靜壓力測量孔 的英文怎麼說

中文拼音 [jìngyālìcèliángkǒng]
靜壓力測量孔 英文
static pressure orifice
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. Moreover, the resulted prediction model of foam size of the closed cell aluminum foam was verified by comparison to the experimental results from the foaming process at different foaming conditions, and the predicted bubble diameter is in good agreement with the experimental ones, the relative error distributes between - 5. 04 % and 6. 32 %

    當入射空氣的壓強、氣流量，液面高度，出氣孔直徑增大時，氣泡直徑隨之增大；當出氣孔數量，液體粘度增大時，氣泡直徑減小，表面張力對氣泡直徑的影響可以忽略不計；靜態條件下液體表面氣泡直徑的預測值和實驗測量值符合得較好，相對誤差分佈在- 5 . 04 % ~ 6 . 32 %之間。
  2. In this section the author analyses the rules of the pile ultimate tip resistance and the shaft friction resistance distribution and their exertion of cast - in - place socketed piles instrumented with strainometers in soft muddy rock. the second aspect of the paper is the analysis on the current rock pile vertical bearing capacity in the four standards gb50007 - 2002, tb 10002. 5 - 99, jtj024 - 85 and jgj94 - 94, then the design method with correlated formula of socketed piles in xigeda - mudstone is given. at the end of this paper, based on the research of pressure grouting technique in recent years, and combined with in - site test result, this paper puts forward the design and calculation method to grouted pile in xigeda - mudstone and the principle of choosing grouting parameters, which provid es experiences for applying this technique and further studying

    本論文結合省級科研項目「西攀高速公路昔格達組泥巖層中鉆孔樁提高承載力的研究」 ，所做的研究工作主要在以下三個方面：一是根據8根樁身內埋設量測元件試樁的單樁豎向靜載荷試驗資料，分析了各試驗樁特別是常規沖孔灌注嵌巖樁在昔格達泥巖中的軸向力、側摩阻和樁端阻力的分佈和發揮規律；二是在討論現行規范對嵌巖樁承載力的計算公式的基礎上，探討了在昔格達泥巖層中的沖孔灌注嵌巖樁的側摩阻和端阻的計算方法，並推薦了相應的計算公式；最後，在吸取近年來對灌注樁后注漿技術研究成果的基礎上，結合現場試驗研究結果，分析了該項技術在昔格達巖層中的應用效果，提出了相應的參數選取，從而為壓力灌漿技術的工程應用和進一步研究提供經驗，並為今後在該地層中合理選用樁型以及指導施工提供了依據。
  3. Based on the data of vertical and horizontal displacements from a certain construction site in cixi city of zhejiang province, the validity of controlling earth - extrusion effects in saturated soft clay ground caused by statically piling was quantitatively analyzed and compared with different technical measures, including reduction of piling rate and installation of stress - relax holes

    摘要根據在浙江省慈溪市某靜壓法沈樁施工現場所監測的地基土位移數據，定量分析比較了控制施工進度、設置應力釋放和排水深孔等工程技術措施對減輕飽和軟粘土地基沈樁擠土效應的有效性，並初步提出了現場地基土位移及其變化速率的監控標準。
  4. Measured hole mass flows and a constant static pressure mixing analysis, together with the measured losses, allowed the decomposition of the losses into three distinct entropy generation mechanisms : loss generation within the hole, loss generation due to the mixing of the coolant with the mainstream, and change in secondary loss generation in the " blade passage

    論文還進行了葉片冷卻孔質量流的測量與常靜壓氣流混合分析，結合前述氣動力損失和冷卻空氣損耗的測量結果表明，端壁氣膜冷卻的綜合損失明顯地由三個部分組成：葉片冷卻孔內產生的損失；由於冷卻空氣與主流熱空氣的混合產生的損失；二次流的變化產生的損失。
  5. In order to fully develop the theory of squeezed branch piles, in particular, the justification of its superior performance in terms of the bearing capacity and sinking displacement, we have derived the analytical formulas of the axial load and the strain at arbitrary depth ; based on existing static loading test results and research on belled pile, together with the analysis of on - site testing data, we have applied the expand theory on sphere holes to the computation of radial stress of squeezed branch piles under hole expansion ; taking the oil pressure of hole expansion in to account, we have find the a branch force under certain hole pressures, hence we can estimate the maximum bearing capacity of single piles ; we have introduced the experiential formulas for the bearing capacity of squeezed branch piles based on its stress characteristic and pile testing data ; we have also done numerical simulations of squeezed branch piles utilizing finite element method software ansys ; we have matched the simulation res ults with those of on - site basic load experiments, regenerating the distributions of stress fields and strain fields of squeezed branch piles, and from those distributions, we can determine the optimal distances between plates and piles

    為了完善支盤樁的設計理論，探求支盤樁高承載力和低沉降量的內涵，本文推導出了支盤樁任意深度的截面荷載以及位移隨深度變化的理論公式；基於已有的靜載試驗成果及有關擴底樁的研究成果，從對現場測試數據的分析，將球形孔擴張理論引入到支盤樁擴孔時徑向應力的計算，考慮到擴孔時的油壓數據，求得某一孔壓下的支盤力，據此估算單樁極限承載力；同時根據對支盤樁的受力特點和試樁數據的分析，提出了支盤樁承載力計算的經驗公式；用有限元分析的方法，利用大型有限元分析軟體ansys對支盤樁進行數值模擬，並將模擬結果同現場的靜載試驗結果進行對比，再現了支盤樁在荷載作用下土中應力場和位移場的變化，根據應力場和位移場的變化范圍，指出最佳盤間距和樁間距；為支盤樁的設計和施工提供了一個可量化的設計依據。
分享友人
分享到 Line

分享到臉書