電磁變換器 的英文怎麼說

中文拼音 [diàncíbiànhuànqì]
電磁變換器 英文
electromagnet transducer
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 磁 : 名詞1. [物理學] （磁性; 能吸引鐵、鎳等的性質） magnetism 2. （瓷） porcelain; china
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 電磁 : [電學] [物理學] electromagnetism電磁安（培） abampere （電磁系電流單位）; 電磁泵 electromagnetic ...
  1. Based on the thorough investigation of the post - regulation and efficiency in multiple output switching - mode power supplies, an optimal combination topology for multiple output switching converter is presented in this thesis, which is consisted of forward converter with active clamp ( fac ), synchronous rectification ( sr ) techniques and magnetic amplifier technique ( magamp )

    本文通過研究分析近年來多路輸出開關電源輔助輸出電壓調節和提高效率的方案，面對開關電源朝著輸出低電壓大電流方向發展的趨勢，提出多路輸出開關電源新的拓撲優化組合模式? ?有源鉗位正激變換器、同步整流技術、磁放大器。
  2. Compared to the traditional converter, the new one can transform electric power from a static part to a rotary part without an electrocircuit connection, which makes the contactless power transform come true. one application of this converter is to supply a steady and regulable excitation circuit for synchronous generator by integrated its second winding with the motor while its primary winding is static. the thesis gives two methods of the rotating converter design paticullarly : flyback and fullbridge, and explains how the circuits are designed

    通過理論分析、模擬分析和實驗驗證，得出這兩種旋轉變換器都能進行感應電能傳輸，但它們的傳輸功率是不同的，反激式旋轉換器最大隻能傳輸幾十瓦功率的感應電能，因此只能用在感應電能傳輸較小的場合，或者信號傳輸的場合;而全橋式旋轉變換器能傳輸較大的功率，可用於電機的新型無刷勵磁方案中。
  3. The thesis includes two parties : research on 2kw multi - function ac excitation power and study on high voltage high power ( hh ) dc / dc full - bridge converter

    論文包括兩個部分： 2kw多功能交流勵磁電源研製和高壓大功率dc dc全橋變換器研究。
  4. Third, this thesis analyzes the angle - control theory based on half bridge converter, and proposes a new way to find the optimized angle. simulation is performed to verify the results. then, this thesis introduces the hardware and software design of the digital control system of doubly salient electro - magnetic motor, which mainly discusses the speed and current loops and angle optimization control

    再次，本文介紹了角度控制與電機轉向的關系，並對基於半橋變換器的電勵磁雙凸極電動機換相角與相電流及輸出轉矩的關系進行了理論分析和模擬驗證，提出了優化電勵磁雙凸極電機換相角的方法。
  5. And the simulation results show the validity of the method. since a dc / dc converter running in chaotic state can improve its emc, we can make engineering application

    由於工作在混沌狀態的dc / dc變換器能夠提高電路的電磁兼容性能，因此其中的混沌現象有潛在的工程應用價值。
  6. Study on field - oriented control of a doubly - fed electric machine fed by matrix converter

    矩陣式變換器勵磁的雙饋電機磁場定向控制研究
  7. In relation to computers, the term is applied to a read / write head, to detector of sector marks in a magnetic disc system, and to electronic / sonic pulse converters of delay line memory

    在與計算機有關時，這個術語用在磁盤系統中的讀寫磁頭、扇面標記的檢測上，以及用在延遲線存儲器的電子或聲波脈沖變換器上。
  8. A device for converting energy form one form to another. in relation to computers, the term is applied to a read / write head, to detector of sector marks in a magnetic disc system, and to electronic / sonic pulse converters of delay line memory

    把能量從一種形式轉換成另一種形式的裝置。在與計算機有關時，這個術語用在磁盤系統中的讀寫磁頭、扇面標記的檢測上，以及用在延遲線存儲器的電子或聲波脈沖變換器上。
  9. Considering the above control strategies which make the controller can not be real - time processing because its workload has increased, control circuits of the main switches based on eprom are designed, which can implement control scheme of firing angles and phase voltage. furthermore, it avoids power converter saturation in the process of commutation

    上述控制策略的引入造成控制器運算量增大、難以在線實時控制，又設計了基於eprom的主開關器件通斷控制電路，實現了開關磁阻電動機開通關斷角控制及對施加於相繞組上電壓的優化控制，同時避免了換相時可能引起的功率變換器飽和現象。
  10. Firstly, the thesis briefly introduces the key techniques relating to the power module, and points out that the magnetic - integration technique can improve the performance further. secondly, the characteristics of active - clamp forward converter are analyzed, and the notion of flux - coupling is proposed to derive the im - fac converter

    論文首先簡要介紹模塊電源及主要的幾種關鍵技術，指出模塊電源中應用磁集成技術可進一步提高其性能;接著分析了有源箝位正激變換器的工作特點，提出磁通有效耦合的思路，並據此得出im - fac變換器。
  11. Calibration specification for magnetical coupling measuring

    磁耦合直流電流測量變換器校準規范
  12. Based on comparison of several motor candidates, doubly salient permanent magnet ( dspm ) motor is a good choice for it ’ s outstanding performance. similar to conventional drive system, dspm brushless dc motor ( dspm - bldcm ) is composed of dspm motor and it ’ s controller. the controller is made up of three - phase full - bridge inverter, driver, dsp control unit and etc. for high power system, every switch of three - phase inverter is actually made up of four mosfets in parallel

    在充分考慮國內外不同的液壓泵電動機的基礎上，本文選用了雙凸極永磁電機作為整個系統的電機本體，並配以電動機控制器（控制器包括三相橋式功率變換器、驅動電路、 dsp主控單元、電流采樣及預處理和位置采樣及預處理等主要部分）組成整個液壓泵電動機系統。
  13. In this paper, the working principle of the interleaving two - transistor forward converter is analyzed in detail, and the waveforms of the switch drain - to - source voltage and transformer magnetizing current are researched in different duty cycle conditions. the simulation model is constructed and the simulation results verify the analysis

    本文分析了交錯並聯雙管正激變換器的工作原理，研究了在不同占空比條件下開關管的漏源電壓和變壓器勵磁電流波形，建立了模擬模型，模擬結果證明理論分析的正確性。
  14. The operation principle is analyzed, the influence on fac converter introduced by im is described and the design rule of im is presented

    詳細分析了該變換器的工作原理，討論了磁集成技術對電流脈動、變換器效率的影響，並給出磁件設計依據。
  15. Non - destructive testing of steel tubes - part 4 : automatic full peripheral magnetic transducer flux leakage testing of seamless ferromagnetic steel tubes for the detection of transverse imperfections

    鋼管的無損檢驗.第4部分:檢測橫向缺陷用無縫鐵磁鋼管的自動全周邊電磁變換器漏磁檢驗
  16. The basic working principles and characteristics of srm will be described firstly in this paper, as well as its developing survey and researching directions. and then the srd system will be separated into several function parts to be introduced respectively in details : ( 1 ) to analyze the basic characteristics of the srm including electromagnetism, current and torque of every angle field of the rotor based on the subsection - linearized inductance characteristics of stator windings and several idealized supposes. ( 2 ) how to design and realize the h - bridge converter, and the method to use it ; ( 3 ) how to design and realize the controller based on dsp ( tms320f240 ) and the control strategies, as well as the program ; ( 4 ) to introduce the monitor program running in a pc, which is programmed by delphi

    本文首先介紹了srm的基本工作原理和特點以及srd系統發展概況和研究方向，然後以srd的功能構成為線索分部分進行介紹： （ 1 ） srm的特性及控制策略分析，在電感分段線性化等簡化條件下分析得出了各個轉子位置角度區間的電磁、電流和轉矩特性並分析了控制策略； （ 2 ）分析設計了h橋式功率變換器的設計和工程實現的方法，並設計了基於這種功率變換器的換相邏輯； （ 3 ）分析設計了以dsp為核心的控制器以及控制方法，並介紹了該控制器的軟硬體實現； （ 4 ）介紹了如何用delphi編制實現上位機監控程序。
  17. Study on the control system of ac excited generator fed by matrix converter

    矩陣變換器供電的交流勵磁發電機控制系統的研究
  18. The other is supported by emerson network power co., ltd as an advanced research project. and this paper mainly introduces how to design and realize a four - quadrant running srd system to control a 3kw srm ( 8 / 6 poles ) based on a dsp ( tms320f240 ), which uses h - bridge power convertor and power - consumption braking method

    本文基於省重點科研項目「開關磁阻電機新型控制及其調速系統」和深圳emerosn網路能源公司預研部項目，分析討論了如何設計實現一套以3kw的四相（ 8 6極） srm為控制對象以dsp為控制核心採用h橋式功率變換器和能耗制動方式的四象限運行srd系統。
  19. With the best modulation strategy which was found on condition that it must have largest energy transfer ratio, smallest current ripple of the inductor, and realizing zvs of each switches, the converter overcomes the drawbacks presented by the conventional zvs fb converter, such as high voltage stress of each switches, large current ripple of the inductor, and severe parasitic ringing on the rectifier diodes, so it can get higher efficiency, faster respond speed, and wider application area. the operation principle of the proposed converter is analyzed and verified by a 3kw, 50khz experimental prototype. experiments and research results show that the scheme of the tl topology derivation is reasonable, adjusted modulation strategy makes some other severe problems in conventional topologies easy to solve or makes the converter more competitive

    研究結果表明，本文提出的三電平拓撲變換方案合理，針對各種三電平拓撲尋找到的控制策略可以解決變換器存在的某些問題或使變換器表現出更突出的優勢：例如針對單管直流變換器三電平拓撲的控制策略可以減小電感的設計值，針對推挽直流變換器三電平拓撲的控制策略可以實現開關管的軟開關、解決變壓器偏磁問題等，針對全橋直流變換器三電平拓撲的控制策略可以減小電感的設計值、實現開關管的軟開關等。
  20. Comparing with usual push - pull converter, the bias - magnetic can be retrained due to the clamping capacitance. but bias - magnetic can not be avoided

    推挽正激變換器相比普通的推挽式變換器，由於箝位電容的存在，偏磁可以被抑制，但並不能完全消除。
分享友人
分享到 Line

分享到臉書