露點溫度 的英文怎麼說

中文拼音 [lòudiǎnwēndù]
露點溫度 英文
dew point temperature （dp）
  • 露 : 露動詞[口語] （顯露; 表現） reveal; show
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 露點 : [氣象學] dew point; dew-point temperature
  • 溫度 : [物理學] temperature
  1. The temperature at which the water vapor in a given sample of air becomes saturated is called the dew point.

    使一已知空氣樣品中的水蒸汽達到飽和時的溫度稱為露點。
  2. The base temperature should be 3 above the dew point

    底材溫度須高於露點以上3 。
  3. Such a temperature is called the dew point

    該溫度名為露點。
  4. Frostbite injury or destruction of skin and underlying tissue, most often that of the nose, ears, fingers, or toes, resulting from prolonged exposure to freezing or subfreezing temperatures

    霜害。由於長期暴露在結冰或近冰點溫度下造成皮膚或皮下組織的傷害或損傷，主要在鼻眼手指或腳趾處。
  5. Values of dew - point temperature and relative humidity are calculated automatically from the dry - and wet - bulb temperatures by a microcomputer

    露點溫度和相對濕度則由一部微型電腦從乾、濕球溫度計算出來。
  6. Threshold temperature and effective temperature sum of the pollen beetle haptoncus luteolus

    棉露尾甲發育起點溫度和有效積溫的研究
  7. It tell us : the abrasive capability of fly ash ; the similar calculation of ash erosion ; the calculation of ash erosion in the tube in turn and tube out of turn ; the reason of tube abrasion for gas flue ; the influence of air parameter for fly ash erosion ; the influence of changing temperature ; the influence of the flue gas composition, etc. next, it advances the solving measure ; reduce the flue gas velocity ; reduce the concentration of fly ash ; responsible construction : replace smooth tube with spiral tube ; use the new material of abrasion ; fuel desulfurization ; reduce so3 of flue gas ; raise flue gas temperature, making it up the dew point ; use the abrasion - resistance material to resist abrasion

    討論了飛灰磨損性能、管壁受飛灰沖蝕的近似計算、灰粒對順列管和錯列管的磨損計算、煙氣走廊引起對流管束的磨損機理、空氣動力參數對飛灰沖蝕的影響以及受熱面壁溫變化及煙氣成份對飛灰磨損的影響等問題。接著提出了解決的措施：降低平均煙氣流速；降低飛灰濃度；使用鰭片管、螺旋翅片管代替光管；選擇合適的結構及排列方式，減少煙氣中so3的含量；提高受熱面壁溫使之大於煙氣的露點溫度；採用抗腐蝕材料作受熱面等防腐蝕的措施。
  8. When the temperature get to the environment dew point, there will be dew on the surface, when the temperature is below zero, we even can find ice on the components. this is the external condensation problem. this problem is a great threat to the safety and service life of the pneumatic system. so this article is the research about it, we try to find out the principle of the external condensation and get a effective method to judge when it will happen, this will give great help to the designer

    氣動系統在運行中會出現系統元件表面溫度下降的情況，當元件表面溫度達到環境露點溫度以下時就會發生結露，當溫度降到零度以下時就會發生結冰，這就是氣動系統的外部結露問題。外部結露對氣動系統的安全和使用壽命都有很大的影響，本文就是針對這一問題進行研究，通過對氣動系統外部結露的原理和實驗及模擬的分析，找出判斷一個氣動系統是否會發生外部結露方法，以對氣動系統的設計提供幫助。
  9. The measurement results and uncertainty analysis shows that in the dew point range of - 25 ~ + 25 the uncertainty less than 0. 04

    測試結果和不確定度分析表明，該發生器在25 ~ + 25測量范圍內，露點溫度測量的不確定度不大於0 . 04 。
  10. Standard test method for water vapor content of gaseous fuels by measurement of dew - point temperature

    露點溫度法測定氣體燃料中蒸汽含量的標準試驗方法
  11. Do not apply when the surface temperature is less than 5 or less than 3 above the dew point of the air

    底材溫度不可低於5 ，而且至少應當高於空氣露點溫度3以上。
  12. The surface temperature of the substrate should be at least 10 and 3 above the dew point. temperature and humidity should be measured in the vicinity of the substrate

    底材溫度10以上，比空氣露點溫度高出至少3 ，溫度和相對濕度在底材附近測量。
  13. It is well known that the traditional efhat is the integration of the externally fired boiler and humid air turbine, in which various kinds of fuels can be used and the perfomance be improved. in particular, the temperature of clean humid air discharging to atmosphere is not limited by the dew point, and large amount of latent heat of water vapor in condensing will be released

    常規外燃式濕空氣透平是外燃和hat循環相結合的系統，既能夠發揮外燃可以燃用劣質燃料和hat循環效率高的優勢，又由於常規efhat循環工質為潔凈濕空氣，因而排氣溫度可以降低到露點以下而不存在常規hat循環中煙氣露點溫度的限制問題。
  14. The main results are as follows : 1. co and water vapor column contents retrieved from the solar absorption spectra are well related with the surface co concentration and surface dew point respectively

    主要研究過程和結果如下： （ 1 ）利用太陽吸收光譜反演得出的co柱總量與地面co濃度之間、水汽柱總量與地面露點溫度之間存在著比較好的相關性。
  15. Based on experience, it define relativity humidity value which corresponding echo value larger than 20dbz in the ppi fig. then calculate relevant mesh dot position. in term of model ' s request, it translate relativity humidity value to dew point temperature value

    根據經驗定義出ppi圖上回波強度值大於20dbz的觀測點的相對濕度，計算出該點所對應的格點位置；按照模式需要，將相對濕度轉化為露點溫度，寫成相應格式。
  16. Firstly, a dew - point control system was established, which can keep the dew - point of the supply air at a constant value range form - 10 ~ 45

    首先建立的露點控制系統實驗臺，能夠為實驗提供露點溫度在- 10 ~ - 45范圍內濕度穩定的壓縮空氣。
  17. To calibrate a dew - point hygrometer, a stream of low flow rate air, generated by a standard humidity generator and at the specified dew - point temperature, is passed through both the uut and reference dew - point hygrometers which are then compared

    由標準濕度產生器產生的低流速定值露點溫度的空氣會流經被測試儀器及參考露點濕度計，然後互相對比，從而校正露點濕度計。
  18. I set up the mathematics model of heat transfer of the thermal bridge of the building and utilize numerical method to analysis whether occur condensation problem on the internal surface in the thermal bridge or not. through the analysis and studying of this subject, we can make conclusion as followed : because the internal surface of the bared wall body incline to be lower than the air dew point indoor, which apt to dew, with the reducing of out air temperature and increasing of the air temperature indoor

    另外，通過建立建築熱橋的傳熱數學模型，利用數值求解的方法，分析了外墻熱橋部位內表面是否結露的問題，研究得出裸露墻體內表面極易低於露點溫度而結露，並且隨著室外溫度的降低，室內溫度越高，外墻熱橋部位的內表面越容易結露。
  19. To avoid any condensation on the floor slabs in summer, the air supplied is kept at a dew point of 14oc to keep some reserve for the pick up of moisture in the room and to stay below the surface temperature of the ceiling

    為了避免夏季樓板上的凝露，送進的新風保持在14攝氏度的露點溫度，以保證能夠除去室內濕氣，並使其露點溫度低於天花板的表面溫度。
  20. Secondly, when the supply pressure is constant, experiments were carried out with different supply air dew - point and volume ratio of the system. then record the system whether occurring internal condensation or not as the experiment result

    其次，當供氣壓力一定時，對不同容積比的氣動系統，改變供氣露點溫度，進行大量實驗，觀察系統是否發生內部結露，記錄實驗結果。
分享友人
分享到 Line

分享到臉書