靜態剛度 的英文怎麼說

中文拼音 [jìngtàigāngdù]
靜態剛度 英文
static stiffness
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 靜態 : [物理學] static state; quiescent condition; steady state; statics; dead level; akinesis; akynesis...
  1. 5 ) the 3 - d geometry and finite element model of the assembly of the optimized obturator of the breech mechanism is set up in terms of the optimized structural parameters. quasi - static and dynamic finite element analysis of stiffness, strength and obturating performance of the optimized obturator of the breech me chanism is performed

    利用優化后的結構參數建立了優化后炮閂閉氣結構的裝配體三維幾何實體模型和有限元模型，對優化后的炮閂閉氣結構剛強度和閉氣性能進行了準靜態及動態多體接觸彈塑性有限元分析。
  2. With the fea software ansys and shell element which has high - precision, this dissertation optimize the size and thickness of skeleton section and seek steel pipe which still have strength and stiffness surplus under static state working condition : sinkage of 240mm of rear wheel. it ' s fully loaded in the state of static bending and torsion. after that, amelioration is achieved for even strength design

    本課題運用ansys有限元分析軟體，並且使用精度較高的shell殼單元作為建模單元，在靜態條件下，通過對左右後輪下沉240mm的彎扭聯合工況的模擬分析，尋找出骨架中存在強度和剛度富裕的構件，使之達到輕量化改進的目的。
  3. In the base of rigid body kinematics, the equations of attitude computation was developed via the imu sensor ’ s output, and a new method of the integrated attitude determination using gyroscope ’ s dynamic output and accelerometer ’ s static output was presented

    基於剛體運動學，本文給出了由慣性測量單元的輸出所確定的氣浮臺姿態解算方程，並提出了利用陀螺儀的動態輸出與加速度計的靜態輸出進行組合的姿態確定方法。
  4. The research result indicated : for the strip primary mirror discussed in this article, the hexagon light - weighted cell has the best structural rigidity quality, the square cell is a little worse, the triangle cell is the worst ; there is an optimum on primary mirror thickness ; on condition of 1g gravity load combining with 4 centigrade uniform temperature rising, the thinner and higher of the flexible support reed, the better of the primary mirror surface figure. the decision of the structural parameters of the flexible support reed must take static rigidity, dynamic rigidity, static strength and dynamic strength of primary mirror assembly into account

    研究結果表明：對于本文的長圓形主鏡，採用正六邊形輕量化孔，鏡體結構剛性品質最好，正方形次之，正三角形最差；主鏡鏡體厚度存在最佳值；主鏡組件在1g重力、均勻溫升4共同作用的工況下，主鏡柔性支撐簧片厚度越小、高度越高，主鏡綜合面形誤差（ p - v值）越小，但同時主鏡組件的剛體位移增大、固有頻率下降，因此柔性支承結構參數的確定要綜合考慮主鏡的綜合面形誤差和主鏡組件靜態剛度、動態剛度、靜態強度和動態強度等因素。
  5. As a result, it is proved that the static / dynamic stiffness and damping force of the linear rolling guide joint affect greatly the dynamic behavior of nc machine tools

    說明直線滾動導軌結合面的靜、動剛度與阻尼對機床的動態特性具有很大的影響。
  6. 3 ) a 3 - d geometry and finite element model of the assembly of the obturator of the breech mechanism is established. quasi - static and dynamic finite element analysis of stiffness, strength and obturating performance of the obturator of the breech mechanism is carried out, based on elastoplastic theory and multi - body contact algorithm, and the simulation results coincide with experimental results, further, th e effect of friction factor on its obturating performance is investigated

    建立了炮閂閉氣結構的三維裝配體幾何實體模型和有限元模型，對炮閂閉氣結構剛強度和閉氣性能進行了準靜態及動態多體接觸彈塑性有限元分析，分析結果與試驗結果相吻合，進一步研究了摩擦系數對其閉氣性能的影響。
  7. A finite element model for double wishbone suspension with twirl torsion bar of a 5 - axle heavy truck is established and a simulation is conducted, including the analyses on static stiffness and strength characteristics of the suspension

    摘要建立了某五軸載貨汽車雙扭桿雙橫臂懸架有限元模型，對各零部件之間連接關系進行模擬，在此基礎上，對模型靜態剛度和強度特性進行分析。
  8. Applying the limited unit law the article carries out the static analysis to the electrical machinery commutation pumping unit support, calculated its static intensity and rigidity

    摘要應用有限單元法對電機換向抽油機支架進行了靜態分析，計算了其靜強度和剛度。
  9. The effect of initial static load on the instantaneous response makes the amplitude of vibration of horizontal and vertical displacement bigger than that without the effect

    初始靜力效應對結構瞬態響應的影響與剛度、質量、阻尼等因素有關，剛度越小，質量、阻尼越大時，初始靜力荷載效應對結構最大位移影響越小。
  10. The deformation and the change of the performance of the air spring on various conditions were analyzed by application of the finite element method

    運用有限元分析軟體在充分考慮材料非線性、幾何非線性和狀態非線性的條件下，分析了在不同情況下空氣彈簧的變形情況以及靜剛度等性能的變化。
  11. The paper studies the effect of end - plate to initial connection stiffness, ductility failure of beam, strength of panel zone and contact states itself through analysis of different thickness of end - plate in the extended end - plate connection. 3

    對節點中不同厚度端板的靜力分析，深入研究了端板對節點的初始連接剛度、梁的延性破壞、柱腹板承載力以及其本身接觸狀態的影響； 3
  12. In buddhist tantra, or vajrayana, in contrast to the hindu, the female principle of " wisdom ( prajna ) is seen as static, whereas the male, or " means ( upaya ), is active

    佛教的坦陀羅，或者金剛乘，與印度教相反，女性法則的「智慧（般若） 」看起來是靜態的，而男性，或者「手段（方便） 」是積極的。
  13. During the research, a static state strength and stiffness test was made so that a comparison can get between simulation results and test results, further more, after that a dynamic test was hold in ding yuan standard testing ground of anhui province

    在模擬計算的同時，在生產廠家的大力幫助下，進行了骨架車的靜態強度、剛度試驗，之後又在安徽定遠國家標準試驗場進行了整備車的動態強度試驗。
  14. In this paper, the pressure field and static characteristic of bearings are simulated by fluent. the pressure contours of restrictors and shaft are acquired as well as the load capacity and static stiffness curves versus eccentricity ratio

    本文首次應用它對軸承的壓力場和靜態特性進行了模擬分析，得出了氣體流經小孔、多孔柱塞和全多孔質的壓力變化曲線以及軸上壓力沿軸向和圓周方向上的變化趨勢，並給出了軸承的承載能力和靜態剛度曲線。
  15. It analyses static errors and dynamic errors, calculates vehicle plane every parts static and dynamic steel and bend distortion effect. it discusses testing means and testing equipment to oscillation, puts forward disposal means to oscillation data, fetches oscillation model of vehicle plane, does predigestion and coupling to all kinds of oscillations

    分析了車載平臺的靜態誤差和動態誤差，計算車載平臺的各部分靜態、動態的剛度以及彎曲變形的影響。對振動的測試方法和測試設備進行了論述，提出對振動數據進行處理的方法，推導出車載平臺的振動模型，對各種振動進行了相應的簡化和耦合處理。
  16. The modal analysis result shows that the vertical and horizontal frequencies of dps undeployed are high enough and suffice the dynamic stiffness requested for launching. but the large spread length and light weight effect the low frequency of dbs deployed, so considerations should be taken to the effects of other systems of the satellite. the static analysis result shows that the displacements of the dbs are small under the joint affect of vertical and horizontal loads, and stresses are low, so the stiffness and intensity are good enough

    模態分析結果表明伸桿收攏狀態的軸向和橫向頻率都比較高，可滿足發射升空時的動剛度要求；靜力分析結果表明伸桿結構在衛星處于發射段和上升段時，在軸向和橫向過載聯合作用下變形均較小，剛度足夠；其應力水平亦較低，強度儲備較大。
  17. But there are not very effective solution means that satisfy the rigorous requirement of vibration, noise etc. on the experimental base, the paper applys dynamic design theory and makes a creative exploration to engine design method, and makes a dynamic stiff and strength analysis to remedy the insufficiency of static design

    本文針對上述問題在試驗的基礎上，應用動態設計理論對發動機的設計方法進行了創造性的探索。通過對發動機的主要零部件的動態剛、強度的研究和分析以彌補靜態設計的不足。
  18. Guide to general principles for determination of the bending stiffness of paper and board by static methods

    採用靜態法測定紙和紙板彎曲剛度一般原則指南
  19. The vibration resistant performances of the parts that made o f pc are five times higher than that of casting iron, but weight is o ne third of it at the same volume. the thickness of the sfpc parts can be increased if the weight is equal. this would make natural fr equency and the amplitude of vibration reduced and improve the dy namic characteristics of a machine tool

    用此種材料製造的部件，從減振性能來看，超過鑄鐵的5倍，相同體積下重量只有鑄鐵的1 3 ，在不增加其重量的情況下，壁厚可增大，使固有頻率提高，共振振幅減小，靜動剛度提高，改善了機床的動態性能。
  20. On the control to static stiffness of tower in tower crane

    塔式起重機靜態剛度現狀與分析
分享友人
分享到 Line

分享到臉書