需氧腐蝕 的英文怎麼說

中文拼音 [xūyǎngfǔshí]
需氧腐蝕 英文
aerobic corrosion
  • 需 : Ⅰ動詞（需要） need; want; require Ⅱ名詞1. （需用的東西） necessaries; needs 2. （姓氏） a surname
  • 氧 : 名詞[化學] （氣體元素） oxygen （o）
  • 腐 : Ⅰ名詞（豆腐） bean curdⅡ動詞（腐爛; 變壞） decay Ⅲ形容詞（腐爛） rotten; corroded; putrid
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 腐蝕 : 1 （通過化學作用使物體逐漸消損破壞） corrode; corrosion; corroding; deep etch; diabrosis; rot; ea...
  1. Aim of this study was to meet the need for development of tribological parts in pumps. at room temperature tribological properties of different sliding pairs of silicon carbide and alumina - based ceramics were tested using a laboratory tribometer in the ring - on - plate geometry under reciprocating sliding linear contact in different media, such as distilled water, aggressive media and air

    本文針對目前泵用摩擦零部件材料發展的需要，在實驗室摩擦磨損試驗機上研究了按環/塊線接觸方式作往復運動條件下的碳化硅和氧化鋁基陶瓷材料摩擦副在水、化學腐蝕性介質作潤滑劑和無潤滑時室溫下的摩擦磨損特性。
  2. In the third chapter, the influence of current density, solution concentration, erosion time and aging in ambient air on the pl spectra of ps suggests that peak would blue shift with current density increasing, and with erosion time and aging time prolonging ; with the increasing of solution concentration, peaks would red shift when solution concentration less than 1 : 1 but blue shift when solution concentration greater than 1 : 1. above phenomena can be explained by quantum confinement and light center model, but do not deny the action of si - h bonding and defect on the surface in the process of photoluminescence. at present, radiation mechanism is still one of the primary problems in the study of ps

    在第z三章中；通過對比，分析了電流密度、陽極化時間、溶液濃度以及自i然氧化時間對多孔硅光致發光光譜的影響，認為在一定的范圍內，多i孔硅的發光峰位會隨電流密度的增大而藍移，要獲得較強的發光，需z要選擇合適的電流密度；隨著腐蝕時間的延長，多孔硅的發光峰位會i發生藍移；當f酸的濃度較小q ： 1 ）時，峰位隨濃度的增大表現為向i低能移動；而當f酸的濃度較大河山時，峰位隨濃度的增大則表現z為移向高能；多孔硅在空氣中自然氧化；其發光峰位發生藍移，而強i度隨放置時間的延長而降低。
  3. But because of the characteristic of the open absorption refrigeration cycle, problems of continuous abstraction of uncondensable gas automatically and corrosion to pipe columns in the absorber when oxygen is separated from libr - h2o will appear. to solve them, more experiments and design efforts must be done in the future

    但由於開式循環的特點，產生的不凝氣體的連續自動抽除問題、溴化鋰溶液在析出的微量氧氣條件下對吸收器管束的腐蝕問題等，均需要通過實驗和系統完善設計的方法來加以解決。
  4. The work mainly consists of four parts : the first part is to use oxidation and lpcvd technique to produce sio2 mask film and si3n4 insulation film in order to enhance the heating efficiency of micro chamber, and guarantee the carry out of the reaction. the second part is to use the combination of dry etching and wet etching to produce reaction micro chamber, it is the container which carry out the pcr reaction, and dna sample carry out amplification reaction here. the third part is to use the sputtering, photolithography to produce heaters and temperature sensors which heat the reaction micro chamber and provide the temperature condition for the pcr reaction

    首先，利用氧化工藝和lpcvd技術，生長sio _ 2掩膜層和si _ 3n _ 4絕緣層，以提高反應腔的熱效率，保證擴增反應的順利進行；其次，用濕法腐蝕和干法刻蝕相結合的方法加工微型腔體，使之作為dna樣品進行pcr擴增反應的容器；第三，用濺射、光刻等工藝在微型腔體底部製作微型加熱器和溫度傳感器，實現對反應腔體的加熱及其溫度的精確測量，提供pcr擴增反應所需的溫度條件。
分享友人
分享到 Line

分享到臉書