電荷驅動 的英文怎麼說

中文拼音 [diànhéqūdòng]
電荷驅動 英文
charge drive/exchange/sharing/transfer/storage
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 荷 : 荷名詞（蓮） lotus
  • 驅 : 動詞1. （趕） drive （a horse, car, etc. ） 2. （快跑） run quickly 3. （趕走） expel; disperse
  • 驅動 : [機械工程] drive; prime mover
  1. A white led driver circuit is presented in this paper. the circuit drives up to four white leds with regulated constant current for uniform intensity. by utilizing proprietary adaptive 1x / 1. 5x modes and ultra - low - dropout current regulators, it maintains the highest possible efficiency over the full 1 - cell li + battery input voltage range

    整體電路以恆定電流驅動4隻白光led ，利用1倍/ 1 . 5倍分數型電荷泵和低壓差電流調節器，在整個鋰電池供電電壓范圍內保持最高的效率，並使四個白光led獲得均勻的亮度。
  2. Pitch control system consist of three channels which is formed by three drive units. base on need of bench, drive system scheme is designed. single channel three - loop position servo system which is formed by linear motor is simulated. then kinetic behavior of rotor and system ’ s force coupling relation is analyzed. a compensation method for dynamic load which is caused by rotor rotation is presented base on structure - invarient theory

    根據實驗臺的技術要求，設計了整個驅動系統方案。對由直線電機構成的單通道三環位置伺服系統進行了設計和模擬。分析了旋翼運動的動力學特性、系統力耦合關系，並根據結構不變性原理對由旋翼運動產生的動態載荷提出了補償方法。
  3. The subject of this thesis is to study ironless moving coil linear permanent magnet synchronous motor and the major works in this thesis are summarized as follows : 1 ) two analytical formulas are derived by concentrated current method and distributed current method to determine the magnetic field due to pm, based on the current model of pm. besides, two method ( magnetic charge method and solution by laplace equation method ) are also introduced with comparing their advantages and disadvantages. then the effects of the motor parameters on the flux distribution are discussed

    本文對空芯動圈式直線同步電動機進行了深入細致的研究，內容包括： （ 1 ）採用電流模型推導出兩種計算永磁磁極二維氣隙磁場的解析公式（集中電流法、分佈電流法） ，同時介紹了兩種永磁電機氣隙磁場計算方法（磁荷法，直接求解拉氏方程法） ，分析各種方法的優缺點，討論電機參數對氣隙磁密的影響； （ 2 ）介紹了單層同心繞組的布置方式，根據安培定律推導出空芯動圈式直線永磁同步電動機的靜推力計算公式，分析靜態力?位移特性； （ 3 ）建立空芯動圈式直線永磁同步電動機動態模擬模型，模擬不同驅動方式下電動機起動、穩態運行時電磁力、速度、位移的變化情況。
  4. During the circuit design, the author analyzed the basic principle of the direct current motor, pwm control, h - bridge power driver, and two control techniques of h - bridge power drive circuit, designed its general structure, so the feasibility of the design is confirmed. then, reference, oscillator, power dmos gate drive circuit ( charge pump, bootstrap ), and dead time generation circuit are designed and analyzed in the sub - circuits. a current - controlled oscillator is presented in this thesis

    在電路設計中，作者介紹了直流電機的工作原理和數學模型、脈寬調制（ pwm ）控制原理、 h橋電路基本原理和h橋功率驅動電路的兩種控制模式，設計了驅動電路的總體結構，給出了電路的功能模塊，確定了設計的可行性，然後在子電路模塊中，重點分析設計了基準源電路、振蕩器電路、高端功率管柵驅動電路（電荷泵及自舉電路） 、低端功率管柵驅動電路和死區時間產生電路。
  5. According to the requirements of propeller aerocraft model test in wind tunnel, specifications of the driven motor is presented by aerodynamic analysis, and a short - term operated high power density three - phase induction motor is developed with reasonably designing the motor, such as electromagnetism load, heat checkout and high - efficiency heat exchanger

    摘要針對螺旋槳飛機模型帶動力風洞實驗要求，通過氣動性能分析提出驅動電機的技術指標，在滿足結構約束的條件下，通過合理設計電機的電磁負荷、校核發熱、採用高效冷卻裝置等，研製出短時工作制高功率密度三相異步電機。
  6. To cancel the offset - voltage of the comparator, a switch capacitance circuit is used between the three pre - amplifier stages. the charge pump circuit is used to boost the clock voltage of the switch transistor

    採用電荷泵電路提供開關管柵過驅動電壓，帶隙基準電路作為電荷泵穩定電壓的輸入，有利於改善開關電路的性能。
  7. There are mainly two structures of white led driver, based on capacitor - charge pump and based on inductor - switching power supply

    白光led驅動電路主要有兩種結構:基於電容的電荷泵結構和基於電感的開關電源結構。
  8. The electro - hydraulic load simulator of fin stabilizer is physical half - objective simulative system. its function is to simulate, under laboratory conditions, different kinds of hydrodynamic force exerted on the fin stabilizer so as to detect technical performance index of the driving system of fin stabilizer. thus the classical self - destructing all - objective experiment will be converted to half - objective forecasting experiment in laboratory to achieve the aims such as shortening lead time, saving developing funds, enhancing reliability and success proportion

    減搖鰭電液負載模擬臺是一種半實物物理模擬系統，其功能是在實驗室的條件下，模擬船舶航行過程中減搖鰭所受的海浪水動力載荷譜，從而檢測減搖鰭驅動系統的技術性能指標，將經典的自破壞全實物實驗轉化為在實驗室條件下的半實物預測性實驗，以達到縮短研製周期、節約研製經費、提高可靠性和成功率的目的。
  9. For saving driver ics ' power consumption and cost, this research proposes a novel display pixel design with integrated charge pump circuits. the proposed display pixel design can supply driving voltage more than double the input voltage to display pixels. there are two advantages for this developed novel pixel design. first, the power consumption of the panels with the proposed novel pixels can be reduced due to the lower voltage on data lines. second, the high voltage driver ics are not necessary, such that the cost and power consumption of the corresponding driving systems can be diminished. from the simulation results, the pixel voltage indeed could raise to more than double input voltage by this proposed design. in addition, the pixels with charge pump circuits also retrench about half power consumption than the conventional display pixels

    為了節省面板電路驅動晶元的功率損耗以及製作成本，本研究提出一種新的像素電路設計，而在設計中將會融合電荷泵電路.利用這種電路設計的像素可有效地將像素電極上的驅動電壓提高到輸入電壓的2 3倍以上.此像素電路設計具有兩個優勢:第一，可以有效降低顯示面板的像素功率損耗;第二，不需高電壓的面板電路驅動晶元，因此可節省晶元的成本及功率損耗.由模擬結果可知，像素電極上的驅動電壓確實可由此像素電路設計而提高到輸入電壓的2 3倍以上;而像素的功率損耗也可有效地降低，約為傳統像素的1 / 2
  10. Therefore, a four - phase charge pump circuit is invented to surmount this problem, but the current loading capability of this circuit is unfavorable and the driving clocks must have four - phase non - overlapped " signals

    針對這個問題，四相位的電荷泵電路由此產生，但是這個電路的電流負載能力不太好並且它的驅動時鐘信號必須是四相位且不重疊。
  11. The platform is widely applied in precision engineering, ultraprecision machining and et al, which consists of a mechanical elastomer, two piezoelectric actuators, two driving circuits based on charge - feedback, two linear variable differential transformers, and a numerical control device based on c8051f021

    該平臺主要由機械彈性體、壓電作動器、壓電作動器驅動電路及電荷反饋迴路、差動變壓器測微儀和c8051f021單片機控制裝置等構成。
  12. New method for measuring the wall charge of ac plasma display panel under arbitrary driving waveform

    交流等離子體顯示屏任意驅動波形壁電荷測量方法
  13. An auto - adjustable charge pump embodied in a white led driver has been taped - out successfully using a 0. 5 m cmos process. it can provide more than 80ma output current in the wide input voltage range from 2. 7v to 5. 5v

    此電荷泵晶元採用0 . 5 mcmos工藝;輸入電壓范圍為2 . 7 5 . 5v ;可以提供大於80ma的輸出電流，同時驅動四顆白光led ;並且此晶元具有根據輸入電壓自動選擇工作模式的功能。
  14. To avoid the actuator, a capacitor load being charged up by the drift current of the amplifier, a secondary feedback from the output of the amplifier has been used and expected result has been gotten

    針對驅動器輸出電流漂移造成的壓電作動器（容性負載）電荷積累，文中引入了抑制驅動器電流漂移的反饋環節，取得了預期的控制效果。
  15. The disease in jaw surface will be drop the bite force ; the bite force in the patient who disease in temporal jaw joint descent obviously than normal person ; serious mistake in join deformity, the acute damage in the area arthritis can also drop the bite force evidently ; compare to normal children, wenneberg fund that the bite force lower and the duration of the biggest bite force shorter in the children who fall ill of the chronic arthritis ; the bite force also be used in appraise of the recovery condition in surgical operation 、 disorder in jaw arthritis and the serious bone offset in bite lopsided etc. some materials, it will be produce polarization phenomenon inside when suffered some force in certain direction, at the same time, it produce opposite electric charge in two of the surface ; and resume to the station of on - electrification when removed the outside force ; change the direction of the outside force, the polarity of the electric charge also be changed, this kind of phenomenon is called as “ piezoelectric effect ”

    本文設計了石英晶體壓電傳感器，以它作為傳感元件把咬合力信號轉變成電信號;利用ts5860型準靜態電荷放大器把傳感器的電荷信號轉變成電壓信號;選用usb7822數據採集卡，編寫該數據採集卡的驅動程序，採集該電壓信號並送到計算機里;編寫labview程序對該信號進行處理，得出咬合力值和咬合力曲線，並把測量結果以電子表格的形式保存，以便做進一步的分析和研究。通過對該測量儀的靜態標定、動態標定、溫度漂移標定以及實際測量試驗，證實了本測量儀具有較高的靈敏度、受動態力和溫度變化的影響比較小、能實時地顯示咬合力曲線和較準確地顯示咬合力值，滿足了咬合力測量的要求。
  16. This can be reduced by borrowing close loop feedback which cost great and make the system more complex. with charge driver the pizeo acuter works under ideal linear. but charge driver is lack of low frequency stability

    而採用電壓驅動方法控制壓電陶瓷，開環時存在遲滯、蠕變和位移非線性;採用電荷驅動方法，開環控制線性良好，但低頻穩定性差。
  17. The task of this controller is to control the diesel and dc electric machine to be combined together under certain conditions automatically to get good power and exhaust performance

    控制器所要完成的任務是控制hev中柴油機和電機按照一定規律自動分配負荷來驅動hev ，得到較好的動力與排放性能。
  18. They are the sodium ions in the brain that generate the electrical charges powering our thoughts

    它們是腦中能夠產生電荷而驅動思維的鈉離子。
  19. At the same time, charge pump circuits are also used in the low - supply - voltage switched - capacitor systems that require high voltage to drive the analog switches and dc - to - dc converters and so forth

    同時，電荷泵還可以應用在需要高壓來驅動模擬開關低電源電壓的開關電容系統和dc - to - dc轉換器等電路中。
  20. Charge drive exchange sharing transfer storage

    電荷驅動交換共享轉移存儲
分享友人
分享到 Line

分享到臉書