電阻性分量 的英文怎麼說

中文拼音 [diànzǔxìngfēnliáng]
電阻性分量 英文
resistive component
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 電阻 : （物質阻礙電流通過的性質） resistance; electric resistance （電路中兩點間在一定壓力下決定電流強度...
  1. Taking the silicon diode as an example, through an analysis of the diode ' s current - voltage characters and the avometer circuit, the writer finds out the reasons for the differences in the amount when measuring the positive direct current equivalent resistance with different ohm grades

    摘要以硅二極體為例，從二極體的伏安特性及萬用表內部電路的角度，分析了用指針式萬用表的不同歐姆檔位測量二極體的正向直流等效電阻時，其值緣何不同。
  2. The boracic acid was used to prepare flexible graphite and the effect of amount of boracic acid addition on expanded volume, oxidation resistance, specific resistance and tensile strength of the fexible graphite obtained were analysed

    摘要初步探討了製造柔性石墨材料過程中加入添加劑硼酸的方法，並就硼酸的加入量對其膨脹倍數、抗氧化性、電阻率、抗拉強度等的影響進行了比較和分析。
  3. A new measurement system for electrical conductivity in an yj - 3000t press fitted with a wedge - type cubic anvil was set up on the basis of the old one. a solartron 1260 impedance / gain phase analyzer was used in the new system ; mo electrodes and a mo shield were also used to keep oxygen fugacity close to the mo - moo2, which is similar to that of iron - wustite ( iw )

    在yj ?緊裝式六面頂壓機上，對原有的礦物、巖石電性測量系統進行了進一步的改進：建立了一套以solartron1260阻抗增益?相位分析儀為測試儀器，使用mo電極和mo盾來控制樣品氧逸度的測量系統，該系統的氧逸度環境為mo ? moo _ 2 ，接近iw緩沖對。
  4. The control system of furnace " s temperature has been widely used in every walk of life, as an important link of repair and manufacture of the electrical equipment such as electromotor transformer etc., soaking lacquer drying craft has some especial requests on drying crafto this article starts with the analysis of drying chamber " s configuration, analyzed its configuration limitation and control function limitation according to the factory " s situation and advances the conception of heated air drying circulation, in addition, this article adopts an intellectualize a / d module, a development sampling tuning - voltage circuit, and presents the method to measure online the insulation resistance of products in order to improve constantly products quality

    而浸漆乾燥工藝作為電機、變壓器等電氣設備的修理、製造中的重要環節之一，對乾燥過程的質量要求有一定的特殊性。該文從乾燥爐的結構分析入手，聯繫到工廠的實際情況分析了結構功能缺陷和控制功能缺陷，提出了熱風循環乾燥的概念，同時，選擇了較為先進的a d板卡、熱電阻信號調理板等專業化智能卡，運用數字pid控制技術，構成了一個較有特色的計算機控制系統。此外，該文還從保證乾燥品質量的角度，採用智能化交流模塊和自製采樣調壓電路的方法，提出了在線檢測產修品的絕緣電阻的方法和手段，以確保企業產品質量不斷提高。
  5. Connectors for electronic equipment - tests and measurements - part 2 - 1 : electrical continuity and contact resistance tests ; test 2a : contact resistance - millivolt level method

    電子設備連接器.試驗和測量.第2 - 1部分:電連續性和接觸電阻試驗.試驗2a :接觸電阻.毫伏法
  6. Based on the verification regulation of prt, this paper studies the temperature characteristics of prt, suggests a method of improving the accuracy of measurement and supplies the uncertainty of calibration point

    摘要分析了檢定規程對鉑電阻溫度計的要求，通過研究鉑電阻溫度計的測溫特性，提出了提高鉑電阻溫度計測量精度的方法，並給出了在溫度校準點的測量不確定度。
  7. The probe ' s linearity, temperature and dynamic characteristics are analyzed base on principal theory of eddy - current displacement sensor, such as the influence of the coil q value to the linearity characteristic, influence of the diameter of coil to the linearity characteristic, influence of coil resistance to the temperature characteristic, influence of the measuring coil to the syntony loop

    在介紹渦流位移傳感器的基本理論的基礎上，分析了傳感器探頭線性特性、溫度特性、動態特性的影響因素。從探頭線圈q值對線性特性的影響；探頭直徑對線性的影響；探頭線圈電阻對溫度特性的影響；激勵信號溫度特性的影響：檢測線圈?振迴路動態響應特性等方面分析並提出製作高質量傳感器探頭的改進措施。
  8. Measurements of the electrical properties of electronic tubes. part 12 : methods of measuring electrode resistance, transconductance, amplification factor, conversion resistance and conversion transconductance

    電子管電性能的測量.第12部分:電極電阻跨導放大系數變頻電阻和變頻跨導的測量方法
  9. Measurements of the electrical properties of electronic tubes ; measurement of equivalent noise resistance

    電子管電氣性能測量.第8部分:當量噪聲電阻的測量
  10. Harmonized system of quality assessment for electronic components - sectional specification : fixed power resistors - capability approval

    電子元器件質量評定協調體系.固定電源電阻器分規范.性能認可
  11. Connectors for electronic equipment - tests and measurements - part 2 - 3 : electrical continuity and contact resistance tests - test 2c : contact resistance variation

    電子設備連接器.試驗和測量.第2 - 3部分:帶電連續性和接觸電阻試驗.試驗2c :接觸電阻變化量
  12. Superconductivity - part 4 : residual resistance ratio measurement - residual resistance ratio of nb - ti composite superconductors

    超導性.第4部分:剩餘電阻比測量. nb - ti復合超導體的剩餘電阻比
  13. Superconductivity - part 4 : residual resistance ratio measurement ; residual resistance ratio of nb - ti composite superconductors

    超導性.第4部分:剩餘電阻比測量. nb - ti復合超導體的剩餘電阻比
  14. Superconductivity - part 4 : residual resistance ratio measurement ; residual resistance ratio of nb - ti composite superconductors iec 61788 - 4 : 2001 ; german version en 61788 - 4 : 2001

    超導性.第4部分:剩餘電阻比測量:鈮-鈦復合超導體的剩
  15. The variations of the surface state and environment conditions could change the procedure of exfoliation, therefore, the potentiometry and electric resistance methods in this paper are used to measure the exfoliation rate of aluminum alloys in a constant temperature, the experimental results show that relations of natural corrosion potential vs time have a resemblance to those of corrosion rate vs time, both relations are all at the different change rates in the front and back of 120 minutes

    超硬鋁合金表面狀態、環境條件的變化，均可能改變剝蝕的發展過程，為此，本文提出在恆溫條件下，用電位法、電阻法定量研究鋁合金的剝蝕性能。實驗結果顯示了lc4cs鋁合金的自腐蝕電位與時間的關系，和腐蝕速率與時間的關系有著十分相似的規律，兩者均在120分鐘前後有不同的變化。
  16. This article also study the principle with harmony wave analytic approaches monitoring the resistive weight of moa leak current and realize this requisition on hardwares circuit

    本文還研究了用諧波分析法監測moa泄漏電流阻性分量的原理和實現這一方法對硬體電路的要求。
  17. This paper, according to the characteristic and requests of measurement for the medium loss of electric capacitive equipment and the resistive weight of moa leak current in a power substation, according to the on - line monitoring principle and implementing scheme of electric equipment in substation relying mainly on the means through the software analysis, finish the design and the fabrication of monitoring system hardware and software, and then empolder the on - line monitoring equipment fitting for the 220kv substation of dazhuling in chongqing, have finished the installation, debugging and the data analyzing of the running device

    本文針對變電站電容性設備介質損耗和moa泄漏電流阻性分量測量的特點和要求，按照以軟體分析為主的變電站電氣設備絕緣在線監測的原理和實施方案，完成了監測系統硬體、軟體的設計、製作並開發了適合於重慶大竹林220kv變電站電氣設備絕緣的在線監測裝置，完成了裝置的安裝、調試和運行的數據分析。
  18. Measurements of the electrical properties of electronic tubes. part 7 : measurement of equivalent noise resistance

    電子管電性能的測量.第7部分:等效噪聲電阻的測量
  19. Superconductivity - part 7 : electronic characteristic measurements ; surface resistance of superconductors at microwave frequencies

    超導性.第7部分:電特性測量.微波頻率下超導體的表面電阻
  20. Superconductivity - part 7 : electoronic characteristic measurements - surface resistance of superconductors at microwave frequencies

    超導性.第7部分:電特性測量.微波頻率下超導體的表面電阻
分享友人
分享到 Line

分享到臉書