霧化燃燒氣 的英文怎麼說

中文拼音 [wùhuàránshāoqì]
霧化燃燒氣 英文
atomizing burner
  • 霧 : 名詞1. （水蒸氣凝結成的小水點） fog 2. （像霧的許多小水點） fine spray
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 燃燒 : （物質劇烈氧化而發光、發熱; 燒） burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  1. Influences of air liquid mass flow rate on spray combustion produced by effervescent atomizer

    氣液質量流量比對氣泡霧化噴嘴燃燒特性的影響
  2. Ultrasonic has being attracted much attention gradually in fuel atomization because of some specialities of cavitation and infection on liquid flow. in the course of atomization of pitchy oil, especially, does it show greatly its advantage, but its material atomizational mechanism need research ulteriorly. the primary content of this thesis is about adding cantilever reed to effervescent atomizer so as to combine ultrasonic and effervescent. this thesis has discussed ultrasonic some mechanism, ultrasonic dynamical procreator, effervescent and liquid mucosity infection on atomization, at the some time we make some experiments and discuss atomization rule following some machinery parameter and run parameter so as to find some rule about ultrasonic atomization and to rich the research of ultrasonic atomization mechanism. all that will be beneficial to the design about ultrasonic atomization atomizer

    超聲波由於其空化機理及對液體的流變性影響等特性，在燃油霧化燃燒中逐步引起人們的重視，尤其在重渣油等高粘度液體的霧化過程中逐步顯示出其優越性，但其具體的霧化機理還需要做進一步的研究在氣泡霧化噴嘴基礎加入懸臂式簧片哨，將超聲波與氣泡霧化相結合是本文討論的主要內容本文從研究超聲波的一些機理入手，討論了超聲動力發生器氣泡霧化以及液體粘度對霧化質量的影響，並通過具體的實驗，根據實驗數據來討論霧化質量隨各種結構參數運行參數的變化規律，以便找到超聲霧化的一些規律，豐富對超聲霧化機理的研究，對超聲霧化噴嘴的設計具有一定的指導意義。
  3. Air atomizing oil burner

    噴氣霧化油燃燒器
  4. Pulsating spray drying technique makes use of the unstable hot gas stream generated by a pulse combustor to atomi / e and dry a liquid material

    脈動燃燒乾燥技術是近年來出現的一種新型乾燥技術，它利用脈動燃燒器產生的高溫，高頻脈動尾氣流直接霧化和乾燥液態物料。
  5. As to the simulation, three - dimensional n - s equations and two - phase flow model, in which the liquid toluene spray as discrete particles was considered, were employed to describe the turbulent combustion processes in the combustion chamber. the mass and energy transfer between the two phases were calculated by the droplet evaporation model, and the arrehnius model was used to obtain the gas chemical reaction rate. the details of 3d flow field, the distributions of temperature and compounds were obtained by solving the equations

    數值模擬方面，應用三維湍流n - s方程以及顆粒軌道模型描述了激光器燃燒室內部的噴霧兩相燃燒流動過程，兩相之間的質量、能量交換由液滴蒸發模型計算，氣相化學反應速率由arrhnius公式計算，通過耦合求解氣液兩相模型方程，模擬了燃燒室三維流場，得到了燃燒室內的溫度和組分濃度分佈。
  6. Abstract : during the heating of scrap with carbon or hydrocarbon contented substances in some process, it will bring problems like explosion of carbon monoxide, fume and smell from oil volatilization, etc. ， if incomplete combustion occurs. through laboratory experiments, the time related variation of gas contents and post combustion ratio of fume during the heating of oil - bearing scrap are studied. the results show that the restrictive chain of reaction procedure is the thermolysis of oil ; that temperature and ( co ) / ( co2 ) ratio influence transformation ratio and post - combustion ratio under lower temperature ; that 900 is the temperature above which the complete reaction can be ensured at all ( co ) / ( co2 ) ratios

    文摘:在某些廢鋼熔煉過程中，當爐料中含碳及碳氫物質且燃燒不充分時，會帶來煙氣中一氧化碳的燃爆、油污揮發時造成的煙霧、臭味等問題.通過實驗室裝置研究含油廢鋼在加熱過程中煙氣成分隨時間的改變以及二次燃燒率的變化，試驗結果表明，反應過程的限制性環節是油分的熱分解；在較低的溫度下（ co ） / （ co2 ）比例影響轉化率和二次燃燒率；而在任意比例下保證充分反應的溫度為900以上
  7. This paper reports the droplet size and distribution, penetration and diffusionangle of fuel spray before and after impingement by multiple - picture overlapping photography and laser technology, as well as the fuel spray mixing and burning process in a direct injection diesel engine by high speed photography

    本文介紹了用多次噴霧疊加攝影與激光粒子分析技術對燃油噴霧撞擊前後的粒徑、貫穿度以及噴霧錐角等因素變化所進行的觀察和測量以及介紹了利用雙像高速攝影技術對燃油束撞擊霧化形成的混合氣以及燃燒過程特點的研究。
  8. ( 3 ) comparison of the experimental data with the simulation results a pulse combustion spray drying system was constructed and the spray drying of nacl solution was carried out under a high oscillating flow field generated by the pulse combustor

    （ 3 ）進行了脈動燃燒噴霧乾燥試驗和數學模型驗證建立了脈動燃燒噴霧乾燥試驗裝置，並利用質量分數10的nacl溶液進行脈動氣流直接霧化和乾燥的試驗。
  9. Characters including : fuel atomization device replaced by gas sprayer, gas supply controlled by gas flux valve ; separate fuel supply from combustion - supporting air, regulate air supply through changing the electioneering voltage to make the fully burning and improve efficiency and reduce fuel consume ; arts and crafts are simple, the modification of the oil heater ' s configuration is little and the heating power is not below the oil heater ' s level ; because of falling the voltage of electioneering, greatly descend the noise of the sample machine compared with the original

    其特點是：以燃氣噴頭替代原機燃油霧化裝置；以燃氣流量控制閥控制燃氣的供給；燃氣的供給與助燃空氣的供給相分離；通過改變主電機的電壓，調整空氣的供給量，使燃燒更加充分完全，並進一步提高了熱效率，降低了燃料消耗；工藝簡單，對原機型改動較小；樣機的加熱功率不小於原機型水平；此外，由於主電機電壓的降低，使樣機的整機噪聲比原機大大下降。
  10. The experimental results also illustrated that it is importance of the fuelimpinge ment to promote fuel and air mixing and speed up burning process

    混合氣形成及其燃燒過程的高速攝影研究結果表明，燃油束撞擊霧化對加快燃油與空氣的混合併促進其火焰擴展起到重要作用。
  11. This article has a particular research on three kind of gas / liquid coaxial nozzles for their flow performance and atomization performance under cold - flow - simulated experiment with the supply of laser doppler technology, and the measurement of the drop parameter and combustion performance under normal pressure and burning condition

    本文應用激光多普勒技術對三種氣液同軸模型噴嘴的流量特性和霧化特性進行了冷流模擬實驗研究，並在常壓燃燒條件下對其噴霧流的液滴參數和燃燒性能進行了實驗測量。
分享友人
分享到 Line

分享到臉書