電流換向 的英文怎麼說

中文拼音 [diànliúhuànxiàng]
電流換向 英文
current reversal
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. All - round review and presentation of the capability of commutation

    直流電機換向性能的綜合評述
  2. For electrodeposition by dc methods, the metals deposite uninterrupted and the particles were also embeded uninterrupted into the coatings ; for electrodeposition by pc method, the particles with biggish volume were desorbed from the coatings and returned to the electrolyte again owing to the presence of pulse interval ; for electrodeposition by prc method, the particles carried positive charges are much more easy to desorb from the coatings owing to the effecf of reverse pulse current combined with pulse interval, in addition, the reverse pulse current also could dissovle the metals, further accelerates the desorption of particles, thus the particles size embeded in the coatings by prc method is the least

    直流電沉積時，基質金屬的沉積連續進行，粒子在電極表面不間斷嵌入鍍層;單脈沖電沉積由於脈沖間歇的存在使得具有較大體積的粒子會脫附，重新回到溶液中;採用周期換向脈沖時，反向脈沖電流使表面荷正電的較大的粒子更易從電極表面脫附，同時，反向脈沖電流對基質金屬的溶解作用，也會促進粒子的脫附，因此鍍層中復合粒子尺寸最小。隨著鍍層中粒子復合量的增加，三種鍍層的晶粒都明顯細化，說明al _ 2o _ 3的存在阻止了晶粒的長大，提高了電沉積過程中晶核的形成速率。
  3. Auto classification of dc - electromotor sparks

    直流電機換向火花的自動分級
  4. Based on the thorough investigation of the post - regulation and efficiency in multiple output switching - mode power supplies, an optimal combination topology for multiple output switching converter is presented in this thesis, which is consisted of forward converter with active clamp ( fac ), synchronous rectification ( sr ) techniques and magnetic amplifier technique ( magamp )

    本文通過研究分析近年來多路輸出開關電源輔助輸出電壓調節和提高效率的方案，面對開關電源朝著輸出低電壓大電流方向發展的趨勢，提出多路輸出開關電源新的拓撲優化組合模式? ?有源鉗位正激變換器、同步整流技術、磁放大器。
  5. Maintenace of commuator of dc traction mo - tor

    直流牽引電動機換向器的維護
  6. In the paper, on the basis of research of static state and transient state in the scr and series connection valve circuit, the high voltage scr changing current valve device has been developed for ac - dc - ac high voltage commutatorless motor. the series connection valve circuit has been designed and simulated. the hardware design and software programming of trigger pulse system and monitoring system in the photo - electronic - photo fashion has been completed

    無換向器電動機在火電廠等工礦企業的電機調速節能領域中有十分廣闊的應用前景，本文在對晶閘管元件和串聯閥電路的靜態特性和動態特性研究的基礎上，研製了用於交直交電流型高壓無換向器電動機的高壓晶閘管換流閥裝置，進行了串聯閥電路的設計和模擬，完成了電光電方式的觸發脈沖系統和監測系統硬體設計及軟體編程，並進行了裝置的實驗調試。
  7. The commutators of motors are critical parts for the current transfer in motors, the accuracy of the commutators will directly effect the efficacy and life expectancy of the motors

    換向片是馬達中控制電流換向的重要元件，其精度將直接影響馬達的壽命及效能。
  8. Third, this thesis analyzes the angle - control theory based on half bridge converter, and proposes a new way to find the optimized angle. simulation is performed to verify the results. then, this thesis introduces the hardware and software design of the digital control system of doubly salient electro - magnetic motor, which mainly discusses the speed and current loops and angle optimization control

    再次，本文介紹了角度控制與電機轉向的關系，並對基於半橋變換器的電勵磁雙凸極電動機換相角與相電流及輸出轉矩的關系進行了理論分析和模擬驗證，提出了優化電勵磁雙凸極電機換相角的方法。
  9. Conventional hard switching technology has several flaws below : on and off loss, inductive off, capacitive on and diode recover problems. comparing with it, the loss of on and off decreases markedly, as the switches are on and off in zero voltage or zero current cases. and also the size of converter becomes smaller because of the higher of switching frequency

    傳統硬開關技術由於存在開通關斷損耗大、感性關斷、容性開通、二極體反向恢復等問題，與之相比，軟開關技術在零電壓或零電流條件下導通，開關損耗明顯降低，加上開關頻率的提高使得變換器的體積得以減小，這也是軟開關技術受到青睞的原因。
  10. Design engineers now selecting pmbldc motors over conventional dc or induction motor drives for the following reasons : 1 ) the absence of brushes results in an essentially maintenance free operation and eliminates the undesirable effects of commutation such as sparks, brush - loss, radio - frequency interference, etc. 2 ) the low inertia of the rotor enhances the quality of the mechanical response of the motor, shortening the acceleration and deceleration time. 3 ) utilizing rare - earth permanent magnet materials with high coercive force results in substantially higher efficiency than their counterpart with brushes of the same size. 4 ) because of the absence of commutation segments, the stator construction is simple

    現在的工程師們更為青睞永磁無刷直流電動機是因為以下幾點原因： （ 1 ）去除了電刷的永磁無刷直流電動機徹底地免除了維護而且消除了我們不希望的由於換向帶來的火花、電刷損耗以及無線電干擾等等； （ 2 ）低轉動慣量的轉子提高了電機機械響應的質量，從而縮短了電機加速和減速的時間； （ 3 ）高矯頑力稀土永磁材料的使用使得同樣尺寸的永磁無刷直流電動機比傳統的直流電動機效率高； （ 4 ）由於沒有機械換向部分定子的結構簡單了。
  11. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流，兩者產生的偏置磁場在控制線圈產生感應信號，檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號，該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號，再由pid控制器轉換為轉子位移的控制信號，最後控制信號輸入功放電路產生控制電流，實現閉環控制。
  12. The direction of the current is reversed.

    電流方向倒換。
  13. A commutator - brush combination is used as a mechanical rectifier to make the armature terminal voltage unidirectional and also to make the mmf wave due to the armature current fixed in space

    通過使用換流器電刷的組合作為一個機械整流器以使得電樞的端電壓為單方向的同時也使得由電樞電流所產生的磁動勢在空間是固定的。
  14. It throughly solved some long time complicated questions such as high service rate in dc motor, large quantities of maintaining contact type drive controller, high energy consumption of dc locomotive

    徹底解決了直流電機維修率高、換向火花及接觸組火花大、觸頭式司控器維修量大、直流電機車能耗高等老大難問題。
  15. As a non - linear and multi - coupled system, the control of the ac induction motor ( acim ) has long been challenging. thanks to the vector control algorithm, acim can offer the same control capabilities and dynamic performance as traditional high - performance dc motors. with the vector control algorithm, the stator current of acim can be expressed in two orthogonal axes, and thus the rotor flux part and torque are de - coupled

    交流感應電機難于控制是因為它是一個非線性、多耦合的系統，矢量控制演算法通過坐標變換將異步電機的定子電流分解為轉子磁鏈方向和與之垂直方向的兩個分量分別進行控制，從而實現轉子磁通和轉矩的解耦，使得交流感應電機的動態性能可以和直流電機媲美。
  16. The permanent magnet brushless dc motor is a dc motor using electronic commutation in place of mechanical commutation in fact, so it has excellent characteristics of dc motors, for example good start and timing performance. it simplifies the motor ' s structure and overcomes the friction disadvantages of ordinary dc motor because it does n ' t use mechanical commutation. it is extensively used in aviations, robots, digital machine tool and so on

    永磁無刷直流電動機實際上是以電子換向代替機械換向的直流電動機，因而保持了直流電動機的優良特性，具有較好的起動和調速性能，又因它無需機械換向器使電機的結構簡單，可以從根本上克服一般有刷直流電動機易於產生換向火花的弊病，在航天、機器人、數控機床等許多工業領域已得到廣泛應用。
  17. The permanent magnet brushless dc motor is a dc motor using electronic communication in place of mechanical communication in fact, so it has excellent characteristic of dc motors, for example good start and timing performance. it simplifies the motor ' s structure and overcomes the friction disadvantages of ordinary dc motor because it does n ' t use mechanical communication. it is extensively used in aviations, robots, digital machine tool and so on

    永磁無刷直流電動機實際上是以電子換向代替機械換向的直流電動機，因而保持了直流電動機的優良特性，具有較好的起動和調速性能，又因它無需機械換向器使電機的結構簡單，可以從根本上克服一般有刷直流電動機易於產生換向火花的弊病，在航天、機器人、數控機床等許多工業領域已得到廣泛應用。
  18. Current reversing key

    電流換向開關
  19. It elaborates on the 3 - step start technique. i adopt the method which permits the bldc motor to automatically search the best time to change its operation stage from a separately controlled synchronous one to a self controlled one using the back emf as the commutation signal. this method prevents the stepping out and stopping problems in the changing procedure of the motor

    闡述了電機的三段式起動方法，在直流無刷電機由起動階段外同步運行切換到反電勢換向自同步運行的過程中採用了自尋最優點切換的方法，保證了電機在切換過程中不會發生失步和停轉現象。
  20. Analysis and attenuation on commutation torque ripples of brushless dc motor

    無刷直流電機換向轉矩脈動分析與抑制
分享友人
分享到 Line

分享到臉書