非彈性屈曲 的英文怎麼說

中文拼音 [fēidànxìngqūqū]
非彈性屈曲 英文
inelastic buckling
  • 非 : Ⅰ名詞1 （錯誤） mistake; wrong; errors 2 （指非洲） short for africa 3 （姓氏） a surname Ⅱ動詞1 ...
  • 彈 : 彈名詞1. （彈子; 小球形的東西） ball; pellet 2. （內裝爆炸物, 具有破壞和殺傷能力的東西） bullet; bomb
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 曲 : 曲名詞1 （一種韻文形式） qu a type of verse for singing which emerged in the southern song and ji...
  1. First, the dynamic stability of braid composite cylindrical shells with the influences of some main factors is introduced. the general governing equations for the nonlinear dynamic stability is obtained. by the hamilton principle. the creep buckling analysis of braid composite cylindrical shells under axial compression and the dynamic stability under nonconservation force are discussed as emphases. in creep buckling question, by means of theoretical analysis, the instaneous critical load and durable critical load of viscoelastic braid composite cylindrical shell under axial compression are obtained and the numerical example is given

    首先介紹了編織復合材料圓柱殼在幾種主要因素影響下的動力穩定性問題，用hamilton原理建立非線性動力穩定性問題的一般性基本方程。然後重點討論了編織復合材料圓柱殼軸壓下的蠕變屈曲問題及非保守力作用下的屈曲問題。對蠕變屈曲問題，通過理論分析來得到了編織復合材料圓柱殼的瞬時彈性臨界載荷和持久臨界載荷，給出了具體的算例。
  2. Inelastic yield load of concrete filled steel tubular middle long columns under axial compression

    鋼管混凝土軸壓中長柱的非彈性屈曲荷載
  3. ( 3 ) by using an elastic - plastic material model, the nonlinear analysis is taken on the rectangular tube and simply supporte d plate, and the ultimate carrying load capacity pu is obtained. the results show that the buckling mode is in accordance with the assumption of elastic analysis, and so shows the ultimate mode

    （ 3 ）採用彈塑性模型，考慮幾何非線性理論，利用ansys軟體對矩形鋼管考慮板組相關屈曲影響和不考慮相關屈曲影響（將矩形管板件按四邊簡支板對待）兩種情況進行了屈曲後分析，分別得出其極限承載力p _ u ，並分析了矩形管的屈曲過程。
  4. The nonlinear thermal vibration bifurcation ofbucking viscoelastic rectangular plate

    屈曲黏彈性矩形板的非線性振動分岔
  5. In the buckling question under nonconservation force, a simply example ( the dynamic stability question under the uniformly follower forces with small deformation % linear elastic, straight normal. ) is considered. the variational equation of braid composite cylindrical shells subjectd to uniformly follower forces is deduced based on the variation principle of quasinatural frequency of elastic nonconservative system self - excited vibration. the calculated formulas of the flutter load and quasinatural frequency of shells are obtained. the program for calculating the flutter load is developed. the numerical example is given and some useful conclusions are obtained

    對非保守力作用下的屈曲問題，具體研究了圓柱殼在比較簡單的情況，即小變形、線彈性、直法線假設下在隨動力作用下的殼屈曲問題，由擬固有頻率變分原理推出了圓柱殼受隨從力作用的變分方程，得到了顫振載荷與殼彎曲的固有頻率的計算公式，編制了相應的計算機程序，並給出了具體算例，得到了一些有益的結論。
  6. When there is original stage support only, the load ratio of surrounding rock gets more and more bigger with the increasing of crust stress, correspondingly, the load ratio of initial stage support gets smaller. when the initial stage support and the second support act each other, the load ratio of surrounding rock is more than fifty percent, and it has little change with the increasing of crust stress. the whole analysis of the surrounding rock and support shows that the bottom arch of liner and the feet of liner have serious stress concentration, so do the sidewalls and the foot of a wall of the surrounding rock

    通過屈曲理論分析結果對比表明，彈性屈曲和突變失穩分析的結果比非線性屈曲分析的結果要大得多，非線性分析由於考慮了材料非線性和幾何非線性，因而結果與實際接近實際；當只有初期支護時，隨著地應力的增加，圍巖的荷載分擔率增大，相應地，初期支護的荷載分擔率就減小了；當有初期支護和二次襯砌共同作用時，圍巖的荷載分擔率在50以上，這一分擔率隨地應力的增加其變化不大；支護和巖體的整體分析表明，襯砌底拱及拱腳處應力集中嚴重，隧道巖體側墻及墻角圍巖的應力集中也較大。
  7. ( 4 ) introducing how to evaluate load capacity pn of wall stud considering post buckling strength of plate element. local buckling effects are determined according to the effective width method used in specifications gb50018 _ 2002 and aisi96

    （ 4 ）參照gb50018 、 aisi96二本現行規范，採用有效寬度法考慮局部屈曲后強度並對非彈性屈曲應力進行修正，給出了考慮局部屈曲影響和進行非彈性修正後立柱的穩定承載能力p _ n 。
  8. The proposed beam model satisfied the rigid - body test requirement. by using general displacement control method ( gsp method ) to determine the incremental load parameter and using incremental tangent method to deal with material non - linearity, the proposed beam model were proved to be able to track the entire procedure of deformation, numerically effective during buckling or snap - through of structure

    一系列的典型算例分析表明，本文提出的彈塑性大位移梁單元，能夠準確的跟蹤結構變形的整個過程，包括極值點失穩和跳躍屈曲的情況，可以運用於框架結構的屈曲后性能研究和非線性極限承載力的分析計算。
  9. Thermal post - buckling of an elastic beam with both ends immovably and simply supported and subjected to a transversely non - uniform temperature rising

    兩端不可移簡支彈性梁在橫向非均勻升溫下的熱屈曲分析
  10. Thermal post - buckling of asymmetrically supported elastic rods

    非對稱支承彈性桿的熱過屈曲
  11. Thne results show that not only the nonlinear elastic critical pressure is much less than linear one, but also the inner pressure can significantly enhance the critical buckling axial load, so it provides a elastically theoretical basis for internal high - pressure forming technology

    計算結果表明不僅非線性彈性臨界載荷遠低於線性彈性臨界載荷，而且更重要的是內壓很大程度上有助於提高柱殼軸向彈性臨界屈曲載荷，這樣為內高壓成形工藝提供了彈性失穩理論依據。
  12. For metals that experience the gradual elastic - plastic transition, the point of yielding is determined as the initial departure from linearity of the stress - strain curve and this is sometimes called the proportional limit

    對于金屬逐步的彈塑性形變轉變，其屈服點確定為應力應變曲線非線性關系的開始，這個點也被稱為比例極限。
分享友人
分享到 Line

分享到臉書