電致發光光源 的英文怎麼說

中文拼音 [diànzhìfāguāngguāngyuán]
電致發光光源 英文
electroluminescent light source
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 致 : Ⅰ動詞1 （給與;向對方表示禮節、情意等） deliver; send; extend 2 （集中於某個方面） devote （one s ...
  • 發 : 名詞（頭發） hair
  • 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
  • 源 : 名詞1. （水流起頭的地方） source （of a river）; fountainhead 2. （來源） source; cause 3. （姓氏） a surname
  • 發光 : 1 （發出光來） give out light; shine; be luminous; brighten; fulgurate; flash; glow; sparkle; gli...
  1. The bandgap is found to broaden with increasing dopant concentration, and it is found that doping with al has the effect of shifting the optical absorption to the shorter wavelength, with both cases being attributed to the burstein - moss shift. we report a study on the fabrication and characterization of ultraviolet photodetectors based on zno : al films. using sol - gel technique, highly c - axis oriented zno films with 5 mol. %

    為了研究zno : al薄膜在紫外光探測方面的性能，我們採用溶膠-凝膠旋塗法在si襯底上生長出具有高度c軸取向的zno : al薄膜，摻al濃度為5mol . % ，並以此作為有源區成功制備出了au / zno : al / au光電導型紫外探測器的原型器件，並對其i - v特性、紫外光響應和光致發光等方面的性能進行了研究。
  2. We have contrasted several methods on fabrication of passive matrix oled, then we mainly discuss two fabricating methods, one is the precise mask method, the other is the barrier wall method. we find that the barrier wall method to fabricate the passive matrix oled ( pmoled ) has the advantages of high resolution, simple process and no crosstalking problem, so the barrier wall method is the good one to fabricate pmoled. in this paper we adopt the both methods, and we have successfully fabricated the pmoled

    分析和對比了實現無源矩陣有機電致發光顯示器件的幾種方法，著重介紹了採用精密掩模技術和障壁技術等技術方案，來製作和設計無源矩陣有機電致發光顯示器件，其中採用障壁技術方案製作的器件具有解析度高、工藝簡單容易實現、器件的交叉效應少、成本低等許多優點，是一種可行的製作無源矩陣有機電致發光顯示器件的方案。
  3. Bringing into play the communication market resources in hangzhou bay, the park devotes itself to the formation of a “ mobile valley ”, which means a unique zhejiang - flavored economic pattern : forming a complete telecommunication industry chain from software and operation development of key parts, such as ic chip, rf modules, base band, display, high capacity battery, to related components like cell phone housing, keypad, antenna, vibration motor, mould, pcb ( circuit board ), photoelectricity device, electronic device, connectors and system and software development, and operation service development

    園區依託杭州灣通信市場資源，致力打造「移動谷」 ，創造中國浙江經濟特有的專業版塊模式：從集成電路晶元、 rf組件、基帶、顯示器、高能電池等核心器件到接手機外殼和按鍵、天線、振動馬達、模具、 pcb （電路板） 、光電器件、電子器件、連接件等相關組件及系統和軟體開發、運營服務開發，形成完整的通信產業鏈。
  4. 3. polycrystalline lif thin films were grown by thermal evaporation on amorphous substrates. properties of broad band photo - luminescence at room temperature of active channel ( f2 and fa + ) produced by electron beam irradiation were studied

    首次用熱蒸發法在玻璃襯底上制備了多晶lif薄膜平面波導，研究了由電子束照射產生的有源（ f _ 2和f _ 3 ~ +色心）溝道的室溫寬帶光致發光特性。
  5. In this thesis, we realize the web - based rtu in telecontrol system for electrical railway systems by using new techniques of computer, communication, and existing the resources of super - speed fiber optic cable that we have already had. besides, we also realize the multi - receiver of the rtu real - time information and the consistency of the information ; the bottleneck problem of the communication and " information solitary island " can also be solved. improving the consistency and real - time performance of information transmission, sending all kinds of information more accurate, safety and faster to the places where the information is required and receiving permitted, realizing larger scope information sharing are all newly and highly anticipated projects in the area of supervise and control

    最大程度的結合新型計算機通信、網路及軟硬體技術，利用目前已經具備的高速光纜通道資源，實現scada系統被控端基於web方式的廣泛聯網，可以解決rtu信息一發多收、一致性，通信瓶頸及『信息孤島』等問題，提高信息傳輸的實時性和一致性，把各種信息更加準確、安全、快速的送到所有需要並被允許的地方，實現更大范圍的信息共享，是目前監控領域的一個嶄新而又備受關注的課題，本文首先綜述了電氣化鐵道scada （電鐵scada ）系統的三大組成部分：調度端、被控端和通信通道的發展概況，闡述了傳統模式的電鐵遠動系統的弊端所在，接著提出了基於web模式的電鐵scada系統硬體結構設計。
  6. Changzhou hongguang electron co., ltd., established in 1998, is committed in the development and production of switched power supply products

    常州市紅光無線電有限公司成立於1998年，一直致力於交換式電源產品的開發及生產。
  7. With the increase of the amount of al, the intensity of the pl peak at 510nm increases. with the aid of ple we can suggest that pl peak at 370nm and 410nm are related to the oxygen vacancies, and 510nm peak originate from a complex co - function of al, si, and o. el devices have been fabricated on three types of silicon based oxide films ( ge - sio2 films, si - sio2 films, and al - sio2 films )

    用不同的方法制備的51一5102薄膜、 ge一510 :薄膜和al一51一5102薄膜，在較低的電壓萬均觀察到了室溫可見電致發光現象，峰位都在510nm左右，其峰位不因薄膜樣品內所含顆粒的種類、薄膜的制備方法、偏壓及后處理的影響，表明電致發光主要來源於電子和空穴在510 、基質中的發光中心的輻射復合發光。
  8. In this paper ， first, the author drew some important conclusions by analyzing several technical factors and experimental conditions which would have great influence on the quality of diamond thin films during mpcvd process ， including gas proportion ， the power of microwave ， the plasma ' s location, the nucleation technique, etc. finally ， the author has successfully deposited nanocrystalline diamond thin films with 300nm crystal particles on the slick surface of silicon by using ch4 / h2 gases in the mpcvd system ， and the nanocrystalline diamond thin films was proved to have good field emission performance. all these researches will make the foundation for the field emission cathode of diamond films

    本論文中，作者分析了mpcvd方法中氣源成分比、微波功率、等離子體球的位置、成核技術等各種工藝條件對金剛石薄膜質量的影響，並總結得到了一些有意義的結論；同時，在自行研製的mpcvd沉積系統上，於4 - 7kpa 、 1000左右的熱力學條件下，採用ch4 / h2氣源氣氛在光滑的硅襯底上制備出了晶粒尺寸在300納米以下的納米晶金剛石薄膜，測試得到了較好的薄膜場致電子發射性能，為金剛石薄膜場致發射冷陰極的研究工作打下了實驗基礎。
  9. This dissertation focuses on the driving circuit of oled ( organic light emitting device ). first we introduce the emitting theory and the structure of oled, and then we introduce the photo electricity characteristic of oled, analyze the driving requirement

    論文首先介紹了有機電致發光顯示器的發光機理和器件結構，接著從它的光電特性出發，分析了其驅動要求，闡述了電流驅動和電壓驅動、交流驅動和直流驅動、無源驅動和有源驅動各自的特點。
  10. The first chapter mainly introduces the history and the principle of oled, and how to get full - color. the second chapter provides some principles, which are necessary for making toled. the third chapter is the most important ; it mainly discusses how to make the transparent cathode of oled used lab _ 6 cathode and oxide cathode

    本文主要是利用lab _ 6來制備有機電致發光器件的透明陰極，本文採用兩種加熱的方法來製作：分別是利用lab _ 6陰極和氧化物陰極作為轟擊電子源來製作lab _ 6透明陰極。
  11. Then we grew the material with different active layer growth temperature, different v / ratio, different doping concentration and form. after that, we tested these materials by photoluminescence ( pl ) technology, and got the best growth condition according to the results of photoluminescence spectra. our result was that the active layer growth temperature was 700, v / ratio was 60, waveguide layer doping was gradual changed ( n - type doping with sih4 from 190sccm to 590sccm, p - type doping with dmzn from 90sccm to 490sccm )

    然後在不同的有源區生長溫度、 /比、摻雜方式及濃度情況下對激光器材料進行外延生長，並利用光熒光（ pl ）技術對不同生長條件下外延材料的光致發光特性進行了測試對比，結果表明在下列條件下生長出來的材料具有更好的光學和電學性能：有源區生長溫度在700 、波導層/比選擇為60 、 n型波導漸變摻雜190sccm - 590sccm的sih _ 4 、 p型波導漸變摻雜90sccm - 490sccm的dmzn 。
  12. We also investigate the principle of invalidation and give the ways to solve such problems. in the end of this paper, we conclude the methods and successful or failed experience of fabrication pmoled. it is very useful to fabricate the pmoled in the future

    最後，本文總結了製作無源矩陣有機電致發光顯示器件的方法，經驗教訓，以及在實際的試驗過程中，需要考慮和涉及的具體問題，為今後繼續從事這一課題的研究指出了一些建議和方法。
分享友人
分享到 Line

分享到臉書