非可比元素 的英文怎麼說

中文拼音 [fēiyuán]
非可比元素 英文
noncomparable elements
  • : Ⅰ名詞1 (錯誤) mistake; wrong; errors 2 (指非洲) short for africa 3 (姓氏) a surname Ⅱ動詞1 ...
  • : Ⅰ動詞1 (比較; 較量高下、 長短、距離、好壞等) compare; compete; contrast; match; emulate 2 (比...
  • : Ⅰ形容詞1 (本色; 白色) white 2 (顏色單純) plain; simple; quiet 3 (本來的; 原有的) native Ⅱ名...
  1. It is difficult to conform the derivations of the native heavy minerals, so the author assumes corresponding procedures as follows to accomplish the research task : firstly, according to the composition typomorphic peculiarities of minerals deriving from mantle, the author selected a part of minerals as preliminary reseach objects from the native heavy minerals and then further investigate the mantle ones and their host rocks in two ways : one is the method of comparation with the corresponding minerals of rocks deriving mantle in the research field and other places ; anorther is the method of multivariate statistical analysis

    本次工作為了盡能地排除幔源礦物的干擾,根據陳光遠( 1990 ) 、潘兆櫓( 1994 )等學者有關礦物成分標型的論斷,篩選出地幔特徵含量較高的重砂礦物做為初步研究對象,為達到研究目的採取了如下方法:與區內已發現的幔源巖石(如鉀鎂煌斑巖等) 、國內外有代表性的堿性玄武巖、金伯利巖、鉀鎂煌斑巖的深源包體中的相應礦物進行對研究的方法;多統計分類的方法。
  2. In order to overcome problems arisen from the application of x fluorescence analysis into complex spectrum produced by archaeological ceramic fragments with multi - element, low content and thick ground, we have employed the artificial neural network into the research of x fluorescence archaeology and conducted three kinds of research works. as the first one, we have applied the linear olam network ( optimal linear association memory network ) and the non - linear bp network ( back - propagation network ) respectively to analyze the complex x fluorescence spectrum of archaeological samples, and taken both results of spectrum analysis to compare with each other. the second, the method of pattern recognition of bp network was tentatively used to perform intelligent identification of production places of these archaeological samples

    針對科技考古中對大量考古陶片進行產地研究時x熒光分析對多、低含量、厚基底考古陶片產生的復雜譜分析的問題,將人工神經網路引入x熒光考古中,進行了三方面的研究工作:一是用線性olam網路(最優線性聯想網路)和線性bp網路(誤差反傳導網路)分別對考古樣品的x熒光復雜譜進行解譜,並較二者的解譜效果;二是用bp網路模式識別方法對考古樣品的產地進行智能識別;三是為了提高網路運算的靠性和減小基體效應及電噪聲的干擾和影響,研究並提出了三種網路學習前的譜數據預處理方法。
  3. It uses factor analysis method and dualistic relative comparative method to account the ability place of a loan enterprise in its industry, which can confirm the station in its industry better. by using time series model to forecast an enterprise ' s cash flow in the future, we can measure the repayment ability of an enterprise. by using logit model to account the probability of default for a loan enterprise, we can estimate the possibility of its default

    運用因子分析法和二相對較法計算貸款企業在本行業中的財務能力排名,更好地確定其在本行業中的地位;運用時間序列模型預測企業未來的現金流量,從而測度貸款企業未來的還款能力;運用logit模型計算貸款企業的違約概率,估計其違約的能性;從貸款企業的行業風險、經營風險、管理風險、借款人還款意願等方面對貸款企業的財務因進行分析。
  4. In this paper calculation methods of various characteristics curves considering magnetic field nonlinear effect of synchronous generators is systematically studied. the comparison between the results and those without consideration of nonlinear effect is given. the magnetic field nonlinear effect on the operating characteristics is analyzed and the possible factors causing the nonlinear phenomenon is presented

    本論文系統地研究了同步發電機在考慮磁場線性的影響下各種特性曲線的計算方法,並與不計磁場線性時的結果進行較,分析了磁場線性對同步發電機運行特性的影響以及能引起磁場線性的因,並研究在考慮三變量作用下採用插值法估算同步發電機的勵磁電流和功角。
  5. On the premise of summarizing former contributions in the field, and considering the universality of the cylindrical space with circular cross - section in industry, the author develop a novel ofpt structure, on which the design theories, numerical simulation, design of experimental system for plane structure, preliminary experiment and design of applied space structure are presented. the main contents of the thesis are that : put forward the novel ofpt pixel distribution and plane - light - path design theories and their empirical formulae. the numbers of the ofs units and their emitting rays can be decided by the requirements of image - reconstructed resolution and the size of the center unmeasured region

    本論文在總結前人工作的前提下,充分兼顧了工業中具有圓形截面的圓柱形容器或管道普遍存在的事實,提出了一種新型的光纖過程層析成像結構,並從理論設計方法,具體結構模擬,平面結構實驗系統設計,初步實驗以及空間結構實用化設計、理論分析等方面進行了研究,主要的創新點在於:提出了一種用於工業過程監測與控制的新型光纖過程層析成像結構設計方法,並推導了該方法的經驗公式,該方法主要包括像分配和平面光路結構設計,以根據工程應用中圖像重建的解析度和圓形截面測量區域所佔例的要求,設計所需傳感單的數目和傳感單發射光線的數目;設計了一種新型的光纖過程層析成像結構,並對該結構進行了行性分析和數值模擬。
分享友人