電阻性的 的英文怎麼說

中文拼音 [diànzǔxìngde]
電阻性的 英文
ohmic
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 的 : 4次方是 The fourth power of 2 is direction
  • 電阻 : （物質阻礙電流通過的性質） resistance; electric resistance （電路中兩點間在一定壓力下決定電流強度...
  1. It not only gains the physical contrastive datum mark, but also improves the blm stability. cyclic voltammetry is used to study the characteristic of blm attached to metal surface, as the forming of blm, the voltammetric characteristics of blm, the selection of ion and measurement of different ki concentration

    就以上提出的處理方法，採用循環伏安法詳細研究了金屬表面所覆blm的基本性質，如：膜形成液的配製、膜的形成、膜電阻、膜的伏安特性、膜的擊穿電壓、離子的識別性及對不同濃度的碘化鉀溶液的測試。
  2. Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )

    體積電阻率的測定：當r _ v 10 ~ 8時，製成100 100 4mm板材，用zc36型高阻儀測量；當r _ v 10 ~ 8時，用dt - 9205b型數字式萬用表測試試樣的體積電阻，為了減小接觸電阻對測試的影響，採用銀導電膠將銅片粘接在試樣的兩個端面上，靜置24小時，待銀導電膠凝固，試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。
  3. Method for measurement of non - linearity in resistors

    非線性電阻器的測量方法
  4. This is the theoretical expression for the resistivity, and it is in qualitative agreement with experiment.

    這就是電阻率的理論表達式，它與實驗定性地符合。
  5. Tabular layouts of article characteristics for resistors

    電阻器的產品特性圖表
  6. Standard test methods for electrical conductivity and resistivity of water

    水的電導性和電阻率的標準試驗方法
  7. Standard test method for electrical conductivity and resistivity of a flowing high purity water sample

    高純度流動水樣品電導性和電阻率的標準測試方法
  8. The result reveals that the stress control tube comprising a composite structure of the nonlinear resistive and capacitive material shows the best performance in improving electric field distributions in cable terminations

    分析結果表明，採用由電容性和非線性電阻性材料復合絕緣結構的應力控制管時，電纜終端的電場分佈最為均勻。
  9. The result reveals that the stress control tube comprising a composite structure of the nonlinear resistive and capacitive material shows the best performance in uniforming the electric field distributions in cable terminations under impulse voltage

    分析結果表明，在沖擊電壓下電纜終端採用由電容性和非線性電阻性材料復合絕緣結構的應力控制管時，電場分佈最為均勻。
  10. With the increasing of cu contents, flie resistivity of composite samples nd _ ( 0. 67 ) sr _ ( 0. 33 ) mn _ ( 1 - y ) cu _ ( y ) o _ ( 3 ) ) _ ( 0. 7 ) / ( nife _ ( 2 ) o _ ( 4 ) ) o. 3 changes rapidly and the mr gets better ; 6. as for the composite samples composed of nd _ ( 0. 67 ) sr _ ( 0. 33 ) mn _ ( 0. 8 ) cu _ ( 0. 2 ) o _ ( 3 ) of different sizes, with the increasing of heat treatment temperature, the grain size becomes larger, so the resistivity decreases and the capability of mr gets worse ; 7

    6 .經不同溫度熱處理后的n斷67sr033mn0 . scu0203粉體與nifezo ;復合制得的困衡67sr033mno . scu0203 ） 0袱困ifezo4 ） 03復合樣品，隨著粉體熱處理溫度的升高， nd067sr033mnoscu02o3顆粒粒徑逐漸增大，從而導致復合體系電阻率減小，同時磁電阻性能逐漸變差。
  11. Further more, the distribution of electric field in cable termination is analyzed as cavities reside on the interface of a capacitive and a nonlinear resistive material

    進一步分析電纜終端中電容性和非線性電阻性材料知其分界面處含有氣隙時的電場分佈。
  12. To explain this, we ' re going to avoid the idea of impedance ( which has resistive, capacitive and inductive components, some of which vary in effect by frequency, thus varying the actual loading ) and use pure resistance to describe the concept

    為了便於解釋，我們準備暫時避免使用阻抗這一概念，因為它有電阻性、電容性和電感性成分，而其中一部分會隨著頻率的變化而變化，從而改變了實際的負載。
  13. Magnetron sputtering is common method for preparating metal film resistor. by this method, the target is very important for the performance of the resistor

    在金屬膜電阻器的生產過程中，靶材是非常關鍵的，它制約著金屬膜電阻器的精度、可靠性、電阻溫度系數等性能。
  14. For the common purpose of improving the stability of metal film resistor, this paper includes two parts. the preparation of the target has been studied in the first part, the proportion of the material of the target has been studied and the optimal proportion has been confirmed

    針對提高金屬膜電阻器的穩定性這一共同的目的，本文分為兩個部分，第一部分是金屬膜電阻器高阻靶材的研製；第二部分是金屬膜電阻器專用塗料基體的研究。
  15. The target determines the precision, reliability, stability and tcr of the resistor. on the other hand, the coatings play an important role in improving the heat - resistance and moisture - resistance of the resistor. however, nowadays the study in this field is some deficient in our country

    此外，金屬膜電阻器的耐熱、耐濕、耐腐蝕性能還直接與金屬膜電阻器表面的保護塗料的性能密切相關，而目前國產的塗料在耐高溫、耐高濕方面還達不到國家軍標的要求。
  16. On the base of the development of thick film pastes technology, ru - based thick film resistor pastes have been studied due to select conductive phase and inorganic binder. state - of - the - art techniques such as rolling, screen printing and sintering were used for sample preparation. effects of ingredients, printing parameters and sintering parameters, microstructure on the properties of thick film resistor ( trf ) have been analyzed with xrd, sem, dsc and electrical tests

    本文在跟蹤國內外厚膜漿料技術發展的基礎上，以釕酸鉍/銀系厚膜電阻漿料為研究對象，通過選用合適的功能相和無機粘結相成分，以三輥軋制、絲網印刷和高溫燒結等制備工藝為技術特徵，採用xrd 、 sem 、 dsc等分析方法和電性能測試手段，系統的研究了漿料中各相的成分配比、制備工藝參數，以及膜層微觀結構對厚膜電阻性能的影響規律。
  17. Five different structures are described : standard transformer coupling, parafeed, resistively loaded stage capacitively coupled to the output transformer, tube ( valve ) based constant current source load capacitively coupled to the output transformer, and solid state ( mos fet ) constant current source load capacitively coupled to the output transformer

    我們將討論五種不同的方式：標準變壓器耦合；旁饋耦合；電阻性負載電容性耦合至輸出變壓器；膽恆流源負載電容性耦合至輸出變壓器；以及晶體管恆流源負載電容性耦合至輸出變壓器。
  18. The fluid properties and strata pressure have obviousely changed during the high water cut stage, which exert unfavorable influence on determining formation water resistivity based on spontaneous potential curves. from the analysis of the mechanism for forming

    針對油田高含水期地層流體性質和地層壓力的變化給應用自然電位曲線求取地層水電阻率產生不利影響的實際問題，從自然電位產生的機理出發，研究了應用自然電位曲線求取地層水電阻率的方法。
  19. ( 3 ) a modified chua ' s circuit is proposed and a circuit implementation is also designed. dynamics of this modified chua ' s circuit are numerically studied and its lyapunov exponents are also calculated. ( 4 ) a resistance - coupling method for designing new chaos generators by taking use of existing chaos generators is suggested, several new chaos generators realized by this way are studied and their dynamic are compared to those of original chaos generators, their lyapunov exponents are also calculated

    （ 4 ）提出了一種構造新的混沌或者超混沌模型的電阻性混沌模型耦合方法，並且給出了用此方法構造的幾種新的混沌吸引子，對所構造的新的混沌os吸5吁進行了數值研究，贈了其李雅普諾夫指數，將耦合形成的新的混飩吸引子與耦合之前的混飩吸引子進行了對比頒。
  20. Carrier will be capture by trap, the number of electric carrier will decrease. the trap hold back carrier to move from crystal to other crystal. it influences the electrical properties of tft

    陷阱在浮獲載流子之前是電中性的，但是在俘獲載流子之後就帶電了，在其周圍形成一個多子勢區，阻擋載流子從一個晶粒向另一個晶粒運動，導致載流子遷移率下降，導致tft的電學性能下降。
分享友人
分享到 Line

分享到臉書