電荷保持 的英文怎麼說

中文拼音 [diànbǎochí]
電荷保持 英文
charge retention
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 荷名詞(蓮) lotus
  • : Ⅰ動詞1 (保衛; 保護) defend; protect 2 (保持) keep; preserve; maintain in good condition 3 (...
  • : 動詞1 (拿著; 握著) hold; grasp 2 (持有; 保持) keep; hold 3 (支持; 保持) support; maintain 4...
  1. A white led driver circuit is presented in this paper. the circuit drives up to four white leds with regulated constant current for uniform intensity. by utilizing proprietary adaptive 1x / 1. 5x modes and ultra - low - dropout current regulators, it maintains the highest possible efficiency over the full 1 - cell li + battery input voltage range

    整體路以恆定流驅動4隻白光led ,利用1倍/ 1 . 5倍分數型泵和低壓差流調節器,在整個鋰池供壓范圍內最高的效率,並使四個白光led獲得均勻的亮度。
  2. Accurate load forecasting is helpful to planning generators " starting and stopping in the interior of the electrical networks economically and reasonably, preserving the security and stability of power system, reducing the unnecessary circumvolving repertory capacity, making planning to overhaul the units in reason, ensuring the normal production and life of the society, effectively reducing the cost of generating electricity, increasing the economical and social benefit

    力負預測是供部門的重要工作之一,準確的負預測,可以經濟合理地安排網內部發機的啟停,網運行的安全穩定性,減少不必要的旋轉儲備容量,合理安排機組檢修計劃,證社會的正常生產和生活,有效地降低發成本,提高經濟效益和社會效益。
  3. Base - load power is the minimum required to keep things ticking over ? the demands of three o ' clock in the morning, or thereabouts

    基本載功率是正常運轉的最小功率? ?凌晨三點所需的能,或者與之相當的能。
  4. A charge conservation statistics enhancement method used in semiconductor divice monte carlo simulation is approached, which smoothes the charge fluctuation caused by the statistics enhancement, and keeps the continuation of cross edge charge flow

    摘要介紹了一種在半導體器件蒙特卡羅模擬中守恆的統計增強方法,該方法消除了由統計增強引入的統計漲落,了不同增強區界面處過界粒子流的連續性。
  5. The sample and hold circuit is employed by the bottom plate sampling technique, which could not only cancel the charge injection error but also eliminate the effect of clock feed - through

    采樣路設計採用了容下極板采樣技術,不僅有效地避免了注入效應引起的采樣信號失真,而且消除了時鐘饋通效應的不良影響。
  6. The ability of power network maintaining its power supply reliability and quality is restricted by power network structure, line and load characteristics, generator drive device characteristics and relay protection mechanism

    力網路維其供可靠性及能質量的能力是受網結構、線路和負特性、發機動力設備特性以及繼護機制等因素影響的。
  7. Moreover, the vehicle does not need to charge the battery pack from the electricity network for keeping its battery soc at a reasonable level

    而且,池也不需要從力網路中充就能使池的狀態在一個理想的范圍。
  8. After a short - term load forecasting method based analogous and linear extrapolation is proposed, the load forecast and the priority of equipment action are led into static reactive power optimization. the aim function is constructed for the practical situation of power system. on the basis of traditional genetic algorithm the fitness function and the holding of population diversity are improved

    在提出基於相似日和線性外推的短期負預測新方法的基礎上,將負預測和設備動作優先級引入靜態無功優化中,並結合網實際情況,構造了實用的目標函數,對遺傳演算法的適應度函數和群體多樣性的進行了改進,採用鄰域搜索運算元增加遺傳演算法的局部尋優能力。
  9. Along with the development of power system, more and more generators and ehv transmission systems are put into operation. there come many new situations, such as the lengthening transmission distance, the heavier load, the increasing transient elements during the transient process. these new conditions influence the correct working of relay protections

    隨著力系統的不斷發展,大容量發機組和超高壓輸系統的相繼投入運行,系統中出現了許多新的情況,如輸距離增大、負加重、故障暫態過程中的暫態分量大大增加、續時間變長等,這些情況對目前常用的各種繼護方法的正確動作會產生許多不利的影響,甚至不能正常運行。
  10. Electrospinning origins from that electrically charged fluid is forced jets in the high voltage electrostatic field. electrospinning occurs when the electrical forces at the surface of a polymer solution or melt overcome the surface tension and cause an electrically charged jet to be ejected. when the jet dries or solidified, an electrically charged fiber remains

    紡絲技術是基於高壓靜場下導流體產生高速噴射的原理發展而來,其基本過程是:聚合物溶液或熔體在幾千至幾萬伏的高壓靜場下克服表面張力而產生帶噴射流,溶液或熔體射流在噴射過程中乾燥、固化,並一定量,最終落在接收裝置上形成纖維氈或其它形狀的纖維結構物。
  11. To maintain a continuous current, we must in some way maintain a force on the mobile charges in a conductor.

    為了在導體內維流,我們必須用某些方法,使導體內的可動電荷保持受到一個力。
  12. Very large scale integration systems, 2004, 12 : 235 - 244. 7 mathew s k et al. sub - 500 - ps 64 - b alus in 0. 18 - mum soi bulk cmos : design and scaling trends

    而且在動態邏輯門中增加了一定范圍的電荷保持器,使系統在最壞情況下仍能正常工作,同時可承受一定的壓和溫度變化。
  13. Based on the change of electrical load, promptly monitor stop and run operation of capacitor to ensure effective watt factor on proper level

    根據分路用的變化,及時檢查容器的投入和退出運行,證有功功率因數維在正常水平。
  14. Charge retention increases with the increase of ptfe concentration after the addition ptfe whether in positive electrodes or in negative electrodes or treated by hydrophobic in the surface of negative electrodes

    無論是在正極還是負極添加ptfe乳液或者負極表面進行憎水處理,隨著ptfe乳液用量或者濃度的升高,率在增大。
  15. Maintaining power delivery as load increases in the morning, keeping it within security limits during daily peaks, and managing load decreases at night are just some of the tasks the control system will perform

    控制系統將負責的一些任務就是在上午負增加的時候維力輸送,在每日高峰時在安全限度內,以及管理晚上負的降低。
  16. The unit coordinated control of coal - fired power plant is essential to the automatic generation control ( agc ). in order to get the fast load response characteristic and the stable main parameters that the power network dispatching center required, we must reconsider the existing unit coordinated control schemes by analyzing the specialty of the coal fired power plant

    燃煤廠的機組協調控制是機組投入自動發控制( agc )的基本條件,為了機組能夠迅速響應網的負要求,同時證機組各主參數相對的穩定,必須在進一步分析機組被控對象的特性的基礎上,重新研究現存機組協調控制方案。
  17. Despite the change of inner pressure during the charge period, the inner pressure will present the same function to the soc after enough displaying time. the inner pressure during charge period and discharge period will rise suddenly with the increasing of temperature

    對ni / mh池脈沖充放表明,雖然內壓會有較大的變化,但只要態相同,並且靜置時間夠長,池的內壓與態的關系就基本不變。
  18. As the total negative surface charge of such complexes matches the surrounding charge density of the matrix, the sds - protein complex stops migrating and remains stationary, as typical of steady - state separation techniques

    當復合物表面總的負與周圍基質的密度一不能致時,與典型的穩態分離技術相似, sds -蛋白復合物則不再遷移而固定。
分享友人