面電荷 的英文怎麼說

中文拼音 [miàndiànhé]
面電荷 英文
surface charge
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 荷 : 荷名詞（蓮） lotus
  1. Affiliated with piezoelectric effect of quartz, inner nonlinear electric polarization is calculated, equivalent body bound charges and sueface bound charges under torque are approached

    聯系石英晶體的壓電效應，計算出內部的電極化場，並利用電場等效原理求解出等效電極化體電荷與面電荷分佈。
  2. 4 the cleanout and the passivation of si surface was carried out by a two - step process to overcome the surface oxide layer and balance the charge between the substrate and epitaxy. by this way, the crystal quality and emission characteristic of zno thin films can be improved, which provide a way to resolve the native oxide layer of si substrate

    4 、通過用等離子體對硅襯底表面進行清洗和鈍化兩步處理，解決硅襯底表面的氧化層和界面電荷平衡問題，制備出了高質量的氧化鋅薄膜材料，找到了一條獲得了高質量的氧化鋅薄膜的新途徑。
  3. The results showed that the fluorescent intensity of dph decreased and the fluorescent intensity of mc540 increased under sound stimulation, which indicated that the vesicles got looser, the charge density of membrane surface and the plasmalemma hydrophobicity decreased but the membrane fluidity increased

    結果表明，聲波刺激使標記質膜的dph熒光偏振值降低、 mc540熒光強度增加。表明一定強度和頻率的聲波刺激使質膜變的疏鬆，膜表面電荷密度降低，疏水性降低，流動性增加。
  4. These surface charges partially nullify the effect of the charges on the metal plates.

    這些表面電荷部分地抵消金屬極板上電荷的作用。
  5. This dissipation process limits the maximum surface change density on a planar surface to 30μc/.

    這種耗散作用限制著物體平面的最大表面電荷密度為30c。
  6. During the high - voltage device design, the thick epitaxial layer ldmos which is compatible with current technology was researched. this device used piecewise vld and multiple region structure f reduce field layer. the using of the f reduce field layer effectively reduce the surface electric field of the device, shorten the length of its drift region, enlarge the choice of range of the ion implant dose of the p layer, and effectively restrain the disadvantageously affection on the breakdown voltage of the interface charge qss

    在高壓器件研究中對與現有工藝相兼容厚外延ldmos進行研究，該結構採用分段變摻雜多區p ~ -降場層，有效降低器件的表面電場，縮短器件的漂移區長度，增大p ~ -降場層注入劑量的選擇范圍，並有效地抑制界面電荷qss對器件耐壓的不利影響。
  7. Interface charge has a profound influence on the breakdown voltage of flr structure. on severe condition it can make the outer flr far from main junction disfunction

    界面電荷對場限環終端結構的擊穿電壓影響很大，嚴重的甚至可以使遠離主結的場限環失去作用。
  8. Charge qs was located near the interface of silicon and oxide. with more charge, the field of buried oxide was improved up to the critical breakdown field basis on entirely continuity of electric displacement vector, and then the vertical breakdown voltage was raised. the comparisons between analytical and simulative results proved its availability of this model to interpret the vertical blocking mechanism

    該模型認為，將界面電荷qs引入i層si / sio2的si界面，根據電位移矢量的全連續性，界面電荷qs越多，使i層內電場增加，直至sio2的臨界電場，從而提高縱向擊穿電壓vb . v ，很好得解決了器件的縱向耐壓問題。
  9. This paper comparatively analyzes three more practical measurement methods of surface charge distribution on dielectric in vacuum environment : surface potential measurement method, electrostatic capacitive probe measurement method, pockels effect reflecting measurement method, expounds some newly researched productions, and at last puts forward some new problems to be solved in this field

    摘要對比分析了真空中介質表面電荷分佈測量中三類較實用的方法：表面電位法、靜電容探頭法、普克爾斯效應反射法，闡述了真空中介質表面電荷測量方法的研究新成果，最後提出了這一領域留待解決的新問題。
  10. Abstract : three theory problems about technology of leather making are discussed. the first is the difference between surface charge and isoelectric point ( pi ). the second is about the origin of the calculation formula of basicity in making cr3 + liquor. the third is the swelling mechanism of a skin or hide in basic medium

    文摘:本文討論了皮革製造中的三個理論問題，一是表面電荷與電點（ pi ）之間差別，二是三價鉻鞣液配製中公式的簡單來源，三是生皮在堿液中膨脹的機理。
  11. Considering the geometrical figure of tube and tip, we calculated the surface charge density relative distribution curve of metallic carbon nanotube

    摘要考慮碳納米管尺寸及端帽形狀，計算得到了比較精確的金屬型納米管表面電荷密度相對分佈曲線。
  12. The knowledge of surface charge is therefore of paramount importance to take influence on the solid surface behavior

    所以關于固體表面電荷的知識對于固體表面行為具有極為重要的影響。
  13. The operating principle of the compressed electret micromotor is the variable capacitance. the attenuation time constant of the charges on rotor surface is much longer than the shaping time of electret itself while the rotor is made of electret

    扁平駐極體微電機的工作原理是電容可變原理，電機轉子採用駐極體材料製成，轉子表面電荷的衰減時間常數要比駐極體本身形成的周期長得多。
  14. The main contributions to the study on the flashover of insulators in vacuum are as follows : 1. a set of test system for the studies on flashover of insulators in vacuum has been developed, which consists of vacuum system, electrode system, e - dot pulse voltage measurement system, surface charge measurement system, current monitor system and luminescence signal measurement system

    本文主要完成了以下工作： 1 .通過設計加工真空及試驗電極系統，研製e - dot沖擊電壓測量系統、真空中表面電荷測量系統、沖擊電流和表面微弱光信號測量系統，建成了國內第一套用於研究真空中絕緣子沿面閃絡現象的試驗平臺。
  15. In two - dimensional electrokinetic focusing, a theoretical model based on kirchhoff s current law was derived and applied to predict the width of the electrokinetically focused stream

    在三維定常流場混合問題方面，我們以數值模擬方式探討電滲流在具異質性表面電荷分佈之三維微管道中之混合，共有三種不同型態之混合管道被探討。
  16. Density of surface charge

    面電荷密度
  17. First, the preparation process of ommt is optimized via the modification of sodium silicate

    首先採用硅酸鈉修飾mmt邊面電荷性，優化了ommt的制備工藝條件。
  18. On the problem of charge distribution on a conductor and the calculation of geometric factor of an emitting cathode

    帶電導體面電荷分佈問題與發射陰極的幾何因子的計算
  19. Carrier aggregation on the interface between organic layer and electrodes may screen extra electric field and reduce barrier height for carrier injection. ( 3 ) we utilized oxd as buffer layer in anode and lif in cathode in single layer mehppv pleds. and the efficiency and brightness was doubled. the results implied that aggregation of minority carriers at the interface may the role of blocking layer

    （ 3 ）在單層mehppv器件的陽極引入oxd作為電子阻擋修飾層， lif作為陰極修飾層，利用阻擋少數載流子實現界面電荷積累的方法提高了器件發光亮度和效率，分析了器件電流電壓特性，使器件發光效率和亮度提高了一倍以上。
  20. Abstract : in the paper a kind of new idea based on electric field theory is advanced, which is used in research of forming law of electrochmeical perforation with fixed cathode. according to it, the changing law of electric intensity, current density, velocity of perforation in ecm on the machined surface are presented

    文摘:根據電場理論，提出了一種研究固定陰極電化學射孔成形規律的新的處理方法，分析了該加工方式下陰極表面電荷密度及加工區的電場強度、電流密度、加工速度等在加工過程中的變化規律，為這種簡易加工方式的合理應用提供了嚴密的理論依據。
分享友人
分享到 Line

分享到臉書