霧化裝置 的英文怎麼說

中文拼音 [huàzhuāngzhì]
霧化裝置 英文
atomization plant (device)
  • : 名詞1. (水蒸氣凝結成的小水點) fog 2. (像霧的許多小水點) fine spray
  • : Ⅰ名詞1 (服裝) dress; outfit; attire; clothing 2 (演員的化裝品) stage makeup and costume Ⅱ動詞...
  • : 動詞1. (擱; 放) place; put; lay 2. (設立; 布置) set up; establish; arrange; fix up 3. (購置) buy; purchase
  • 裝置 : 1 (機器設備的配件)installation; device; apparatus; equipment; arrangement; gear; appliance; rig...
  1. First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field

    首先,對液體介質的靜電機理作了初步的探討,理論上分析了液體過程中射流區、波紋區、滴區和滴擴散區;然後對液體荷電方法進行了研究分析,對于高電導率的液體,場致荷電和接觸荷電可以使其,而對于電導率較低的絕緣液體,需用浸潤電極荷電和感應荷電方法使其充分帶電;最後,根據前面的研究分析,設計和組試驗,在同一環境下對煤油、乳劑、酒精三種不同液體介質進行高壓靜電試驗,並對試驗結果進行分析處理,總結出液體靜電與液體表面張力、電導率和粘度的關系及電壓對液體靜電的影響等,得出高壓靜電場中液體的一般規律。
  2. Wet paint - mist filtrating equipment

    濕式漆過濾凈
  3. The dried powder product was formed in the spray dryer by pressure nozzle which atomized liquid into small droplets and heat and mass transferring was performed between droplets and hot medium in the drying chamber

    壓力噴乾燥是利用壓力霧化裝置將原料液分散成細小滴,並與熱介質在乾燥塔內充分進行熱量、質量交換,最終達到乾燥產品的目的。
  4. Coal. sampling of pulverized coal conveyed by gases in direct fired coal systems

    煤.直接燃煤氣體傳送的煤的取樣
  5. Oil burning equipment - specification for dimensions of atomizing oil burner pumps with rotating shaft and external drive

    燃油設備.第7部分:有旋轉軸和外部傳動燃油器泵的尺寸規范
  6. Abstract : during the heating of scrap with carbon or hydrocarbon contented substances in some process, it will bring problems like explosion of carbon monoxide, fume and smell from oil volatilization, etc. , if incomplete combustion occurs. through laboratory experiments, the time related variation of gas contents and post combustion ratio of fume during the heating of oil - bearing scrap are studied. the results show that the restrictive chain of reaction procedure is the thermolysis of oil ; that temperature and ( co ) / ( co2 ) ratio influence transformation ratio and post - combustion ratio under lower temperature ; that 900 is the temperature above which the complete reaction can be ensured at all ( co ) / ( co2 ) ratios

    文摘:在某些廢鋼熔煉過程中,當爐料中含碳及碳氫物質且燃燒不充分時,會帶來煙氣中一氧碳的燃爆、油污揮發時造成的煙、臭味等問題.通過實驗室研究含油廢鋼在加熱過程中煙氣成分隨時間的改變以及二次燃燒率的變,試驗結果表明,反應過程的限制性環節是油分的熱分解;在較低的溫度下( co ) / ( co2 )比例影響轉率和二次燃燒率;而在任意比例下保證充分反應的溫度為900以上
  7. Anaesthetic and respiratory equipment - hook - on fittings for the attachment of vaporizers to an anaesthetic gas delivery device

    麻醉和呼吸設備.麻醉氣體傳輸器附件用鉤接式配件
  8. The cold fog is produced by a special device ( cold fogger ) that breaks up the chemical into microscopic droplets by mechanical means, basically with a high - pressure pump and an extreme fine nozzle

    (冷噴器)製造。基本來說,此用高壓泵和極細的噴嘴,以機械方法把學液體變成微細的滴。
  9. This type of dryer was fitful for liquid drying in concurrent, counter - current or mixed air - flow. the dryer can produce powders, granules, hollow spherical particles and agglomerates products. the spraying capacity and particle size were changed by altering the parts assembled in the nozzle

    壓力噴乾燥器的結構適用易調,可通過改變噴嘴的內部結構得到所需要的噴液量和滴尺寸,目前該型式乾燥機已推廣應用於食品、工、醫藥、建材、環保等行業。
  10. The fog is produced by a device ( thermal fogger ) that uses heat to break up the chemical into very small droplets ( usually in 5 - 30 micron diameter range ) which will disperse in the air

    熱噴是經由一特製(熱噴器) ,利用熱力把學液體為微細滴(直徑通常由5至30微米不等)散播並懸浮於空氣中。
  11. Considering the water spraying can effectively increase the contact area between gas and water and promote the hydrate production rate, a batch reactor with water spraying was built in order to experimentally investigate the forming performance of natural gas hydrate, the system ' s state parameters ' variation and its effect on induced time of initial pressure and water temperature

    摘要考慮到水的可以有效提高氣水接觸面積,有助於提高水合物生產速率,設計和建造了一個半間歇式流強水合物實驗,用於探索和揭示噴天然氣水合物制備過程的基本特性,包括制備水合物的形態特徵,形成過程中參數的變規律,以及系統初始壓力和初始水溫度對形成過程誘導時間的影響。
  12. ( 3 ) comparison of the experimental data with the simulation results a pulse combustion spray drying system was constructed and the spray drying of nacl solution was carried out under a high oscillating flow field generated by the pulse combustor

    ( 3 )進行了脈動燃燒噴乾燥試驗和數學模型驗證建立了脈動燃燒噴乾燥試驗,並利用質量分數10的nacl溶液進行脈動氣流直接和乾燥的試驗。
  13. On one hand efficacy of a drug can amount to ill place to produce remedial effect, still can make main and collateral channels of loop of property of a medicine is passed to internal organs of the body, in order to move yin and yang of solar term blood, fu zhengqu evil, promote the refreshment of airframe function thereby, achieve treat a disease sanitarian purpose

    一方面藥力可達病處發揮治療作用,還可使藥性循環經絡傳至臟腑,以調節氣血陰陽,扶正祛邪,從而促進機體功能的恢復,達到治病保健的目的.中藥蒸汽療法是根據蒸汽藥力導入中藥的原理,利用中「健康豐足桶」的蒸汽發生器,將中藥藥液蒸汽,通過蒸汽導管把蒸汽輸入浴足桶,桶內的出汽球和腳踏凳上散汽網,疏導中藥蒸汽熏蒸雙足和小腿部位。
  14. You should buy ant or cockroach traps instead of fluorocarbon sprays ; they are less polluted and can reduce insect populations effectively. you should also try to minimise your purchases of products such as aerosol sprays that contain ozone depleting substances

    避免使用含碳氟合物的滅蟲噴劑,改用? ?屋等滅蟲蟻,既可有效減少蟲蟻的數目,又可減低污染程度。
  15. The conclusions are drawn as following : 1. regularity of fabrication in aluminum matrix composite ring - shaped performs with large dimensions and effects of parameters were investigated, based on the novel crucible movable spray deposition technology and equipment. the optimal parameters are that the diameter of the delivery tube is 3. 8mm, spray gas pressure is 0. 8mpa, spray height is 200mm, and transferring pressure of sic is 0. 5mpa

    通過系統的實驗研究得到如下結論: 1 .基於新型的移動坩堝自動控制噴射沉積環坯制備技術及,研究了大尺寸鋁基復合材料環坯的制備規律,討論了噴射沉積工藝參數對沉積坯形成過程的影響,得到了最佳工藝參數:導流管直徑d = 3 . 8mm ,氣體壓力p = 0 . 8mpa ,噴射高度h = 200mm , sic顆粒輸送壓力p送= 0 . 5mpa 。
  16. Atomizing oil burners ; pumps with rotating shaft and external drive ; dimensions ; german version en 225 : 1987

    燃燒器.帶旋轉軸和外部驅動的泵.尺寸
  17. We have developed a set of supersonic atomizing equipment with the base theory of the supersonic atomization and the base characteristic of the solder alloy. the paper studies systematic the production technology and process of the solder alloy fine powders in the equipment, and deduces the gas velocity formula used in supersonic atomization in theory

    為此,運用超音速的基本原理和焊錫合金的基本性質,研製出一套超音速霧化裝置,在該上對焊錫合金微粉的制備技術及工藝進行了系統的研究,並從理論上推導出適用於超音速的氣體速度公式。
  18. Characters including : fuel atomization device replaced by gas sprayer, gas supply controlled by gas flux valve ; separate fuel supply from combustion - supporting air, regulate air supply through changing the electioneering voltage to make the fully burning and improve efficiency and reduce fuel consume ; arts and crafts are simple, the modification of the oil heater ' s configuration is little and the heating power is not below the oil heater ' s level ; because of falling the voltage of electioneering, greatly descend the noise of the sample machine compared with the original

    其特點是:以燃氣噴頭替代原機燃油霧化裝置;以燃氣流量控制閥控制燃氣的供給;燃氣的供給與助燃空氣的供給相分離;通過改變主電機的電壓,調整空氣的供給量,使燃燒更加充分完全,並進一步提高了熱效率,降低了燃料消耗;工藝簡單,對原機型改動較小;樣機的加熱功率不小於原機型水平;此外,由於主電機電壓的降低,使樣機的整機噪聲比原機大大下降。
  19. In this dissertation, the author summed up the muti - technique in fluid dynamics, heat and mass transferring, mechanical designing and computational technique and studied the conventional pressure spray dryers with different air disperse structure and outlet equipment, at last put forward the theme i. e. the study on combined spin - flow pressure spray drying technology, the main contents were as follows : ( 1 ) the combined spin - flow pressure nozzle was designed whose novel structure has no report at present, and the structural designing parameters were obtained through analyzing the physical characteristic of materials and distribution of particles

    本文總結了國內外在壓力噴乾燥的研究應用狀況,並分析了現有噴乾燥設計方面的優缺點,運用流體力學、空氣動力學、傳熱傳質學、機械設計和計算機技術等多學科知識,綜合研究了傳統壓力噴乾燥系統的單噴嘴霧化裝置在併流、逆流以及混流乾燥中的應用和噴乾燥塔的不同布風以及出風的設情況等,提出了新型旋流式組合壓力噴乾燥技術並對此進行了研究,其主要內容包括: ( 1 )本文創造性地設計出旋流式組合壓力噴嘴的基本結構,並通過對料液的物特性研究分析以及顆粒度的分佈要求,給出了噴嘴的不同結構設計參數。
  20. Application of a new atomizer for flotation reagent at luling coal preparation plant

    新型藥劑霧化裝置在蘆嶺礦選煤廠的應用
分享友人