測試，結果基本上達到了課題要求。
  12. This paper focuses on the control strategies to improve the performance of the three - phase ac - dc pwm voltage - source - converters ( vsr ) under unbalanced power supply. the problems such as negative sequences current, voltage and current harmonics and un - constant ( un - smooth ) power flow from ac to dc side are discussed in this paper. the analytical solutions for negative sequence current and harmonic current elimination are obtained by fully feed - forward of negative sequence voltage and producing a non - harmonic current command of the inner - loop

    電網不平衡時，基於電網平衡為約束條件設計的三相vsr將出現不正常運行狀態，比如三相vsr交流電流中出現負序分量，使交流電流嚴重不對稱；直流電壓和交流電流中出現非特徵諧波分量，使直流電壓和交流電流波形發生嚴重畸變；三相vsr從電網吸收不平衡的瞬時功率等一系列問題。
  13. The fuel cells models are presented in chapter 3. based on the balance conditions in fuel cells stack, the dynamic performance is analyzed. the dynamic model is developed with a set of correlation equations of voltage, fuel utilization, current density and other variables involved in the operating course, which are some partial differential equations with variable coefficients

    第三章以熔融碳酸鹽燃料電池為例，以數值分析的方法，根據mcfc電堆發電過程中物質與電量平衡，分析了電堆的內部動態特性，就輸出電壓與燃料氣體利用率和電流密度等相關量建立了由一組變系數偏微分方程和積分方程描述的數學模型。
  14. Aiming at the feature of cm interference in power converters, a new approach ? intrinsic dynamic nodes potential balance is proposed. by building node pair with balance potential and making use of the intrinsic stray capacitor of power semiconductor devices, the cm current can be suppressed effectively

    在對共模干擾建模的基礎上，提出了內在動態節點電位平衡的思想，其思路是通過在電路內部構造動態電位平衡節點對，並利用電路中功率器件固有的對地分佈電容使得電路中的共模干擾電流互相抵消，從而抑制功率變換器的共模emi 。
  15. On the basis of the analysis on spwm modulation mode and transient current control theory, a new method of voltage balance on the capacitors in dc side is proposed, and computer simulation is carried out in matlab

    在分析了spwm調制方式和瞬態電流控制原理的基礎上，提出了一種直流側兩電容上電壓平衡的方法，並在matlab環境下進行了計算機模擬。
  16. Current balance type

    電流平衡式
  17. The error and model of current balance passive and active tdm were investigated systematically

    深入地研究了電流平衡式無源及有源積分時分割乘法器的數學模型及誤差。
  18. Ac power balance relay

    交流電力平衡
  19. Study on mathematical model and lyapunov - based control for three - phase four - wire three - level npc voltage - source rectifier

    整流器雙環控制技術及中點電壓平衡控制技術的研究
  20. The simulation results show that with the method, the capacitor voltages in the dc side are balanced effectively and the switch frequency reaches requirement

    模擬結果表明：在合理選擇電壓平衡系數的情況下，該方法不僅能夠有效地平衡直流側兩電容上的電壓，也能夠使開關頻率滿足要求。
分享友人
分享到 Line

分享到臉書